Microstructura lly clean, isov alently P-doped BaFe2As2 (Ba-122) single crystalline thin films have been prepared on MgO (001) substrates by molecular beam epitaxy. These films show a superconducting transition temperature (Tc) of over 30 K although
P content is around 0.22, which is lower than the optimal one for single crystals (i.e., 0.33). The enhanced Tc at this doping level is attributed to the in-plane tensile strain. The strained film shows high transport self-field critical current densities (Jc) of over 6 MA/cm2 at 4.2 K, which are among the highest for Fe based superconductors (FeSCs). In-field Jc exceeds 0.1 MA/cm2 at m0H = 35 T for H||ab and m0H = 18 T for H||c at 4.2 K, respectively, in spite of moderate upper critical fields compared to other FeSCs with similar Tc. Structural investigations reveal no defects or misoriented grains pointing to strong pinning centers. We relate this unexpected high Jc to a strong enhancement of the vortex core energy at optimal Tc, driven by in-plane strain and doping. These unusually high Jc make P-doped Ba-122 very favorable for high-field magnet applications.
Ba(Fe1-xCox)2As2 is the most tunable of the Fe-based superconductors (FBS) in terms of acceptance of high densities of self-assembled and artificially introduced pinning centres which are effective in significantly increasing the critical current den
sity, Jc. Moreover, FBS are very sensitive to strain, which induces an important enhancement in critical temperature, Tc, of the material. In this paper we demonstrate that strain induced by the substrate can further improve Jc of both single and multilayer films by more than that expected simply due to the increase in Tc. The multilayer deposition of Ba(Fe1-xCox)2As2 on CaF2 increases the pinning force density Fp by more than 60% compared to a single layer film, reaching a maximum of 84 GN/m^3 at 22.5T and 4.2 K, the highest value ever reported in any 122 phase.
In modern Nb3Sn wires there is a fundamental compromise to be made between optimizing the intrinsic properties associated with the superfluid density in the A15 phase (e.g. Tc, Hc, Hc2, all of which are composition dependent), maximizing the quantity
of A15 that can be formed from a given mixture of Nb, Sn and Cu, minimizing the A15 composition gradients within each sub-element, while at the same time generating a high vortex pinning critical current density, Jc, by maximizing the grain boundary density with the additional constraint of maintaining the RRR of the Cu stabilizer above 100. Here we study these factors in a Ta-alloyed Restacked-Rod-Process (RRP) wire with ~70 microns diameter sub-elements. Consistent with many earlier studies, maximum non-Cu Jc(12T,4.2K) requires preventing A15 grain growth, rather than by optimizing the superfluid density. In wires optimized for 12T, 4.2K performance, about 60% of the non-Cu cross-section is A15, 35% residual Cu and Sn core, and only 5% a residual Nb7.5wt.%Ta diffusion barrier. The specific heat and chemical analyses show that in this 60% A15 fraction there is a wide range of Tc and chemical composition that does diminish for higher heat treatment temperatures, which, however, are impractical because of the strong RRR degradation that occurs when only about 2% of the A15 reaction front breaches the diffusion barrier. As this kind of Nb3Sn conductor design is being developed for sub-elements 1/2 the present size, it is clear that better barriers are essential to allowing higher temperature reactions with better intrinsic A15 properties. We present here multiple and detailed intrinsic and extrinsic evaluations because we believe that only such broad and quantitative descriptions are capable of accurately tracking the limitations of individual conductor designs where optimization will always be a compromise between inherently conflicting goals
Significant progress has been achieved in fabricating high quality bulk and thinfilm iron-based superconductors. In particular, artificial layered pnictide superlattices offer the possibility of tailoring the superconducting properties and understand
ing the mechanism of the superconductivity itself. For high field applications, large critical current densities (Jc) and irreversibility fields (Hirr) are indispensable along all crystal directions. On the other hand, the development of superconducting devices such as tunnel junctions requires multilayered heterostructures. Here we show that artificially engineered undoped Ba-122 / Co doped Ba-122 compositionally modulated superlattices produce ab-aligned nanoparticle arrays. These layer and self-assemble along c-axis aligned defects, and combine to produce very large Jc and Hirr enhancements over a wide angular range. We also demonstrate a structurally modulated SrTiO3 (STO) / Co doped Ba-122 superlattice with sharp interfaces. Success in superlattice fabrication involving pnictides will aid the progress of heterostructured systems exhibiting novel interfacial phenomena and device applications.
We report on the superior vortex pinning of single and multilayer Ba(Fe1-xCox)2As2 thin films with self-assembled c-axis and artificially introduced ab-plane pins. Ba(Fe1-xCox)2As2 can accept a very high density of pins (15-20 vol%) without Tc suppre
ssion. The matching field is greater than 12 T, producing a significant enhancement of the critical current density Jc, an almost isotropic Jc (Theta,20T) > 10^5 A/cm2, and global pinning force density Fp of about 50 GN/m^3. This scenario strongly differs from the high temperature cuprates where the addition of pins without Tc suppression is limited to 2-4 vol%, leading to small HIrr enhancements and improved Jc only below 3-5 Tesla.
The K- and Co-doped BaFe2As2 (Ba-122) superconducting compounds are potentially useful for applications because they have upper critical fields (Hc2) of well over 50 T, Hc2 anisotropy Gamma < 2, and thin film critical current densities exceeding 1 MA
cm-2 at 4.2 K. However, thin-film bicrystals of Co-doped Ba-122 clearly exhibit weak link behavior for [001] tilt misorientations of more than about 5 degrees, suggesting that textured substrates would be needed for applications, as in the cuprates. Here we present a contrary and very much more positive result in which untextured polycrystalline (Ba0.6K0.4)Fe2As2 bulks and round wires with high grain boundary density have transport critical current densities well over 0.1 MAcm-2 (SF, 4.2 K), more than 10 times higher than that of any other ferropnictide wire. The enhanced grain connectivity is ascribed to their much improved phase purity and to the enhanced vortex stiffness of this low-anisotropy compound (Gamma ~ 1-2) compared to YBa2Cu3O7-x (Gamma ~ 5).
We report measurements of the field and angular dependences of Jc of truly epitaxial Co-doped BaFe2As2 thin films grown on SrTiO3/(La,Sr)(Al,Ta)O3 with different SrTiO3 template thicknesses. The films show Jc comparable to Jc of single crystals and a
maximum pinning force Fp(0.6Tc) > 5 GN/m3 at H/Hirr ~ 0.5 indicative of strong vortex pinning effective up to high fields. Due to the strong correlated c-axis pinning, Jc for field along the c-axis exceeds Jc for H//ab plane, inverting the expectation of the Hc2 anisotropy. HRTEM reveals that the strong vortex pinning is due to a high density of nanosize columnar defects.
We report a comprehensive investigation of the suppression of the critical temperature Tc of NdFeAs(OF) single crystal by alpha-particle irradiation. Our data indicate that irradiation defects produce both nonmagnetic and magnetic scattering, resulti
ng in the Kondo-like excess resistance $Deltarho(T)propto ln T$ over 2 decades in temperatures above $T_c$. Despite high densities of irradiation defects, the dose at which $T_c$ is suppressed to zero is comparable to that for MgB2 but is well above the corresponding values for cuprates.
We have investigated the evolution of the low temperature specific heat anomaly (TN=5.4K in zero field) in polycrystalline SmFeAsO samples with magnetic fields up to 35T. The anomaly remains very sharp up to 16T and becomes rounded with little shift
in temperature at higher fields. Doped (superconducting) SmFeAsO0.85F0.15 sample shows a similar behavior up to 16T. The initial slope of the critical field dBc/dT is 160T/K for undoped SmFeAsO and 70T/K for doped SmFeAsO0.85F0.15, with Bc(T) defined at the peak of the specific heat anomaly. The insensitivity to the application of an external magnetic field is unique to Sm and is not observed in CeFeAsO whose anomaly shifts with initial slope dBc/dT=5.7T/K. We argue that SmFeAsO(F) presents an unprecedented case of spin reorientation at the antiferromagnetic transition.
We performed high-field magnetotransport and magnetization measurements on a single crystal of the 122-phase iron pnictide Ba(Fe1-xCox)2As2. Unlike the HTS cuprates and 1111-phase oxypnictides, Ba(Fe1-xCox)2As2 showed practically no broadening of the
resistive transitions under magnetic fields up to 45 T. The mass anisotropy gamma = Hc2ab/Hc2c deduced from the slopes of the upper critical field dHc2ab/dT = 4.9T/K and dHc2c/dT = 2.5T/K decreases from ~2 near Tc, to ~1.5 at lower temperatures. We observed the irreversibility field close to Hc2, and a rather unusual symmetric volume pinning force curve Fp(H) suggestive of strong pinning nano-structure.
