Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userRecharging and rejuvenation of decontaminated N95 masks
54
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
N95 respirators comprise a critical part of the personal protective equipment used by frontline health-care workers, and are typically meant for one-time usage. However, the recent COVID-19 pandemic has resulted in a serious shortage of these masks leading to a worldwide effort to develop decontamination and re-use procedures. A major factor contributing to the filtration efficiency of N95 masks is the presence of an intermediate layer of charged polypropylene electret fibers that trap particles through electrostatic or electrophoretic effects. This charge can degrade when the mask is used. Moreover, simple decontamination procedures (e.g. use of alcohol) can degrade any remaining charge from the polypropylene, thus severely impacting the filtration efficiency post decontamination. In this report, we summarize our results on the development of a simple laboratory setup allowing measurement of charge and filtration efficiency in N95 masks. In particular, we propose and show that it is possible to recharge the masks post-decontamination and recover filtration efficiency.
rate research
Read More
Respirators, medical masks, and barrier face coverings all filter airborne particles using similar physical principles yet are tested using a variety of variety of standardized test methods. To quantify and understand the effects of differences between the standardized test methods for N95 respirators (NIOSH TEB-APR-STP-0059 under US 42 CFR 84), medical face masks (ASTM F2299/F2100), and COVID-19-related barrier face coverings (ASTM F3502-21). We systematically compared the experimental performance of the NIOSH and ASTM F2299 test methods in terms of face velocity, particle properties (mean size, size variability, electric charge, density, and shape), measurement techniques, and environmental preconditioning. Filtration efficiency is most sensitive to changes in face velocity and particle charge. Relative to the NIOSH method, users of the ASTM F2299 method have normally used non-neutralized (highly charged) aerosols at smaller face velocities, each of which may enhance measured filtration efficiencies by approximately 10%. Environmental conditioning at elevated humidity increased filtration efficiency in some lots while decreasing it in others, which was observed to result in false positives in the NIOSH method. Our results provide an experimental basis for comparing respirators certified under various international methods including FFP2, KN95, P2, Korea 1st Class, and DS2.
We study the effect of shear on the aging dynamics of a colloidal suspension of synthetic clay particles. We find that a shear of amplitude $gamma$ reduces the relaxation time measured just after the cessation of shear by a factor $exp(-gamma/gamma_c)$, with $gamma_c sim 5%$, and is independent of the duration and the frequency of the shear. This simple law for the rejuvenation effect shows that the energy involved in colloidal rearrangements is proportional to the shear amplitude, $gamma$, rather than $gamma^2$, leading to an Eyring-like description of the dynamics of our system.
The coupling of active, self-motile particles to topological constraints can give rise to novel non-equilibrium dynamical patterns that lack any passive counterpart. Here we study the behavior of self-propelled rods confined to a compact spherical manifold by means of Brownian dynamics simulations. We establish the state diagram and find that short active rods at sufficiently high density exhibit a glass transition toward a disordered state characterized by persistent self-spinning motion. By periodically melting and revitrifying the spherical spinning glass, we observe clear signatures of time-dependent aging and rejuvenation physics. We quantify the crucial role of activity in these non-equilibrium processes, and rationalize the aging dynamics in terms of an absorbing-state transition toward a more stable active glassy state. Our results demonstrate both how concepts of passive glass phenomenology can carry over into the realm of active matter, and how topology can enrich the collective spatiotemporal dynamics in inherently non-equilibrium systems.
Effects of temperature changes on the nonequilibrium spin-glass dynamics of a strongly interacting ferromagnetic nanoparticle system (superspin glass) are studied. In contrary to atomic spin glasses, strong cooling rate effects are observed, and no evidence for temperature-chaos is found. The flip time of a magnetic moment is much longer than that of an atomic spin and hence much shorter time scales are probed within the experimental time window for a superspin glass than for an atomic spin glass. Within a real space picture the cumulative aging observed for the superspin glass can be explained considering that all investigated length scales are shorter than the temperature-chaos overlap length. The transient relaxation, observed in experiments after temperature changes, can be understood as the adjustment of thermally active droplets, which is mutatis mutandis the Kovacs effect observed in most glassy systems.
We measure the local yield stress, at the scale of small atomic regions, in a deeply quenched two-dimensional glass model undergoing shear banding in response to athermal quasistatic (AQS) deformation. We find that the occurrence of essentially a single plastic event suffices to bring the local yield stress distribution to a well-defined value for all strain orientations, thus essentially erasing the memory of the initial structure. It follows that in a well-relaxed sample, plastic events cause the abrupt (nucleation-like) emergence of a local softness contrast and thus precipitate the formation of a band, which, in its early stages, is measurably softer than the steady-state flow. Moreover, this postevent yield stress ensemble presents a mean value comparable to that of the inherent states of a supercooled liquid around the mode-coupling temperature $T_{rm MCT}$. This, we argue, explains that the transition between brittle and ductile yielding in amorphous materials occurs around a comparable parent temperature. Our data also permit to capture quantitatively the contributions of pressure and density changes and demonstrate unambiguously that they are negligible compared with the changes of softness caused by structural rejuvenation.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
