Joint user selection (US) and vector precoding (US-VP) is proposed for multiuser multiple-input multiple-output (MU-MIMO) downlink. The main difference between joint US-VP and conventional US is that US depends on data symbols for joint US-VP, wherea
s conventional US is independent of data symbols. The replica method is used to analyze the performance of joint US-VP in the large-system limit, where the numbers of transmit antennas, users, and selected users tend to infinity while their ratios are kept constant. The analysis under the assumptions of replica symmetry (RS) and 1-step replica symmetry breaking (1RSB) implies that optimal data-independent US provides nothing but the same performance as random US in the large-system limit, whereas data-independent US is capacity-achieving as only the number of users tends to infinity. It is shown that joint US-VP can provide a substantial reduction of the energy penalty in the large-system limit. Consequently, joint US-VP outperforms separate US-VP in terms of the achievable sum rate, which consists of a combination of vector precoding (VP) and data-independent US. In particular, data-dependent US can be applied to general modulation, and implemented with a greedy algorithm.
Multiple-input multiple-output (MIMO) broadcast channels (BCs) (MIMO-BCs) with perfect channel state information (CSI) at the transmitter are considered. As joint user selection (US) and vector precoding (VP) (US-VP) with zero-forcing transmit beamfo
rming (ZF-BF), US and continuous VP (CVP) (US-CVP) and data-dependent US (DD-US) are investigated. The replica method, developed in statistical physics, is used to analyze the energy penalties for the two US-VP schemes in the large-system limit, where the number of users, the number of selected users, and the number of transmit antennas tend to infinity with their ratios kept constant. Four observations are obtained in the large-system limit: First, the assumptions of replica symmetry (RS) and 1-step replica symmetry breaking (1RSB) for DD-US can provide acceptable approximations for low and moderate system loads, respectively. Secondly, DD-US outperforms CVP with random US in terms of the energy penalty for low-to-moderate system loads. Thirdly, the asymptotic energy penalty of DD-US is indistinguishable from that of US-CVP for low system loads. Finally, a greedy algorithm of DD-US proposed in authors previous work can achieve nearly optimal performance for low-to-moderate system loads.
Training-based transmission over Rayleigh block-fading multiple-input multiple-output (MIMO) channels is investigated. As a training method a combination of a pilot-assisted scheme and a biased signaling scheme is considered. The achievable rates of
successive decoding (SD) receivers based on the linear minimum mean-squared error (LMMSE) channel estimation are analyzed in the large-system limit, by using the replica method under the assumption of replica symmetry. It is shown that negligible pilot information is best in terms of the achievable rates of the SD receivers in the large-system limit. The obtained analytical formulas of the achievable rates can improve the existing lower bound on the capacity of the MIMO channel with no channel state information (CSI), derived by Hassibi and Hochwald, for all signal-to-noise ratios (SNRs). The comparison between the obtained bound and a high SNR approximation of the channel capacity, derived by Zheng and Tse, implies that the high SNR approximation is unreliable unless quite high SNR is considered. Energy efficiency in the low SNR regime is also investigated in terms of the power per information bit required for reliable communication. The required minimum power is shown to be achieved at a positive rate for the SD receiver with no CSI, whereas it is achieved in the zero-rate limit for the case of perfect CSI available at the receiver. Moreover, numerical simulations imply that the presented large-system analysis can provide a good approximation for not so large systems. The results in this paper imply that SD schemes can provide a significant performance gain in the low-to-moderate SNR regimes, compared to conventional receivers based on one-shot channel estimation.
Phase insensitive optical amplification of an unknown quantum state is known to be a fundamentally noisy operation that inevitably adds noise to the amplified state [1 - 5]. However, this fundamental noise penalty in amplification can be circumvented
by resorting to a probabilistic scheme as recently proposed and demonstrated in refs [6 - 8]. These amplifiers are based on highly non-classical resources in a complex interferometer. Here we demonstrate a probabilistic quantum amplifier beating the fundamental quantum limit utilizing a thermal noise source and a photon number subtraction scheme [9]. The experiment shows, surprisingly, that the addition of incoherent noise leads to a noiselessly amplified output state with a phase uncertainty below the uncertainty of the state prior to amplification. This amplifier might become a valuable quantum tool in future quantum metrological schemes and quantum communication protocols.
Spectral efficiency for asynchronous code division multiple access (CDMA) with random spreading is calculated in the large system limit allowing for arbitrary chip waveforms and frequency-flat fading. Signal to interference and noise ratios (SINRs) f
or suboptimal receivers, such as the linear minimum mean square error (MMSE) detectors, are derived. The approach is general and optionally allows even for statistics obtained by under-sampling the received signal. All performance measures are given as a function of the chip waveform and the delay distribution of the users in the large system limit. It turns out that synchronizing users on a chip level impairs performance for all chip waveforms with bandwidth greater than the Nyquist bandwidth, e.g., positive roll-off factors. For example, with the pulse shaping demanded in the UMTS standard, user synchronization reduces spectral efficiency up to 12% at 10 dB normalized signal-to-noise ratio. The benefits of asynchronism stem from the finding that the excess bandwidth of chip waveforms actually spans additional dimensions in signal space, if the users are de-synchronized on the chip-level. The analysis of linear MMSE detectors shows that the limiting interference effects can be decoupled both in the user domain and in the frequency domain such that the concept of the effective interference spectral density arises. This generalizes and refines Tse and Hanlys concept of effective interference. In Part II, the analysis is extended to any linear detector that admits a representation as multistage detector and guidelines for the design of low complexity multistage detectors with universal weights are provided.
Totally asynchronous code-division multiple-access (CDMA) systems are addressed. In Part I, the fundamental limits of asynchronous CDMA systems are analyzed in terms of spectral efficiency and SINR at the output of the optimum linear detector. The fo
cus of Part II is the design of low-complexity implementations of linear multiuser detectors in systems with many users that admit a multistage representation, e.g. reduced rank multistage Wiener filters, polynomial expansion detectors, weighted linear parallel interference cancellers. The effects of excess bandwidth, chip-pulse shaping, and time delay distribution on CDMA with suboptimum linear receiver structures are investigated. Recursive expressions for universal weight design are given. The performance in terms of SINR is derived in the large-system limit and the performance improvement over synchronous systems is quantified. The considerations distinguish between two ways of forming discrete-time statistics: chip-matched filtering and oversampling.
