Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userQubit measurements with a double-dot detector
72
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We propose to monitor a qubit with a double-dot (DD) resonant-tunneling detector, which can operate at higher temperatures than a single-dot detector. In order to assess the effectiveness of this device, we derive rate equations for the density matrix of the entire system. We show that the signal-to-noise ratio can be greatly improved by a proper choice of the parameters and location of the detector. We demonstrate that quantum interference effects within the DD detector play an important role in the measurement. Surprisingly, these effects produce a systematic measurement error, even when the entire system is in a stationary state.
rate research
Read More
We propose to continuously monitor a charge qubit by utilizing a T-shaped double quantum dot detector, in which the qubit and double dot are arranged in such a unique way that the detector turns out to be particularly susceptible to the charge states of the qubit. Special attention is paid to the regime where acquisition of qubit information and backaction upon the measured system exhibit nontrivial correlation. The intrinsic dynamics of the qubit gives rise to dynamical blockade of tunneling events through the detector, resulting in a super-Poissonian noise. However, such a pronounced enhancement of detectors shot noise does not necessarily produce a rising dephasing rate. In contrast, an inhibition of dephasing is entailed by the reduction of information acquisition in the dynamically blockaded regimes. We further reveal the important impact of the charge fluctuations on the measurement characteristics. Noticeably, under the condition of symmetric junction capacitances the noise pedestal of circuit current is completely suppressed, leading to a divergent signal-to-noise ratio, and eventually to a violation of the Korotkov-Averin bound in quantum measurement. Our study offers the possibility for a double dot detector to reach the quantum limited effectiveness in a transparent manner.
Electron spin s in semiconductor quantum dot s have been intensively studied for implementing quantum computation and high fidelity single and two qubit operation s have recently been achieved . Quantum teleportation is a three qubit protocol exploiting quantum entanglement and it serv es as a n essential primitive for more sophisticated quantum algorithm s Here, we demonstrate a scheme for quantum teleportation based on direct Bell measurement for a single electron spin qubit in a triple quantum dot utilizing the Pauli exclusion principle to create and detect maximally entangled state s . T he single spin polarization is teleported from the input qubit to the output qubit with a fidelity of 0.9 1 We find this fidelity is primarily limited by singlet triplet mixing which can be improved by optimizing the device parameters Our results may be extended to quantum algorithms with a larger number of se miconductor spin qubit s
Quantum phase transitions (QPTs) in qubit systems are known to produce singularities in the entanglement, which could in turn be used to probe the QPT. Current proposals to measure the entanglement are challenging however, because of their nonlocal nature. Here we show that a double quantum dot coupled locally to a spin chain provides an alternative and efficient probe of QPTs. We propose an experiment to observe a QPT in a triple dot, based on the well-known singlet projection technique.
We propose a scheme based on using the singlet ground state of an electron spin pair in a double quantum dot nanostructure as a suitable set-up for detecting entanglement between electron spins via the measurement of an optimal entanglement witness. Using time-dependent gate voltages and magnetic fields the entangled spins are separated and coherently rotated in the quantum dots and subsequently detected at spin-polarized quantum point contacts. We analyze the coherent time evolution of the entangled pair and show that by counting coincidences in the four exits an entanglement test can be done. This set-up is close to present-day experimental possibilities and can be used to produce pairs of entangled electrons ``on demand.
We investigate qubit measurements using a single electron transistor (SET). Applying the Schrodinger equation to the entire system we find that an asymmetric SET is considerably more efficient than a symmetric SET. The asymmetric SET becomes close to an ideal detector in the large asymmetry limit. We also compared the SET detector with a point-contact detector. This comparison allows us to illuminate the relation between information gain in the measurement process and the decoherence generated by these measurement devices.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
