Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userLight / heavy hole switching with correlated characterization on a single quantum dot : Probing the light hole / heavy hole switching with correlated magneto-optical spectroscopy and chemical analysis on a single quantum dot
115
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
A whole series of complementary studies have been performed on the same, single nanowire containing a quantum dot: cathodoluminescence spectroscopy and imaging, micro-photoluminescence spectroscopy under magnetic field and as a function of temperature, and energy-dispersive X-ray spectrometry and imaging. The ZnTe nanowire was deposited on a Si 3 N 4 membrane with Ti/Al patterns. The complete set of data shows that the CdTe quantum dot features the heavy-hole state as a ground state, although the compressive mismatch strain promotes a light-hole ground state as soon as the aspect ratio is larger than unity (elongated dot). A numerical calculation of the whole structure shows that the transition from the heavy-hole to the light-hole configuration is pushed toward values of the aspect ratio much larger than unity by the presence of a (Zn,Mg)Te shell, and that the effect is further enhanced by a small valence band offset between the semiconductors in the dot and around it.
rate research
Read More
We investigate Kondo effect and spin blockade observed on a many-electron quantum dot and study the magnetic field dependence. At lower fields a pronounced Kondo effect is found which is replaced by spin blockade at higher fields. In an intermediate regime both effects are visible. We make use of this combined effect to gain information about the internal spin configuration of our quantum dot. We find that the data cannot be explained assuming regular filling of electronic orbitals. Instead spin polarized filling seems to be probable.
We experimentally investigate the dynamic nonlinear response of a single quantum dot (QD) strongly coupled to a photonic crystal cavity-waveguide structure. The temporal response is measured by pump-probe excitation where a control pulse propagating through the waveguide is used to create an optical Stark shift on the QD, resulting in a large modification of the cavity reflectivity. This optically induced cavity reflectivity modification switches the propagation direction of a detuned signal pulse. Using this device we demonstrate all-optical switching with only 14 attojoules of control pulse energy. The response time of the switch is measured to be up to 8.4 GHz, which is primarily limited by the cavity-QD interaction strength.
Quantum dots inserted inside semiconductor nanowires are extremely promising candidates as building blocks for solid-state based quantum computation and communication. They provide very high crystalline and optical properties and offer a convenient geometry for electrical contacting. Having a complete determination and full control of their emission properties is one of the key goals of nanoscience researchers. Here we use strain as a tool to create in a single magnetic nanowire quantum dot a light-hole exciton, an optically active quasiparticle formed from a single electron bound to a single light hole. In this frame, we provide a general description of the mixing within the hole quadruplet induced by strain or confinement. A multi-instrumental combination of cathodoluminescence, polarisation-resolved Fourier imaging and magneto-optical spectroscopy, allow us to fully characterize the hole ground state, including its valence band mixing with heavy hole states.
Starting from the numerical solution of the 6-band textbf{k.p} description of a lattice-mismatched ellipsoidal quantum dot situated inside a nanowire, including a spin Zeeman effect with values appropriate to a dilute magnetic semiconductor, we propose and test phenomenological models of the effect of the built-in strain on the heavy hole, light hole and exciton states. We test the validity and the limits of a description restricted to a ($Gamma_8$) quadruplet of ground states and we demonstrate the role of the interactions of the light-hole state with light-hole excited states. We show that the built-in axial strain not only defines the character, heavy-hole or light-hole, of the ground state, but also mixes significantly the light-hole state with the split-off bands states: Even for a spin-orbit energy as large as 1 eV, that mixing induces first-order modifications of properties such as the spin value and anisotropy, the oscillator strength, and the electron-hole exchange, for which we extend the description to the light-hole exciton. CdTe/ZnTe quantum dots are mainly used as a test case but the concepts we discuss apply to many heterostructures, from mismatched II-VI and III-V quantum dots and nanowires, to III-V nanostructures submitted to an applied stress and to silicon nanodevices with even smaller residual strains.
We report strong heavy hole-light mixing in GaAs quantum dots grown by droplet epitaxy. Using the neutral and charged exciton emission as a monitor we observe the direct consequence of quantum dot symmetry reduction in this strain free system. By fitting the polar diagram of the emission with simple analytical expressions obtained from k$cdot$p theory we are able to extract the mixing that arises from the heavy-light hole coupling due to the geometrical asymmetry of the quantum dot.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
