Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userThe Payload Data Handling Unit (PDHU) on-board the HERMES-TP and HERMES-SP CubeSat Missions
110
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
The High Energy Rapid Modular Ensemble of Satellites (HERMES) Technological and Scientific pathfinder is a space borne mission based on a constellation of LEO nanosatellites. The payloads of these CubeSats consist of miniaturized detectors designed for bright high-energy transients such as Gamma-Ray Bursts (GRBs). This platform aims to impact Gamma Ray Burst (GRB) science and enhance the detection of Gravitational Wave (GW) electromagnetic counterparts. This goal will be achieved with a field of view of several steradians, arcmin precision and state of the art timing accuracy. The localization performance for the whole constellation is proportional to the number of components and inversely proportional to the average baseline between them, and therefore is expected to increase as more. In this paper we describe the Payload Data Handling Unit (PDHU) for the HERMES-TP and HERMES SP mission. The PDHU is the main interface between the payload and the satellite bus. The PDHU is also in charge of the on-board control and monitoring of the scintillating crystal detectors. We will explain the TM/TC design and the distinct modes of operation. We also discuss the on-board data processing carried out by the PDHU and its impact on the output data of the detector.
rate research
Read More
HERMES (High Energy Rapid Modular Ensemble of Satellites) Technological and Scientific pathfinder is a space borne mission based on a LEO constellation of nano-satellites. The 3U CubeSat buses host new miniaturized detectors to probe the temporal emission of bright high-energy transients such as Gamma-Ray Bursts (GRBs). Fast transient localization, in a field of view of several steradians and with arcmin-level accuracy, is gained by comparing time delays among the same event detection epochs occurred on at least 3 nano-satellites. With a launch date in 2022, HERMES transient monitoring represents a keystone capability to complement the next generation of gravitational wave experiments. In this paper we will illustrate the HERMES payload design, highlighting the technical solutions adopted to allow a wide-energy-band and sensitive X-ray and gamma-ray detector to be accommodated in a CubeSat 1U volume together with its complete control electronics and data handling system.
HERMES (High Energy Rapid Modular Ensemble of Satellites) is an innovative mission aiming to observe transient high-energy events such as gamma-ray bursts (GRBs) through a constellation of CubeSats hosting a broadband X and gamma-ray detector. The detector is based on a solid-state Silicon Drift Detector (SDD) coupled to a scintillator crystal, and is sensitive in the 2 keV to 2 MeV band. An accurate evaluation of the foreseen in-orbit instrumental background is essential to assess the scientific performance of the experiment. An outline of the Monte Carlo simulations of the HERMES payload will be provided, describing the various contributions on the total background and the optimization strategies followed in the instrument design. Moreover, the simulations were used in order to derive the effective area and response matrices of the instrument, also as a function of the source location with respect to the detector frame of reference.
To asses stability against 1/f noise, the Low Frequency Instrument (LFI) onboard the Planck mission will acquire data at a rate much higher than the data rate allowed by its telemetry bandwith of 35.5 kbps. The data are processed by an onboard pipeline, followed onground by a reversing step. This paper illustrates the LFI scientific onboard processing to fit the allowed datarate. This is a lossy process tuned by using a set of 5 parameters Naver, r1, r2, q, O for each of the 44 LFI detectors. The paper quantifies the level of distortion introduced by the onboard processing, EpsilonQ, as a function of these parameters. It describes the method of optimizing the onboard processing chain. The tuning procedure is based on a optimization algorithm applied to unprocessed and uncompressed raw data provided either by simulations, prelaunch tests or data taken from LFI operating in diagnostic mode. All the needed optimization steps are performed by an automated tool, OCA2, which ends with optimized parameters and produces a set of statistical indicators, among them the compression rate Cr and EpsilonQ. For Planck/LFI the requirements are Cr = 2.4 and EpsilonQ <= 10% of the rms of the instrumental white noise. To speedup the process an analytical model is developed that is able to extract most of the relevant information on EpsilonQ and Cr as a function of the signal statistics and the processing parameters. This model will be of interest for the instrument data analysis. The method was applied during ground tests when the instrument was operating in conditions representative of flight. Optimized parameters were obtained and the performance has been verified, the required data rate of 35.5 Kbps has been achieved while keeping EpsilonQ at a level of 3.8% of white noise rms well within the requirements.
The HERMES-TP/SP mission, based on a nanosatellite constellation, has very stringent constraints of sensitivity and compactness, and requires an innovative wide energy range instrument. The instrument technology is based on the siswich concept, in which custom-designed, low-noise Silicon Drift Detectors are used to simultaneously detect soft X-rays and to readout the optical light produced by the interaction of higher energy photons in GAGG:Ce scintillators. To preserve the inherent excellent spectroscopic performances of SDDs, advanced readout electronics is necessary. In this paper, the HERMES detector architecture concept will be described in detail, as well as the specifically developed front-end ASICs (LYRA-FE and LYRA-BE) and integration solutions. The experimental performance of the integrated system composed by scintillator+SDD+LYRA ASIC will be discussed, demonstrating that the requirements of a wide energy range sensitivity, from 2 keV up to 2 MeV, are met in a compact instrument.
The High Energy Modular Ensemble of Satellites (HERMES) project is aimed to realize a modular X/gamma-ray monitor for transient events, to be placed on-board of a CubeSat bus. This expandable platform will achieve a significant impact on Gamma Ray Burst (GRB) science and on the detection of Gravitational Wave (GW) electromagnetic counterparts: the recent LIGO/VIRGO discoveries demonstrated that the high-energy transient sky is still a field of extreme interest. The very complex temporal variability of GRBs (up to the millisecond scale) combined with the spatial and temporal coincidence between GWs and their electromagnetic counterparts suggest that upcoming instruments require sub-ms time resolution combined with a transient localization accuracy lower than a degree. The current phase of the ongoing HERMES project is focused on the realization of a technological pathfinder with a small network (3 units) of nano-satellites to be launched in mid 2020. We will show the potential and prospects for short and medium-term development of the project, demonstrating the disrupting possibilities for scientific investigations provided by the innovative concept of a new modular astronomy with nano-satellites (e.g. low developing costs, very short realization time). Finally, we will illustrate the characteristics of the HERMES Technological Pathfinder project, demonstrating how the scientific goals discussed are actually already reachable with the first nano-satellites of this constellation. The detector architecture will be described in detail, showing that the new generation of scintillators (e.g. GAGG:Ce) coupled with very performing Silicon Drift Detectors (SDD) and low noise Front-End-Electronics (FEE) are able to extend down to few keV the sensitivity band of the detector. The technical solutions for FEE, Back-End-Electronics (BEE) and Data Handling will be also described.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
