Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userSpin detection via parametric frequency conversion in a membrane resonator
54
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Recent demonstrations of ultracoherent nanomechanical resonators introduce the prospect of new protocols for solid state sensing applications. Here, we propose to use two coupled ultracoherent resonator modes on a Si$_3$N$_4$ membrane for the detection of small nuclear spin ensembles. To this end, we employ parametric frequency conversion between nondegenerate modes. The nondegenerate modes result from coupled degenerate resonators, and the parametric conversion is mediated by periodic
rate research
Read More
We report on the measurement and characterization of power to frequency conversion in the resonant mode of a cryogenic sapphire loaded cavity resonator, which is used as the frequency discriminating element of a loop oscillator circuit. Fluctuations of power incident on the resonator leads to changes in radiation pressure and temperature in the sapphire dielectric, both of which contribute to a shift in the resonance frequency. We measure a modulation and temperature independent radiation pressure induced power to frequency sensitivity of -0.15 Hz/mW and find that this is the primary factor limiting the stability of the resonator frequency.
The microwave cavity perturbation method is often used to determine material parameters (electric permittivity and magnetic permeability) at high frequencies and it relies on measurement of the resonator parameters. We present a method to determine the $Q$-factor and resonance frequency of microwave resonators which is conceptually simple but provides a sensitivity for these parameters which overcomes those of existing methods by an order of magnitude. The microwave resonator is placed in a feedback resonator setup, where the output of an amplifier is connected to its own input with the resonator as a band pass filter. After reaching steady-state oscillation, the feedback circuit is disrupted by a fast microwave switch and the transient signal, which emanates from the resonator, is detected using down-conversion. The Fourier transform of the resulting time-dependent signal yields directly the resonance profile of the resonator. Albeit the method is highly accurate, this comes with a conceptual simplicity, ease of implementation and lower circuit cost. We compare existing methods for this type of measurement to explain the sensitivity of the present technique and we also make a prediction for the ultimate sensitivity for the resonator $Q$ and $f_0$ determination.
Optical spin pumping of color centers in diamond is presently attracting broad interest as a platform for dynamic nuclear polarization at room temperature, but the mechanisms involved in the generation and transport of polarization within the host crystal are still partly understood. Here we investigate the impact of continuous radio-frequency (RF) excitation on the generation of nuclear magnetization produced by optical illumination. In the presence of RF excitation far removed from the nuclear Larmor frequency, we witness a magnetic-field-dependent sign reversal of the measured nuclear spin signal when the drive is sufficiently strong, a counter-intuitive finding that immediately points to non-trivial spin dynamics. With the help of analytical and numerical modeling, we show our observations indicate a modified form of solid effect, down-converted from the microwave to the radio-frequency range through the driving of hybrid transitions involving one (or more) nuclei and two (or more) electron spins. Our results open intriguing opportunities for the manipulation of many-electron spin systems by exploiting hyperfine couplings as a means to access otherwise forbidden intra-band transitions.
Current approaches for electric power generation from nanoscale conducting or semi-conducting layers in contact with moving aqueous droplets are promising as they show efficiencies of around 30 percent, yet, even the most successful ones pose challenges regarding fabrication and scaling. Here, we report stable, all-inorganic single-element structures synthesized in a single step that generate electrical current when alternating salinity gradients flow along its surface in a liquid flow cell. 10 nm to 30 nm thin nanolayers of iron, vanadium, or nickel produce several tens of mV and several microA cm^-2 at aqueous flow velocities of just a few cm s^-1. The principle of operation is strongly sensitive to charge-carrier motion in the thermal oxide nano-overlayer that forms spontaneously in air and then self terminates. Indeed, experiments suggest a role for intra-oxide electron transfer for Fe, V, and Ni nanolayers, as their thermal oxides contain several metal oxidation states, whereas controls using Al or Cr nanolayers, which self-terminate with oxides that are redox inactive under the experimental conditions, exhibit dramatically diminished performance. The nanolayers are shown to generate electrical current in various modes of application with moving liquids, including sliding liquid droplets, salinity gradients in a flowing liquid, and in the oscillatory motion of a liquid without a salinity gradient.
We propose an experimentally accessible superconducting quantum circuit, consisting of two coplanar waveguide resonators (CWRs), to enhance the microwave squeezing via parametric down-conversion (PDC). In our scheme, the two CWRs are nonlinearly coupled through a superconducting quantum interference device embedded in one of the CWRs. This is equivalent to replacing the transmission line in a flux-driven Josephson parametric amplifier (JPA) by a CWR, which makes it possible to drive the JPA by a quantized microwave field. Owing to this design, the PDC coefficient can be considerably increased to be about tens of megahertz, satisfying the strong-coupling condition. Using the Heisenberg-Langevin approach, we numerically show the enhancement of the microwave squeezing in our scheme. In contrast to the JPA, our proposed system becomes stable around the critical point and can generate stronger transient squeezing. In addition, the strong-coupling PDC can be used to engineer the photon blockade.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
