ترغب بنشر مسار تعليمي؟ اضغط هنا

We analyze a sample of tens of thousands of spectra of halo turnoff stars, obtained with the optical spectrographs of the Sloan Digital Sky Survey (SDSS), to characterize the stellar halo population in situ out to a distance of a few tens of kpc from the Sun. In this paper we describe the derivation of atmospheric parameters. We also derive the overall stellar metallicity distribution based on F-type stars observed as flux calibrators for the Baryonic Oscillations Spectroscopic Survey (BOSS). Our analysis is based on an automated method that determines the set of parameters of a model atmosphere that reproduces each observed spectrum best. We used an optimization algorithm and evaluate model fluxes by means of interpolation in a precomputed grid. In our analysis, we account for the spectrographs varying resolution as a function of fiber and wavelength. Our results for early SDSS (pre-BOSS upgrade) data compare well with those from the SEGUE Stellar Parameter Pipeline (SSPP), except for stars with logg (cgs units) lower than 2.5. An analysis of stars in the globular cluster M13 reveals a dependence of the inferred metallicity on surface gravity for stars with logg < 2.5, confirming the systematics identified in the comparison with the SSPP. We find that our metallicity estimates are significantly more precise than the SSPP results. We obtain a halo metallicity distribution that is narrower and more asymmetric than in previous studies. The lowest gravity stars in our sample, at tens of kpc from the Sun, indicate a shift of the metallicity distribution to lower abundances, consistent with what is expected from a dual halo system in the Milky Way.
For late-type non-active stars, gravitational redshifts and convective blueshifts are the main source of biases in the determination of radial velocities. If ignored, these effects can introduce systematic errors of the order of ~ 0.5 km/s. We demons trate that three-dimensional hydrodynamical simulations of solar surface convection can be used to predict the convective blue-shifts of weak spectral lines in solar-like stars to ~ 0.070 km/s. Using accurate trigonometric parallaxes and stellar evolution models, the gravitational redshifts can be constrained with a similar uncertainty, leading to absolute radial velocities accurate to better than ~ 0.1 km/s.
The determination of atmospheric parameters is the first and most fundamental step in the analysis of a stellar spectrum. Current and forthcoming surveys involve samples of up to several million stars, and therefore fully automated approaches are req uired to handle not just data reduction but also the analysis, and in particular the determination of atmospheric parameters. We propose that a successful methodology needs, at the very least, to pass a series of consistency tests that we dub the four-step program. This and related issues are discussed in some detail in the context of the massive data set to be obtained with the Radial Velocity Spectrometer onboard Gaia
118 - C. Allende Prieto 2008
The calculation of solar absolute fluxes in the near-UV is revisited, discussing in some detail recent updates in theoretical calculations of bound-free opacity from metals. Modest changes in the abundances of elements such as Mg and the iron-peak el ements have a significant impact on the atmospheric structure, and therefore self-consistent calculations are necessary. With small adjustments to the solar photospheric composition, we are able to reproduce fairly well the observed solar fluxes between 200 and 270 nm, and between 300 and 420 nm, but find too much absorption in the 270-290 nm window. A comparison between our reference 1D model and a 3D time-dependent hydrodynamical simulation indicates that the continuum flux is only weakly sensitive to 3D effects, with corrections reaching <10% in the near-UV, and <2% in the optical.
APOGEE is a large-scale, NIR, high-resolution (R~20,000) spectroscopic survey of Galactic stars. It is one of the four experiments in SDSS-III. Because APOGEE will observe in the H band, it will be the first survey to pierce through Galactic dust and provide a vast, uniform database of chemical abundances and radial velocities for stars across all Galactic populations (bulge, disk, and halo). The survey will be conducted with a dedicated, 300-fiber, cryogenic, spectrograph that is being built at the University of Virginia, coupled to the ARC 2.5m telescope at Apache Point Observatory. APOGEE will use a significant fraction of the SDSS-III bright time during a three-year period to observe, at high signal-to-noise ratio (S/N>100), about 100,000 giant stars selected directly from 2MASS down to a typical flux limit of H<13. The main scientific objectives of APOGEE are: (1) measuring unbiased metallicity distributions and abundance patterns for the different Galactic stellar populations, (2) studying the processes of star formation, feedback, and chemical mixing in the Milky Way, (3) surveying the dynamics of the bulge and disk, placing constraints on the nature and influence of the Galactic bar and spiral arms, and (4) using extensive chemodynamical data, particularly in the inner Galaxy, to unravel its formation and evolution.
We examine closely the solar Center-to-Limb variation of continua and lines and compare observations with predictions from both a 3-D hydrodynamic simulation of the solar surface (provided by M. Asplund and collaborators) and 1-D model atmospheres. I ntensities from the 3-D time series are derived by means of the new synthesis code ASSET, which overcomes limitations of previously available codes by including a consistent treatment of scattering and allowing for arbitrarily complex line and continuum opacities. In the continuum, we find very similar discrepancies between synthesis and observation for both types of model atmospheres. This is in contrast to previous studies that used a ``horizontally and time averaged representation of the 3-D model and found a significantly larger disagreement with observations. The presence of temperature and velocity fields in the 3-D simulation provides a significant advantage when it comes to reproduce solar spectral line shapes. Nonetheless, a comparison of observed and synthetic equivalent widths reveals that the 3-D model also predicts more uniform abundances as a function of position angle on the disk. We conclude that the 3-D simulation provides not only a more realistic description of the gas dynamics, but, despite its simplified treatment of the radiation transport, it also predicts reasonably well the observed Center-to-Limb variation, which is indicative of a thermal structure free from significant systematic errors.
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا