Combining first-principles calculations and spin- and angle-resolved photoemission spectroscopy measurements, we identify the helical spin textures for three different Dirac cone states in the interfaced systems of a 2D topological insulator (TI) of
Bi(111) bilayer and a 3D TI Bi2Se3 or Bi2Te3. The spin texture is found to be the same for the intrinsic Dirac cone of Bi2Se3 or Bi2Te3 surface state, the extrinsic Dirac cone of Bi bilayer state induced by Rashba effect, and the hybridized Dirac cone between the former two states. Further orbit- and atom-resolved analysis shows that s and pz orbits have a clockwise (counterclockwise) spin rotation tangent to the iso-energy contour of upper (lower) Dirac cone, while px and py orbits have an additional radial spin component. The Dirac cone states may reside on different atomic layers, but have the same spin texture. Our results suggest that the unique spin texture of Dirac cone states is a signature property of spin-orbit coupling, independent of topology.
Topological insulators (TIs) and graphene present two unique classes of materials which are characterized by spin polarized (helical) and non-polarized Dirac-cone band structures, respectively. The importance of many-body interactions that renormaliz
e the linear bands near Dirac point in graphene has been well recognized and attracted much recent attention. However, renormalization of the helical Dirac point has not been observed in TIs. Here, we report the experimental observation of the renormalized quasi-particle spectrum with a skewed Dirac cone in a single Bi bilayer grown on Bi2Te3 substrate, from angle-resolved photoemission spectroscopy. First-principles band calculations indicate that the quasi-particle spectra are likely associated with the hybridization between the extrinsic substrate-induced Dirac states of Bi bilayer and the intrinsic surface Dirac states of Bi2Te3 film at close energy proximity. Without such hybridization, only single-particle Dirac spectra are observed in a single Bi bilayer grown on Bi2Se3, where the extrinsic Dirac states Bi bilayer and the intrinsic Dirac states of Bi2Se3 are well separated in energy. The possible origins of many-body interactions are discussed. Our findings provide a means to manipulate topological surface states.
Topological insulators (TIs) are a unique class of materials characterized by a surface (edge) Dirac cone state of helical Dirac fermions in the middle of bulk (surface) gap. When the thickness (width) of TIs is reduced, however, interaction between
the surface (edge) states will open a gap removing the Dirac cone. Using density function theory calculation, we demonstrate the creation of helical Dirac fermions from interfacing two gapped TI films, a single bilayer Bi grown on a single quintuple layer Bi2Se3 or Bi2Te3. The theoretical prediction is directly confirmed by experiment. We further show that the extrinsic helical Dirac fermions consists of predominantly Bi bilayer states, which are created by a giant Rashba effect due to interfacial charge transfer. Our findings provide a promising new method to create novel TI materials by interface engineering.
This paper reports on our research in developing a micro power generation system based on gas turbine engine and piezoelectric converter. The micro gas turbine engine consists of a micro combustor, a turbine and a centrifugal compressor. Comprehensiv
e simulation has been implemented to optimal the component design. We have successfully demonstrated a silicon-based micro combustor, which consists of seven layers of silicon structures. A hairpin-shaped design is applied to the fuel/air recirculation channel. The micro combustor can sustain a stable combustion with an exit temperature as high as 1600 K. We have also successfully developed a micro turbine device, which is equipped with enhanced micro air-bearings and driven by compressed air. A rotation speed of 15,000 rpm has been demonstrated during lab test. In this paper, we will introduce our research results major in the development of micro combustor and micro turbine test device.
Stimulated by recent advances in isolating graphene, we discovered that quantum dot can be trapped in Z-shaped graphene nanoribbon junciton. The topological structure of the junction can confine electronic states completely. By varying junction lengt
h, we can alter the spatial confinement and the number of discrete levels within the junction. In addition, quantum dot can be realized regardless of substrate induced static disorder or irregular edges of the junction. This device can be used to easily design quantum dot devices. This platform can also be used to design zero-dimensional functional nanoscale electronic devices using graphene ribbons.
