Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userTerrestrial Planet Finder Coronagraph (TPF-C) Flight Baseline Concept
84
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
The Terrestrial Planet Finder Coronagraph (TPF-C) mission presented here is an existence proof for a flagship-class internal coronagraph space mission capable of detecting and characterizing Earth-like planets and planetary systems at visible wavelengths around nearby stars, using an existing launch vehicle. TPF-C will use spectroscopy to measure key properties of exoplanets including the presence of atmospheric water or oxygen, powerful signatures in the search for habitable worlds.
rate research
Read More
For the first time in human history the possibility of detecting and studying Earth-like planets is on the horizon. Terrestrial Planet Finder (TPF), with a launch date in the 2015 timeframe, is being planned by NASA to find and characterize planets in the habitable zones of nearby stars. The mission Darwin from ESA has similar goals. The motivation for both of these space missions is the detection and spectroscopic characterization of extrasolar terrestrial planet atmospheres. Of special interest are atmospheric biomarkers--such as O2, O3, H2O, CO and CH4--which are either indicative of life as we know it, essential to life, or can provide clues to a planets habitability. A mission capable of measuring these spectral features would also obtain sufficient signal-to-noise to characterize other terrestrial planet properties. For example, physical characteristics such as temperature and planetary radius can be constrained from low- resolution spectra. In addition, planet characteristics such as weather, rotation rate, presence of large oceans or surface ice, and existence of seasons could be derived from photometric measurements of the planets variability. We will review the potential to characterize terrestrial planets beyond their spectral signatures. We will also discuss the possibility to detect strong surface biomarkers--such as Earths vegetation red edge near 700 nm--that are different from any known atomic, molecular, or mineralogical signature.
The Automated Planet Finder (APF) is a facility purpose-built for the discovery and characterization of extrasolar planets through high-cadence Doppler velocimetry of the reflex barycentric accelerations of their host stars. Located atop Mt. Hamilton, the APF facility consists of a 2.4-m telescope and its Levy spectrometer, an optical echelle spectrometer optimized for precision Doppler velocimetry. APF features a fixed format spectral range from 374 nm - 970 nm, and delivers a Throughput (resolution * slit width product) of 114,000 arc-seconds, with spectral resolutions up to 150,000. Overall system efficiency (fraction of photons incident on the primary mirror that are detected by the science CCD) on blaze at 560 nm in planet-hunting mode is 15%. First-light tests on the RV standard stars HD 185144 and HD 9407 demonstrate sub-meter per second precision (RMS per observation) held over a 3-month period. This paper reviews the basic features of the telescope, dome, and spectrometer, and gives a brief summary of first-light performance.
An effective method for detailed observation of the Solar System planets is the use of vehicles that can perform flight in their atmospheres, with the most promising of them being Flyers (aircraft for other planets atmospheres). Besides the advantage of probing the atmosphere directly, they have the ability to fly on selected direction and altitude, making them suitable for collecting information over large areas. Equipping the Flyer with nuclear propulsion will allow it to conduct flight for months without the need of combustible fuel or oxidizer to be carried on board. Among the planets of the Solar System and their satellites, Jupiter is a viable target for exploration, since it features thick atmosphere suitable for aerodynamic flight, there is no solid surface that can be contaminated after end of the mission, and the atmospheric data for designing a Flyer is readily available. This paper proposes a mathematical model for evaluating the thrust, the lift and the maximum allowable mass for horizontal steady flight as functions of the altitude and different heat chamber temperatures.
Over the past two decades, thousands of confirmed exoplanets have been detected; the next major challenge is to characterize these other worlds and their stellar systems. Much information on the composition and formation of exoplanets and circumstellar debris disks can only be achieved via direct imaging. Direct imaging is challenging because of the small angular separations ($<1$ arcsec) and high star-to-planet flux ratios (${sim}10^{9}$ for a Jupiter analog or ${sim}10^{10}$ for an Earth analog in the visible). Atmospheric turbulence prohibits reaching such high flux ratios on the ground, so observations must be made above the Earths atmosphere. The Nancy Grace Roman Space Telescope (Roman), set to launch in the mid-2020s, will be the first space-based observatory to demonstrate high-contrast imaging with active wavefront control using its Coronagraph Instrument. The instruments main purpose is to mature the various technologies needed for a future flagship mission to image and characterize Earth-like exoplanets. These technologies include two high-actuator-count deformable mirrors, photon-counting detectors, two complementary wavefront sensing and control loops, and two different coronagraph types. In this paper, we describe the complete set of flight coronagraph mask designs and their intended combinations in the Roman Coronagraph Instrument. There are three types of mask configurations included: a primary one designed to meet the instruments top-level requirement, three that are supported on a best-effort basis, and several unsupported ones contributed by the NASA Exoplanet Exploration Program. The unsupported mask configurations could be commissioned and used if the instrument is approved for operations after its initial technology demonstration phase.
One of two approaches to implementing NASAs Terrestrial Planet Finder is to build a space telescope that utilizes the techniques of coronagraphy and apodization to suppress diffraction and image exo-planets. We present a method for calculation of a telescopes apodizer which suppresses the side lobes of the image of a star so as to optimally detect an Earth-like planet. Given the shape of a telescopes aperture and given a search region for a detector, we solve an integral equation to determine an amplitude modulation (an apodizer) which suppresses the stars energy in the focal plane search region. The method is quite general and yields as special cases the product apodizer reported by Nisenson and Papaliolios (2001) and the Prolate spheroidal apodizer of Kasdin et al (2002), and Aime et al (2002). We show computer simulations of the apodizers and the corresponding point spread functions for various aperture-detector configurations.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
