Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userHigh-Curie-temperature ferromagnetism in bilayer CrI3 on bulk semiconducting substrates
109
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Two-dimensional (2D) ferromagnetic (FM) semiconductors with high Curie temperature have long been pursued for electronic and spintronic applications. Here we provide a general strategy to achieve robust FM state in bilayer CrI3 of the monoclinic stacking, which intrinsically has interlayer antiferromagnetic (AFM) order and weak in-plane FM coupling. We showed that the proximity effect from bulk semiconducting substrates induces electronic doping and significantly increases the FM nearest-neighbor exchange for bilayer CrI3, leading to the AFM-to-FM transition for the interlayer spin configuration as well as enhanced intralayer FM coupling. By first-principles calculations and Monte Carlo simulations, bulk and 2D semiconductors providing different interaction strengths from strong covalent bonding to weak van der Waals (vdW) interaction with CrI3 are compared to thoroughly address the substrate effect on magnetic behavior and Curie temperature of bilayer CrI3. These theoretical results offer a facile route for direct synthesis of 2D ferromagnets on proper semiconducting substrates to achieve high Curie temperature for device implementation.
rate research
Read More
Two-dimensional (2D) ferromagnets with high Curie temperature have long been the pursuit for electronic and spintronic applications. CrI3 is a rising star of intrinsic 2D ferromagnets, however, it suffers from weak exchange coupling. Here we propose a general strategy of self-intercalation to achieve enhanced ferromagnetism in bilayer CrI3. We showed that filling either Cr or I atoms into the van der Waals gap of stacked and twisted CrI3 bilayers can induce the double exchange effect and significantly strengthen the interlayer ferromagnetic coupling. According to our first-principles calculations, the intercalated native atoms act as covalent bridge between two CrI3 layers and lead to discrepant oxidation states for the Cr atoms. These theoretical results offer a facile route to achieve high-Curie-temperature 2D magnets for device implementation.
Wurtzite GaN:Mn films on sapphire substrates were successfully grown by use of the molecular beam epitaxy (MBE) system. The film has an extremely high Curie temperature of around 940 K, although the Mn concentration is only about 3 ~ 5 %. Magnetization measurements were carried out in magnetic fields parallel to the film surface up to 7 T. The magnetization process shows the coexistence of ferromagnetic and paramagnetic contributions at low temperatures, while the typical ferromagnetic magnetization process is mainly observed at high temperatures because of the decrease of the paramagnetic contributions. The observed transport characteristics show a close relation between the magnetism and the impurity conduction. The double exchange mechanism of the Mn-impurity band is one of the possible models for the high-TC ferromagnetism in GaN:Mn.
The nature of the often reported room temperature ferromagnetism in transition metal doped oxides is still a matter of huge debate. Herein we report on room temperature ferromagnetism in high quality Co-doped ZnO (Zn1-xCoxO) bulk samples synthesized via standard solid-state reaction route. Reference paramagnetic Co-doped ZnO samples with low level of structural defects are subjected to heat treatments in a reductive atmosphere in order to introduce defects in the samples in a controlled way. A detailed structural analysis is carried out in order to characterize the induced defects and their concentration. The magnetometry revealed the coexistence of a paramagnetic and a ferromagnetic phase at room temperature in straight correlation with the structural properties. The saturation magnetization is found to increase with the intensification of the heat treatment, and, therefore, with the increase of the density of induced defects. The magnetic behavior is fully explained in terms of the bound magnetic polaron model. Based on the experimental findings, supported by theoretical calculations, we attribute the origin of the observed defect-induced-ferromagnetism to the ferromagnetic coupling between the Co ions mediated by magnetic polarons due to zinc interstitial defects.
Atomically thin transition metal dichalcogenide (TMD) semiconductors hold enormous potential for modern optoelectronic devices and quantum computing applications. By inducing long-range ferromagnetism (FM) in these semiconductors through the introduction of small amounts of a magnetic dopant, it is possible to extend their potential in emerging spintronic applications. Here, we demonstrate light-mediated, room temperature (RT) FM, in V-doped WS2 (V-WS2) monolayers. We probe this effect using the principle of magnetic LC resonance, which employs a soft ferromagnetic Co-based microwire coil driven near its resonance in the radio frequency (RF) regime. The combination of LC resonance with an extraordinary giant magneto-impedance effect, renders the coil highly sensitive to changes in the magnetic flux through its core. We then place the V-WS2 monolayer at the core of the coil where it is excited with a laser while its change in magnetic permeability is measured. Notably, the magnetic permeability of the monolayer is found to depend on the laser intensity, thus confirming light control of RT magnetism in this two-dimensional (2D) material. Guided by density functional calculations, we attribute this phenomenon to the presence of excess holes in the conduction and valence bands, as well as carriers trapped in the magnetic doping states, which in turn mediates the magnetization of the V-WS2 monolayer. These findings provide a unique route to exploit light-controlled ferromagnetism in low powered 2D spintronic devices capable of operating at RT.
Diverse interlayer tunability of physical properties of two-dimensional layers mostly lies in the covalent-like quasi-bonding that is significant in electronic structures but rather weak for energetics. Such characteristics result in various stacking orders that are energetically comparable but may significantly differ in terms of electronic structures, e.g. magnetism. Inspired by several recent experiments showing interlayer anti-ferromagnetically coupled CrI3 bilayers, we carried out first-principles calculations for CrI3 bilayers. We found that the anti-ferromagnetic coupling results from a new stacking order with the C2/m space group symmetry, rather than the graphene-like one with R3 as previously believed. Moreover, we demonstrated that the intra- and inter-layer couplings in CrI3 bilayer are governed by two different mechanisms, namely ferromagnetic super-exchange and direct-exchange interactions, which are largely decoupled because of their significant difference in strength at the strong- and weak-interaction limits. This allows the much weaker interlayer magnetic coupling to be more feasibly tuned by stacking orders solely. Given the fact that interlayer magnetic properties can be altered by changing crystal structure with different stacking orders, our work opens a new paradigm for tuning interlayer magnetic properties with the freedom of stacking order in two dimensional layered materials.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
