Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userFluorescent diamond microparticles doped glass fiber for magnetic field sensing
85
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Diamond containing the negatively charged nitrogen-vacancy (NV) center is emerging as a significant new system for magnetometry. However, most NV sensors require microscopes to collect the fluorescence signals and are therefore limited to laboratory settings. By incorporating micron-scale diamond particles at an annular interface within the cross section of a silicate glass fiber, a high-sensitivity and robust fiber platform for magnetic field sensing is demonstrated here. The fluorescence and spin properties of NV centers embedded in the diamond crystals are well preserved during the fiber drawing process, leading to enhanced continuous-wave diamond-magnetometry in fiber-transmitted sensing configurations. The interface doping of diamond particles also leads to reduced fiber propagation loss and benefits the guidance of NV-fluorescence in the hybrid fiber. Using the diamond-fiber system, magnetic field readout through 50 cm of fiber is achieved. This study paves the way for novel fiber-based diamond sensors for field-deployable quantum metrology applications.
rate research
Read More
Quantifying temperature variations at the micron scale can provide new opportunities in optical sensing. In this paper, we present a novel approach using the temperature-dependent variations in fluorescence of rare-earth doped tellurite glass to provide a micron-scale image of temperature variations over a 200 micrometre field of view. We demonstrate the system by monitoring the evaporation of a water droplet and report a net temperature change of 7.04 K with a sensitivity of at least 0.12 K. These results establish the practicality of this confocal-based approach to provide high-resolution marker-free optical temperature sensing.
We demonstrate the application of a fiber-coupled quantum-dot-in-a-tip as a probe for scanning electric field microscopy. We map the out-of-plane component of the electric field induced by a pair of electrodes by measurement of the quantum-confined Stark effect induced on a quantum dot spectral line. Our results are in agreement with finite element simulations of the experiment. Furthermore, we present results from analytic calculations and simulations which are relevant to any electric field sensor embedded in a dielectric tip. In particular, we highlight the impact of the tip geometry on both the resolution and sensitivity.
Understanding nano- and micro-scale crystal strain in CVD diamond is crucial to the advancement of diamond quantum technologies. In particular, the presence of such strain and its characterization present a challenge to diamond-based quantum sensing and information applications -- as well as for future dark matter detectors where directional information of incoming particles is encoded in crystal strain. Here, we exploit nanofocused scanning X-ray diffraction microscopy to quantitatively measure crystal deformation from growth defects in CVD diamond with high spatial and strain resolution. Combining information from multiple Bragg angles allows stereoscopic three-dimensional reconstruction of strained volumes; the diffraction results are validated via comparison to optical measurements of the strain tensor based on spin-state-dependent spectroscopy of ensembles of nitrogen vacancy (NV) centers in the diamond. Our results open a path towards directional detection of dark matter via X-ray measurement of crystal strain, and provide a new tool for diamond growth analysis and improvement of defect-based sensing.
The possibility of using Nitrogen-vacancy centers in diamonds to measure nanoscale magnetic fields with unprecedented sensitivity is one of the most significant achievements of quantum sensing. Here we present an innovative experimental set-up, showing an achieved sensitivity comparable to the state of the art ODMR protocols if the sensing volume is taken into account. The apparatus allows magnetic sensing in biological samples such as individual cells, as it is characterized by a small sensing volume and full bio-compatibility. The sensitivity at different optical powers is studied to extend this technique to the intercellular scale.
We report on the CEP stabilization of an Yb-doped fiber amplifier system delivering 30 microjoules, 100 fs pulses at 100 kHz repetition rate. A single shot, every shot, measurement of the CEP stability based on a simple f-2f interferometer is performed, yielding a CEP standard deviation of 320 mrad rms over 1 s. Long-term stability is also assessed, with 380 mrad measured over one hour. This level of performance is allowed by a hybrid architecture including a passively CEP-stabilized front-end based on difference frequency generation, and an active CEP stabilization loop for the fiber amplifier system, acting on a telecom-grade integrated LiNbO3 phase modulator. These results demonstrate the full compatibility of Yb-doped high repetition rate laser for attoscience.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
