A self-control mechanism that stabilizes the size of Rhodamine B-doped water microdroplets standing on a superhydrophobic surface is demonstrated. The mechanism relies on the interplay between the condensation rate that was kept constant and evaporation rate induced by laser excitation which critically depends on the size of the microdroplets. The radii of individual water microdroplets (>5 um) stayed within a few nanometers during long time periods (up to 455 seconds). By blocking the laser excitation for 500 msec, the stable volume of individual microdroplets was shown to change stepwise.
We report laser emission from single, stationary, Rhodamine B-doped glycerol/water microdroplets located on a superhydrophobic surface. In the experiments, a pulsed, frequency-doubled Nd:YAG laser operating at 532 nm was used as the excitation source
. The microdroplets ranged in diameter from a few to 20 um. Lasing was achieved in the red-shifted portion of the dye emission spectrum with threshold fluences as low as 750 J/cm2. Photobleaching was observed when the microdroplets were pumped above threshold. In certain cases, multimode lasing was also observed and attributed to the simultaneous lasing of two modes belonging to different sets of whispering gallery modes.
Hybrid pumping appears as a promising compromise in order to reach the much coveted goal of an electrically pumped organic laser. In such configuration the organic material is optically pumped by an electrically pumped inorganic device on chip. This
engineering solution requires therefore an optimization of the organic gain medium under optical pumping. Here, we report a detailed study of the gain features of dye-doped polymer thin films. In particular we introduce the gain efficiency $K$, in order to facilitate comparison between different materials and experimental conditions. The gain efficiency was measured with various setups (pump-probe amplification, variable stripe length method, laser thresholds) in order to study several factors which modify the actual gain of a layer, namely the confinement factor, the pump polarization, the molecular anisotropy, and the re-absorption. For instance, for a 600 nm thick 5 wt% DCM doped PMMA layer, the different experimental approaches give a consistent value $Ksimeq$ 80 cm.MW$^{-1}$. On the contrary, the usual model predicting the gain from the characteristics of the material leads to an overestimation by two orders of magnitude, which raises a serious problem in the design of actual devices. In this context, we demonstrate the feasibility to infer the gain efficiency from the laser threshold of well-calibrated devices. Besides, temporal measurements at the picosecond scale were carried out to support the analysis.
We report electron spin resonance measurements of donors in silicon at millikelvin temperatures using a superconducting $LC$ planar micro-resonator and a Josephson Parametric Amplifier. The resonator includes a nanowire inductor, defining a femtolite
r detection volume. Due to strain in the substrate, the donor resonance lines are heavily broadened. Single-spin to photon coupling strengths up to $sim 3~text{kHz}$ are observed. The single shot sensitivity is $120 pm 24~$spins/Hahn echo, corresponding to $approx 12 pm 3$~spins$/sqrt{text{Hz}}$ for repeated acquisition.
Lasers based on biological materials are attracting an increasing interest in view of their use in integrated and transient photonics. DNA as optical biopolymer in combination with highly-emissive dyes has been reported to have excellent potential in
this respect, however achieving miniaturized lasing systems based on solid-state DNA shaped in different geometries to confine and enhance emission is still a challenge, and physico-chemical mechanisms originating fluorescence enhancement are not fully understood. Herein, a class of wavelength-tunable lasers based on DNA nanofibers is demonstrated, for which optical properties are highly controlled through the system morphology. A synergistic effect is highlighted at the basis of lasing action. Through a quantum chemical investigation, we show that the interaction of DNA with the encapsulated dye leads to hindered twisting and suppressed channels for the non-radiative decay. This is combined with effective waveguiding, optical gain, and tailored mode confinement to promote morphologically-controlled lasing in DNA-based nanofibers. The results establish design rules for the development of bright and tunable nanolasers and optical networks based on DNA nanostructures.
We study statistical properties after a sudden episode of wind for water waves propagating in one direction. A wave with random initial conditions is propagated using a forced-damped higher order Nonlinear Schrodinger equation (NLS). During the wind
episode, the wave action increases, the spectrum broadens, the spectral mean shifts up and the Benjamin-Feir index (BFI) and the kurtosis increase. Conversely, after the wind episode, the opposite occurs for each quantity. The kurtosis of the wave height distribution is considered the main parameter that can indicate whether rogue waves are likely to occur in a sea state, and the BFI is often mentioned as a means to predict the kurtosis. However, we find that while there is indeed a quadratic relation between these two, this relationship is dependent on the details of the forcing and damping. Instead, a simple and robust quadratic relation does exist between the kurtosis and the bandwidth. This could allow for a single-spectrum assessment of the likelihood of rogue waves in a given sea state. In addition, as the kurtosis depends strongly on the damping and forcing coefficients, by combining the bandwidth measurement with the damping coefficient, the evolution of the kurtosis after the wind episode can be predicted.