اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدFractional Power Control for Decentralized Wireless Networks
162
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We consider a new approach to power control in decentralized wireless networks, termed fractional power control (FPC). Transmission power is chosen as the current channel quality raised to an exponent -s, where s is a constant between 0 and 1. The choices s = 1 and s = 0 correspond to the familiar cases of channel inversion and constant power transmission, respectively. Choosing s in (0,1) allows all intermediate policies between these two extremes to be evaluated, and we see that usually neither extreme is ideal. We derive closed-form approximations for the outage probability relative to a target SINR in a decentralized (ad hoc or unlicensed) network as well as for the resulting transmission capacity, which is the number of users/m^2 that can achieve this SINR on average. Using these approximations, which are quite accurate over typical system parameter values, we prove that using an exponent of 1/2 minimizes the outage probability, meaning that the inverse square root of the channel strength is a sensible transmit power scaling for networks with a relatively low density of interferers. We also show numerically that this choice of s is robust to a wide range of variations in the network parameters. Intuitively, s=1/2 balances between helping disadvantaged users while making sure they do not flood the network with interference.
قيم البحث
اقرأ أيضاً
A wireless packet network is considered in which each user transmits a stream of packets to its destination. The transmit power of each user interferes with the transmission of all other users. A convex cost function of the completion times of the us
er packets is minimized by optimally allocating the users transmission power subject to their respective power constraints. At all ranges of SINR, completion time minimization can be formulated as a convex optimization problem and hence can be efficiently solved. In particular, although the feasible rate region of the wireless network is non-convex, its corresponding completion time region is shown to be convex. When channel knowledge is imperfect, robust power control is considered based on the channel fading distribution subject to outage probability constraints. The problem is shown to be convex when the fading distribution is log-concave in exponentiated channel power gains; e.g., when each user is under independent Rayleigh, Nakagami, or log-normal fading. Applying the optimization frameworks in a wireless cellular network, the average completion time is significantly reduced as compared to full power transmission.
We address the optimization of the sum rate performance in multicell interference-limited singlehop networks where access points are allowed to cooperate in terms of joint resource allocation. The resource allocation policies considered here combine
power control and user scheduling. Although very promising from a conceptual point of view, the optimization of the sum of per-link rates hinges, in principle, on tough issues such as computational complexity and the requirement for heavy receiver-to-transmitter channel information feedback across all network cells. In this paper, we show that, in fact, distributed algorithms are actually obtainable in the asymptotic regime where the numbers of users per cell is allowed to grow large. Additionally, using extreme value theory, we provide scaling laws for upper and lower bounds for the network capacity (sum of single user rates over all cells), corresponding to zero-interference and worst-case interference scenarios. We show that the scaling is either dominated by path loss statistics or by small-scale fading, depending on the regime and user location scenario. We show that upper and lower rate bounds behave in fact identically, asymptotically. This remarkable result suggests not only that distributed resource allocation is practically possible but also that the impact of multicell interference on the capacity (in terms of scaling) actually vanishes asymptotically.
Assuming non-ideal circuit power consumption at the energy harvesting (EH) nodes, we propose two practical protocols that optimize the performance of the harvest-then-transmit wireless powered communication networks (WPCNs) under two different object
ives: (1) proportional fair (PF) resource allocation, and (2) sum rate maximization. These objectives lead to optimal allocations for the transmit power by the base station (BS), which broadcasts RF radiation over the downlink, and optimal durations of the EH phase and the uplink information transmission phases within the dynamic time-division multiple access (TDMA) frame. Compared to the max-sum-rate protocol, the PF protocol attains a higher level of system fairness at the expense of the sum rate degradation. The PF protocol is advantageous over the max-sum-rate protocol in terms of system fairness regardless of the circuit power consumption, whereas the uplink sum rates of both protocols converge when this power consumption increases.
Radiative wireless power transfer (WPT) is a promising technology to provide cost-effective and real-time power supplies to wireless devices. Although radiative WPT shares many similar characteristics with the extensively studied wireless information
transfer or communication, they also differ significantly in terms of design objectives, transmitter/receiver architectures and hardware constraints, etc. In this article, we first give an overview on the various WPT technologies, the historical development of the radiative WPT technology and the main challenges in designing contemporary radiative WPT systems. Then, we focus on discussing the new communication and signal processing techniques that can be applied to tackle these challenges. Topics discussed include energy harvester modeling, energy beamforming for WPT, channel acquisition, power region characterization in multi-user WPT, waveform design with linear and non-linear energy receiver model, safety and health issues of WPT, massive MIMO (multiple-input multiple-output) and millimeter wave (mmWave) enabled WPT, wireless charging control, and wireless power and communication systems co-design. We also point out directions that are promising for future research.
This paper investigates power splitting for full-duplex relay networks with wireless information and energy transfer. By applying power splitting as a relay transceiver architecture, the full duplex information relaying can be powered by energy harve
sted from the source-emitted radio frequency signal. In order to minimize outage probability, power splitting ratios have been dynamically optimized according to full channel state information (CSI) and partial CSI, respectively. Under strong loop interference, the proposed full CSI-based and partial CSI-based power splitting schemes achieve the better outage performance than the fixed power splitting scheme, whereas the partial CSI-based power splitting scheme can ensure competitive outage performance without requiring CSI of the second-hop link. It is also observed that the worst outage performance is achieved when the relay is located midway between the source and destination, whereas the outage performance of partial CSI-based power splitting scheme approaches that of full CSI-based scheme when the relay is placed close to the destination.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
