اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدElectronic structure of self-assembled InAs/InP quantum dots: A Comparison with self-assembled InAs/GaAs quantum dots
292
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We investigate the electronic structure of the InAs/InP quantum dots using an atomistic pseudopotential method and compare them to those of the InAs/GaAs QDs. We show that even though the InAs/InP and InAs/GaAs dots have the same dot material, their electronic structure differ significantly in certain aspects, especially for holes: (i) The hole levels have a much larger energy spacing in the InAs/InP dots than in the InAs/GaAs dots of corresponding size. (ii) Furthermore, in contrast with the InAs/GaAs dots, where the sizeable hole $p$, $d$ intra-shell level splitting smashes the energy level shell structure, the InAs/InP QDs have a well defined energy level shell structure with small $p$, $d$ level splitting, for holes. (iii) The fundamental exciton energies of the InAs/InP dots are calculated to be around 0.8 eV ($sim$ 1.55 $mu$m), about 200 meV lower than those of typical InAs/GaAs QDs, mainly due to the smaller lattice mismatch in the InAs/InP dots. (iii) The widths of the exciton $P$ shell and $D$ shell are much narrower in the InAs/InP dots than in the InAs/GaAs dots. (iv) The InAs/GaAs and InAs/InP dots have a reversed light polarization anisotropy along the [100] and [1$bar{1}$0] directions.
قيم البحث
اقرأ أيضاً
The spin polarization of electrons trapped in InAs self-assembled quantum dot ensembles is investigated. A statistical approach for the population of the spin levels allows one to infer the spin polarization from the measure values of the addition en
ergies. From the magneto-capacitance spectroscopy data, the authors found a fully polarized ensemble of electronic spins above 10 T when $mathbf{B}parallel[001]$ and at 2.8 K. Finally, by including the g-tensor anisotropy the angular dependence of spin polarization with the magnetic field $mathbf{B}$ orientation and strength could be determined.
We present a comprehensive study of the optical properties of InAs/InP self-assembled quantum dots (QDs) using an empirical pseudopotential method and configuration interaction treatment of the many-particle effects. The results are compared to those
of InAs/GaAs QDs. The main results are: (i) The alignment of emission lines of neutral exciton, charged exciton and biexciton in InAs/InP QDs is quite different from that in InAs/GaAs QDs. (ii) The hidden correlation in InAs/InP QDs is 0.7 - 0.9 meV, smaller than that in InAs/GaAs QDs. (iii) The radiative lifetimes of neutral exciton, charged exciton and biexciton in InAs/InP QDs are about twice longer than those in InAs/GaAs QDs. (v) The phase diagrams of few electrons and holes in InAs/InP QDs differ greatly from those in InAs/GaAs QDs. The filling orders of electrons and holes are shown to obey the Hunds rule and Aufbau principle, and therefore the photoluminescence spectra of highly charged excitons are very different from those of InAs/GaAs QDs.
We investigate the thermal quenching of the multimodal photoluminescence from InAs/InP (001) self-assembled quantum dots. The temperature evolution of the photoluminescence spectra of two samples is followed from 10 K to 300 K. We develop a coupled r
ate-equation model that includes the effect of carrier thermal escape from a quantum dot to the wetting layer and to the InP matrix, followed by transport, recapture or non-radiative recombination. Our model reproduces the temperature dependence of the emission of each family of quantum dots with a single set of parameters. We find that the main escape mechanism of the carriers confined in the quantum dots is through thermal emission to the wetting layer. The activation energy for this process is found to be close to one-half the energy difference between that of a given family of quantum dots and that of the wetting layer as measured by photoluminescence excitation experiments. This indicates that electron and holes exit the InAs quantum dots as correlated pairs.
We use a many-body, atomistic empirical pseudopotential approach to predict the multi-exciton emission spectrum of a lens shaped InAs/GaAs self-assembled quantum dot. We discuss the effects of (i) The direct Coulomb energies, including the difference
s of electron and hole wavefunctions, (ii) the exchange Coulomb energies and (iii) correlation energies given by a configuration interaction calculation. Emission from the groundstate of the $N$ exciton system to the $N-1$ exciton system involving $e_0to h_0$ and $e_1to h_1$ recombinations are discussed. A comparison with a simpler single-band, effective mass approach is presented.
Built-in electrostatic fields in Zincblende quantum dots originate mainly from - (1) the fundamental crystal atomicity and the interfaces between two dissimilar materials, (2) the strain relaxation, and (3) the piezoelectric polarization. In this pap
er, using the atomistic NEMO 3-D simulator, we study the origin and nature of the internal fields in InAs/GaAs quantum dots with three different geometries, namely, box, dome, and pyramid. We then calculate and delineate the impact of the internal fields in the one-particle electronic states in terms of shift in the conduction band energy states, anisotropy and non-degeneracy in the P level, and formation of mixed excited bound states. Models and approaches used in this study are as follow: (1) Valence force field (VFF) with strain-dependent Keating potentials for atomistic strain relaxation; (2) 20-band nearest-neighbor sp3d5s* tight-binding model for the calculation of single-particle energy states; and (3) For piezoelectricity, for the first time within the framework of sp3d5s* tight-binding theory, four different recently-proposed polarization models (linear and non-linear) have been considered in conjunction with an atomistic 3-D Poisson solver that also takes into account the image charge effects. Specifically, in contrast to recent studies on similar quantum dots, our calculations yield a non-vanishing net piezoelectric contribution to the built-in electrostatic field. Demonstrated also is the importance of full three-dimensional (3-D) atomistic material representation and the need for using realistically-extended substrate and cap layers (systems containing ~2 million atoms) in the numerical modeling of these reduced-dimensional quantum dots.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
