Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userDielectric and polarization experiments in high loss dielectrics: a word of caution
134
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
The recent quest for improved functional materials like high permittivity dielectrics and/or multiferroics has triggered an intense wave of research. Many materials have been checked for their dielectric permittivity or their polarization state. In this report, we call for caution when samples are simultaneously displaying insulating behavior and defect-related conductivity. Many oxides containing mixed valent cations or oxygen vacancies fall in this category. In such cases, most of standard experiments may result in effective high dielectric permittivity which cannot be related to ferroelectric polarization. Here we list few examples of possible discrepancies between measured parameters and their expected microscopic origin.
rate research
Read More
We have measured dielectric properties of Ca$_{1+x}$Cu$_{3-x}$Ti$_4$O$_{12}$ ($x$ = 0, 0.1, 0.5, 1, 1.5, 2, 2.9 and 3), and have found that Ca$_2$Cu$_2$Ti$_4$O$_{12}$ (a composite of CaCu$_3$Ti$_4$O$_{12}$ and CaTiO$_3$) exhibits a high dielectric constant of 1800 with a low dissipation factor of 0.02 below 100 kHz from 220 to 300 K. These are comparable to (or even better than) those of the Pb/Ba-based ceramics, which could be attributed to a barrier layer of CaTiO$_3$ on the surface of the CaCu$_3$Ti$_4$O$_{12}$ grains. The composite dielectric ceramics reported here are environmentally benign as they do not contain Ba/Pb.
Dielectric loss from two-level states is shown to be a dominant decoherence source in superconducting quantum bits. Depending on the qubit design, dielectric loss from insulating materials or the tunnel junction can lead to short coherence times. We show that a variety of microwave and qubit measurements are well modeled by loss from resonant absorption of two-level defects. Our results demonstrate that this loss can be significantly reduced by using better dielectrics and fabricating junctions of small area $lesssim 10 mu textrm{m}^2$. With a redesigned phase qubit employing low-loss dielectrics, the energy relaxation rate has been improved by a factor of 20, opening up the possibility of multi-qubit gates and algorithms.
We report observation of magneto-electric and magneto-dielectric couplings in ceramic Co3TeO6. Temperature dependent DC magnetization and dielectric constant measurements together indicate coupling between magnetic order and electronic polarization. Strong anomaly in dielectric constant at ~ 18K in zero magnetic field indicates presence of spontaneous polarization. Observations like weak ferromagnetic order at lower temperature, field and temperature dependences of the ferroelectric transition provide experimental verification of the recent theoretical proposal by P. Toledano et al., Phys. Rev. B 85, 214439 (2012). We provide direct evidence of spin-phonon coupling as possible origin of magnetic order.
Recently it has been demonstrated that a careful treatment of both longitudinal and transverse matrix elements in electron energy loss spectra can explain the mystery of relativistic effects on the {it magic angle}. Here we show that there is an additional correction of order $(Zalpha)^2$ where $Z$ is the atomic number and $alpha$ the fine structure constant, which is not necessarily small for heavy elements. Moreover, we suggest that macroscopic electrodynamic effects can give further corrections which can break the sample-independence of the magic angle.
We carry out first-principles calculations of the nonlinear dielectric response of short-period ferroelectric superlattices. We compute and store not only the total polarization, but also the Wannier-based polarizations of individual atomic layers, as a function of electric displacement field, and use this information to construct a model capable of predicting the nonlinear dielectric response of an arbitrary superlattice sequence. We demonstrate the successful application of our approach to superlattices composed of SrTiO$_3$, CaTiO$_3$, and BaTiO$_3$ layers.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
