Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userTransport regimes in surface disordered graphene sheets
77
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We investigate the size scaling of the conductance of surface disordered graphene sheets of width W and length L. Metallic leads are attached to the sample ends across its width. At E ~ 0, the conductance scales with the system size as follows: i) For constant W/L, it remains constant as size is increased, at a value which depends almost lineally on that ratio; this scaling allows the definition of a conductivity value that results similar to the experimental one. ii) For fixed width, the conductance decreases exponentially with length L, both for ordered and disordered samples. Disorder reduces the exponential decay, leading to a higher conductance. iii) For constant length, conductance increases linearly with width W, a result that is exclusively due to the tails of the states of the metallic wide contact. iv) The average conductance does not show an appreciable dependence on magnetic field. Away from E = 0, the conductance shows the behavior expected in two-dimensional systems with surface disorder, i.e., ballistic transport.
rate research
Read More
We investigate the conductivity $sigma$ of graphene nanoribbons with zigzag edges as a function of Fermi energy $E_F$ in the presence of the impurities with different potential range. The dependence of $sigma(E_F)$ displays four different types of behavior, classified to different regimes of length scales decided by the impurity potential range and its density. Particularly, low density of long range impurities results in an extremely low conductance compared to the ballistic value, a linear dependence of $sigma(E_F)$ and a wide dip near the Dirac point, due to the special properties of long range potential and edge states. These behaviors agree well with the results from a recent experiment by Miao emph{et al.} (to appear in Science).
The amount of rippling in graphene sheets is related to the interactions with the substrate or with the suspending structure. Here, we report on an irreversibility in the response to forces that act on suspended graphene sheets. This may explain why one always observes a ripple structure on suspended graphene. We show that a compression-relaxation mechanism produces static ripples on graphene sheets and determine a peculiar temperature $T_c$, such that for $T<T_c$ the free-energy of the rippled graphene is smaller than that of roughened graphene. We also show that $T_c$ depends on the structural parameters and increases with increasing sample size.
We have measured the impact of atomic hydrogen adsorption on the electronic transport properties of graphene sheets as a function of hydrogen coverage and initial, pre-hydrogenation field-effect mobility. Our results are compatible with hydrogen adsorbates inducing intervalley mixing by exerting a short-range scattering potential. The saturation coverages for different devices are found to be proportional to their initial mobility, indicating that the number of native scatterers is proportional to the saturation coverage of hydrogen. By extrapolating this proportionality, we show that the field-effect mobility can reach $1.5 times 10^4$ cm$^2$/V sec in the absence of the hydrogen-adsorbing sites. This affinity to hydrogen is the signature of the most dominant type of native scatterers in graphene-based field-effect transistors on SiO$_2$.
We report an electron transport study of lithographically fabricated graphene nanoribbons of various widths and lengths at different temperatures. At the charge neutrality point, a length-independent transport gap forms whose size is inversely proportional to the width. In this gap, electron is localized, and charge transport exhibits a transition between simple thermally activated behavior at higher temperatures and a variable range hopping at lower temperatures. By varying the geometric capacitance through the addition of top gates, we find that charging effects constitute a significant portion of the activation energy.
We demonstrate how self-assembled monolayers of aromatic molecules on copper substrates can be converted into high-quality single-layer graphene using low-energy electron irradiation and subsequent annealing. We characterize this two-dimensional solid state transformation on the atomic scale and study the physical and chemical properties of the formed graphene sheets by complementary microscopic and spectroscopic techniques and by electrical transport measurements. As substrates we successfully use Cu(111) single crystals and the technologically relevant polycrystalline copper foils.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
