Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userCaCu_3Ti_4O_12/CaTiO_3 Composite Dielectrics: A Ba/Pb-free Ceramics with High Dielectric Constants
98
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We have measured dielectric properties of Ca$_{1+x}$Cu$_{3-x}$Ti$_4$O$_{12}$ ($x$ = 0, 0.1, 0.5, 1, 1.5, 2, 2.9 and 3), and have found that Ca$_2$Cu$_2$Ti$_4$O$_{12}$ (a composite of CaCu$_3$Ti$_4$O$_{12}$ and CaTiO$_3$) exhibits a high dielectric constant of 1800 with a low dissipation factor of 0.02 below 100 kHz from 220 to 300 K. These are comparable to (or even better than) those of the Pb/Ba-based ceramics, which could be attributed to a barrier layer of CaTiO$_3$ on the surface of the CaCu$_3$Ti$_4$O$_{12}$ grains. The composite dielectric ceramics reported here are environmentally benign as they do not contain Ba/Pb.
rate research
Read More
A correlation between structure and vibrational properties related to a ferroelectric to paraelectric phase transition in perovskite Pb(1-x)(Na0.5Sm0.5)xTiO3 (PNST - x) polycrystalline powders is discussed. Substitution leads to reduction of tetragonality which is associated with a shift of the phase transition to lower temperatures. The nature of the phase transition gets diffused with increasing substitution.
The recent quest for improved functional materials like high permittivity dielectrics and/or multiferroics has triggered an intense wave of research. Many materials have been checked for their dielectric permittivity or their polarization state. In this report, we call for caution when samples are simultaneously displaying insulating behavior and defect-related conductivity. Many oxides containing mixed valent cations or oxygen vacancies fall in this category. In such cases, most of standard experiments may result in effective high dielectric permittivity which cannot be related to ferroelectric polarization. Here we list few examples of possible discrepancies between measured parameters and their expected microscopic origin.
Silicate ceramics are of considerable promise as high frequency dielectrics in emerging millimetre wave applications including high bandwidth wireless communication and sensing. In this review, we show how high quality factors and low, thermally stable permittivities arise in ordered silicate structures. On the basis of a large number of existing studies, the dielectric performance of silicate ceramics is comprehensively summarized and presented, showing how microstructure and SiO4 tetrahedral connectivity affect polarizability and dielectric losses. We critically examine the appropriateness of silicate materials in future applications as effective millimetre wave dielectrics with low losses and tuneable permittivities. The development of new soft chemistry based processing routes for silicate dielectric ceramics is identified as being instrumental towards the reduction of processing temperatures, thus enabling silicate ceramics to be co-fired in the production of components functioning in the mm wave regime.
Dielectric and magnetic properties of Eu0.5Ba0.25Sr0.25TiO3 are investigated between 10 K and 300 K in the frequency range from 10 Hz to 100 THz. A peak in permittivity revealed near 130 K and observed ferroelectric hysteresis loops prove the ferroelectric order below thistemperature. The peak in permittivity is given mainly by softening of the lowest frequency polar phonon (soft mode revealed in THz and IR spectra) that demonstrates displacive character of the phase transition. Room-temperature X-ray diffraction analysis reveals cubic structure, but the IR reflectivity spectra give evidence of a lower crystal structure, presumably tetragonal I4/mcm with tilted oxygen octahedra as it has been observed in EuTiO3. The magnetic measurements show that the antiferromagnetic order occurs below 1.8 K. Eu0.5Ba0.25Sr0.25TiO3 has three times lower coercive field than Eu0.5Ba0.5TiO3, therefore we propose this system for measurements of electric dipole moment of electron.
The state of art in the theoretical and experimental studies of transition metal doped oxides (dilute magnetic dielectrics) is reviewed. The available data show that the generic non-equilibrium state of oxide films doped with magnetic impurities may either favor ferromagnetism with high Curie temperature or result in highly inhomogeneous state without long-range magnetic order. In both case concomitant defects (vacancies, interstitial ions play crucial part.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
