ترغب بنشر مسار تعليمي؟ اضغط هنا

We carefully investigated the ferromagnetic coupling in the as-grown and annealed ferromagnetic semiconductor GaMnAs/AlGaMnAs bilayer devices. We observed that the magnetic interaction between the two layers strongly affects the magnetoresistance of the GaMnAs layer with applying out of plane magnetic field. After low temperature annealing, the magnetic easy axis of the AlGaMnAs layer switches from out of plane into in-plane and the interlayer coupling efficiency is reduced from up to 0.6 to less than 0.4. However, the magnetic coupling penetration depth for the annealed device is twice that of the as-grown bilayer device.
A critical challenge for the integration of the optoelectronics is that photodetectors have relatively poor sensitivities at the nanometer scale. It is generally believed that a large electrodes spacing in photodetectors is required to absorb suffici ent light to maintain high photoresponsivity and reduce the dark current. However, this will limit the optoelectronic integration density. Through spatially resolved photocurrent investigation, we find that the photocurrent in metal-semiconductor-metal (MSM) photodetectors based on layered GaSe is mainly generated from the photoexcited carriers close to the metal-GaSe interface and the photocurrent active region is always close to the Schottky barrier with higher electrical potential. The photoresponsivity monotonically increases with shrinking the spacing distance before the direct tunneling happen, which was significantly enhanced up to 5,000 AW-1 for the bottom contacted device at bias voltage 8 V and wavelength of 410 nm. It is more than 1,700-fold improvement over the previously reported results. Besides the systematically experimental investigation of the dependence of the photoresponsivity on the spacing distance for both the bottom and top contacted MSM photodetectors, a theoretical model has also been developed to well explain the photoresponsivity for these two types of device configurations. Our findings realize shrinking the spacing distance and improving the performance of 2D semiconductor based MSM photodetectors simultaneously, which could pave the way for future high density integration of 2D semiconductor optoelectronics with high performances.
312 - Y. F. Cao , K. M. Cai , L. J. Li 2014
We carefully investigated the transport and capacitance properties of few layer charge density wave (CDW) 2H-TaS2 devices. The CDW transition temperature and the threshold voltage vary from device to device, which is attributed to the interlayer inte raction and inhomogeneous local defects of these micro-devices based on few layer 2H-TaS2 flakes. Semiconductivity rather than metallic property of 2H-TaS2 devices was observed in our experiment at low temperature. The temperature dependence of the relative threshold voltage can be scaled to (1- T / Tr )^0.5+delta with delta=0.08 for the different measured devices with presence of the CDWs. The conductance-voltage and capacity-voltage measurements were performed simultaneously. At very low ac active voltage, we found that the hysteresis loops of these two measurements exactly match each other. Our results point out that the capacity-voltage measurements can also be used to define the threshold depinning voltage of the CDW, which give us a new method to investigate the CDWs.
Electrical current manipulation of magnetization switching through spin-orbital coupling in ferromagnetic semiconductor (Ga,Mn)As Hall bar devices has been investigated. The efficiency of the current-controlled magnetization switching is found to be sensitive to the orientation of the current with respect to the crystalline axes. The dependence of the spin-orbit effective magnetic field on the direction and magnitude of the current is determined from the shifts in the magnetization switching angle. We find that the strain induced effective magnetic field is about three times as large as the Rashba induced magnetic field in our GaMnAs devices.
We observed the coulomb blockade phenomena in ferromagnetic contacting single wall semiconducting carbon nanotube devices. No obvious Coulomb peaks shift was observed with existing only the Zeeman splitting at 4K. Combining with other effects, the fe rromagnetic leads prevent the orbital spin states splitting with magnetic field up to 2 Tesla at 4K. With increasing magnetic field further, both positive or negative coulomb peaks shift slopes are observed associating with clockwise and anticlockwise orbital state splitting. The strongly suppressed/enhanced of the conductance has been observed associating with the magnetic field induced orbital states splitting/converging.
Current-driven magnetic domain wall motion is demonstrated in the quaternary ferromagnetic semiconductor (Ga,Mn)(As,P) at temperatures well below the ferromagnetic transition temperature, with critical currents of the order 10^5Acm^-2. This is enable d by a much weaker domain wall pinning compared to (Ga,Mn)As layers grown on a strain-relaxed buffer layer. The critical current is shown to be comparable with theoretical predictions. The wide temperature range over which domain wall motion can be achieved indicates that this is a promising system for developing an improved understanding of spin-transfer torque in systems with strong spin-orbit interaction.
We have investigated the domain wall resistance for two types of domain walls in a (Ga,Mn)As Hall bar with perpendicular magnetization. A sizeable positive intrinsic DWR is inferred for domain walls that are pinned at an etching step, which is quite consistent with earlier observations. However, much lower intrinsic domain wall resistance is obtained when domain walls are formed by pinning lines in unetched material. This indicates that the spin transport across a domain wall is strongly influenced by the nature of the pinning.
We have studied current-driven domain wall motion in modified Ga_0.95Mn_0.05As Hall bar structures with perpendicular anisotropy by using spatially resolved Polar Magneto-Optical Kerr Effect Microscopy and micromagnetic simulation. Regardless of the initial magnetic configuration, the domain wall propagates in the opposite direction to the current with critical current of 1~2x10^5A/cm^2. Considering the spin transfer torque term as well as various effective magnetic field terms, the micromagnetic simulation results are consistent with the experimental results. Our simulated and experimental results suggest that the spin-torque rather than Oersted field is the reason for current driven domain wall motion in this material.
We investigate the anisotropy of magnetic reversal and current-driven domain wall motion in annealed Ga_0.95Mn_0.05As thin films and Hall bar devices with perpendicular magnetic anisotropy. Hall bars with current direction along the [110] and [1-10] crystallographic axes are studied. The [110] device shows larger coercive field than the [1-10] device. Strong anisotropy is observed during magnetic reversal between [110] and [1-10] directions. A power law dependence is found for both devices between the critical current (JC) and the magnetization (M), with J_C is proportional to M^2.6. The domain wall motion is strongly influenced by the presence of local pinning centres.
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا