Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userCoexistence of Superconductivity and Charge Density Wave in Tantalum Disulfide: Experiment and Theory
74
0
0.0
(
0
)
Added by
Mahmoud Abdel-Hafiez
Publication date
2020
fields
Physics
and research's language is
English
Ask ChatGPT about the research
No Arabic abstract
The coexistence of charge density wave (CDW) and superconductivity in tantalum disulfide (2H-TaS$_2$) at ambient pressure, is boosted by applying hydrostatic pressures up to 30GPa, thereby inducing a typical dome-shaped superconducting phase. The ambient pressure CDW ground state which begins at TCDW = 76 K, with critically small Fermi surfaces, was found to be fully suppressed at Pc = 8.7GPa. Around Pc, we observe a superconducting dome with a maximum superconducting transition temperature Tc = 9.1 K. First-principles calculations of the electronic structure predict that, under ambient conditions, the undistorted structure is characterized by a phonon instability at finite momentum close to the experimental CDW wave vector. Upon compression, this instability is found to disappear, indicating the suppression of CDW order. The calculations reveal an electronic topological transition (ETT), which occurs before the suppression of the phonon instability, suggesting that the ETT alone is not directly causing the structural change in the system. The temperature dependence of the first vortex penetration field has been experimentally obtained by two independent methods and the corresponding lower critical field H$_{c1}$ was deduced. While a d wave and single-gap BCS prediction cannot describe our H$_{c1}$ experiments, the temperature dependence of the H$_{c1}$ can be well described by a single-gap anisotropic s-wave order parameter.
rate research
Read More
We performed an optical spectroscopy measurement on single crystals of $mathrm{Ba_2Ti_2Fe_2As_4O}$, which is a newly discovered superconductor showing a coexistence of superconductivity and density wave order. The study reveals a spectral change related to the formation density wave energy gap below $T_{DW}approx$125 K, leading to the removal of about half of the multiple Fermi surface sheets. The ratio of 2$Delta_{DW}$/$k_B T_{DW}approx$ 11.9 is considerably larger than the mean-field value based on the weak-coupling BCS theory. At the lowest temperature in the superconducting state, we observed opening of superconducting energy gaps $Delta_1(0) =3.4$ meV and $Delta_2(0)=7.9$ meV. The properties of superconducting state in $mathrm{Ba_2Ti_2Fe_2As_4O}$ are similar to that in $mathrm{BaFe_{1.85}Co_{0.15}As_2}$.
We report on switching among three charge-density-wave phases - commensurate, nearly commensurate, incommensurate - and the high-temperature normal metallic phase in thin-film 1T-TaS2 devices induced by application of an in-plane electric field. The electric switching among all phases has been achieved over a wide temperature range, from 77 K to 400 K. The low-frequency electronic noise spectroscopy has been used as an effective tool for monitoring the transitions, particularly the switching from the incommensurate charge-density-wave phase to the normal metal phase. The noise spectral density exhibits sharp increases at the phase transition points, which correspond to the step-like changes in resistivity. Assignment of the phases is consistent with low-field resistivity measurements over the temperature range from 77 K to 600 K. Analysis of the experimental data and calculations of heat dissipation suggest that Joule heating plays a dominant role in the electric-field induced transitions in the tested 1T-TaS2 devices on Si/SiO2 substrates. The possibility of electrical switching among four different phases of 1T-TaS2 is a promising step toward nanoscale device applications. The results also demonstrate the potential of noise spectroscopy for investigating and identifying phase transitions in materials.
Here we report a systematic investigation on the evolution of the structural and physical properties, including the charge density wave and superconductivity of the polycrystalline CuIr2Te4-xIx. X-ray diffraction results indicate that both of a and c lattice parameters increase linearly. The resistivity measurements indicate that the charge density wave is destabilized with slight x but reappears when x is large than 0.9. Meanwhile, the superconducting transition temperature enhances as x raises and reaches a maximum value of around 2.95 K for the optimal composition CuIr2Te3.9I0.1 followed by a slight decrease with higher iodine doping content. The specific heat jump for the optimal composition CuIr2Te3.9I0.1 is approximately 1.46, which is close to the Bardeen Cooper Schrieffer value which is 1.43, indicating it is a bulk superconductor. The results of thermodynamic heat capacity measurements under different magnetic fields, magnetization and magneto-transport measurements further suggest that CuIr2Te4-xIx bulks are type II superconductors. Finally, an electronic phase diagram for this CuIr2Te4-xIx system has been constructed. The present study provides a suitable material platform for further investigation of the interplay of the CDW and superconductivity.
Charge density wave (CDW), the periodic modulation of the electronic charge density, will open a gap on the Fermi surface that commonly leads to decreased or vanishing conductivity. On the other hand superconductivity, a commonly believed competing order, features a Fermi surface gap that results in infinite conductivity. Here we report that superconductivity emerges upon Se doping in CDW conductor ZrTe$_{3}$ when the long range CDW order is gradually suppressed. Superconducting critical temperature $T_c(x)$ in ZrTe$_{3-x}$Se$_x$ (${0leq}xleq0.1$) increases up to 4 K plateau for $0.04$$leq$$x$$leq$$0.07$. Further increase in Se content results in diminishing $T_{c}$ and filametary superconductivity. The CDW modes from Raman spectra are observed in $x$ = 0.04 and 0.1 crystals, where signature of ZrTe$_{3}$ CDW order in resistivity vanishes. The electronic-scattering for high $T_{c}$ crystals is dominated by local CDW fluctuations at high temperures, the resistivity is linear up to highest measured $T=300K$ and contributes to substantial in-plane anisotropy.
We systematically investigated the superconducting properties and the interplay between charge-density-waves (CDW) and superconductivity in lithium-intercalated 2H-TaS2. By gradually increasing the lithium content x, the CDW formation temperature is continuously suppressed, and the onset temperature of superconductivity is increased with a maximum transition temperature Tc = 3.5 K for x = 0.096. The bulk nature of superconductivity is confirmed by a superconducting shielding fraction of the order of unity for this composition. The electronic contribution to the specific heat and Hall resistivity data demonstrate that the CDW weakens with lithium-intercalation, thereby indirectly increasing carrier density and boosting superconductivity. While the sign of the charge carriers in undoped 2H-TaS2 changes from electron-like to hole type near the CDW formation temperature around 75 K, the lithium intercalated LixTaS2 show predominantly hole-type carriers in the CDW phase even for very low lithium contents.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
