Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userIdentification of point defects on Co-Ni co-doping in SnO$_{2}$ nanocrystals and their effect on the structural and optical properties
77
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Sn$_{0.97-y}$Co$_{0.03}$Ni$_{y}$O$_{2}$ (0 $leq y leq$ 0.04) nanocrystals, with average crystallite size in the range of 7.3 nm ($y$=0.00) to 5.6 nm ($y$=0.04), have been synthesized using pH-controlled chemical co-precipitation technique. The non-stoichiometric Sn related defects and the O related stoichiometric Frenkel defects arising in the nanocrystals because of co-doping have been identified and their effect on the structural and optical properties of the nanocrystals have been extensively studied. It has been observed, using XPS that on increasing the Ni co-doping concentration ($y$), the non-stoichiometric Sn defect Sn$_{text{Sn}}^{}$ increases in compensation of existing defect Sn$_{i}^{....}$ for $y$ = 0.00 nanocrystals. High resolution transmission electron microscopy (HR-TEM) also confirms the existence of Sn$_{text{Sn}}^{}$. Regarding the Frenkel defect, XPS results indicate that the concentration of $V_{text{O}}$ and O$_{i}$, manifested in the form of dangling bond related surface defect states,increases with increase in $y$. Temperature dependent magnetisation measurement of the nanocrystals confirm the charge state of $V_{text{O}}$. The point defects have been found to affect the structural properties in a way that distortion in octahedral geometry of complete Sn-O octahderon effectively reduces whereas distortion in the trigonal planar coordination geometry of O increases. The investigation of Urbach edge indicates an enhancement in the disorder in the nanocrystals on co-doping. The optical band gap of the nanocrystals has been found to be red shifted upto $y$=0.02 and then a gradual blue shift has been observed. A direct effect of the O related defect has been observed on the blue luminescence of the nanocrystals such that the spectral contribution of blue luminescence in the total emission intensity increases by 72% for $y$=0.04 as compared to $y$=0.00.
rate research
Read More
YBaCuFeO5 is one of the interesting multiferroic compounds, which exhibits magnetic ordering and dielectric anomaly above 200 K. Partial substitution of Fe with other magnetic and non-magnetic ion affects the magnetic and the structural properties of the system. We report detailed investigation of structural, magnetic and dielectric properties of YBaCuFe0.85M0.15O5 (M=Co, Ni and Ga). We observed that the partial replacement of Ni and Co in place of Fe, results in magnetic dilution and broadening of the magnetic transition and shifting towards lower temperature. The replacement of Fe with non-magnetic Ga also results in shifting of the magnetic transition to the lower temperature side. The observed dielectric relaxation behavior in these compounds is due to the charge carrier hoping. This study highlights the impacts of magnetic and non-magnetic doping at the magnetic site on magnetic and dielectric properties in layered perovskite compound YBaCuFeO5.
At certain compositions Ni-Mn-$X$ Heusler alloys ($X$: group IIIA-VA elements) undergo martensitic transformations, and many of them exhibit inverse magnetocaloric effects. In alloys where $X$ is Sn, the isothermal entropy change is largest among the Heusler alloys, particularly in Ni$_{50}$Mn$_{37}$Sn$_{13}$ where it reaches a value of 20 Jkg$^{-1}$K$^{-1}$ for a field of 5T. We substitute Ni with Fe and Co in this alloy, each in amounts of 1 at% and 3 at% to perturb the electronic concentration and examine the resulting changes in the magnetocaloric properties. Increasing both Fe and Co concentrations causes the martensitic transition temperature to decrease, whereby the substitution by Co at both compositions or substituting 1 at% Fe leads to a decrease in the magnetocaloric effect. On the other hand, the magnetocaloric effect in the alloy with 3 at% Fe leads to an increase in the value of the entropy change to about 30 Jkg$^{-1}$K$^{-1}$ at 5T.
We studied the structural and magnetic properties of FeC~thin films deposited by co-sputtering of Fe and C targets in a direct current magnetron sputtering (dcMS) process at a substrate temperature (Ts) of 300, 523 and 773,K. The structure and morphology was measured using x-ray diffraction (XRD), x-ray absorption near edge spectroscopy (XANES) at Fe $L$ and C $K$-edges and atomic/magnetic force microscopy (AFM, MFM), respectively. An ultrathin (3,nm) $^{57}$FeC~layer, placed between relatively thick FeC~layers was used to estimate Fe self-diffusion taking place during growth at different Ts~using depth profiling measurements. Such $^{57}$FeC~layer was also used for $^{57}$Fe conversion electron M{o}ssbauer spectroscopy (CEMS) and nuclear resonance scattering (NRS) measurements, yielding the magnetic structure of this ultrathin layer. We found from XRD measurements that the structure formed at low Ts~(300,K) is analogous to Fe-based amorphous alloy and at high Ts~(773,K), pre-dominantly a tifc~phase has been formed. Interestingly, at an intermediate Ts~(523,K), a clear presence of tefc~(along with tifc~and Fe) can be seen from the NRS spectra. The microstructure obtained from AFM images was found to be in agreement with XRD results. MFM images also agrees well with NRS results as the presence of multi-magnetic components can be clearly seen in the sample grown at Ts~= 523,K. The information about the hybridization between Fe and C, obtained from Fe $L$ and C $K$-edges XANES also supports the results obtained from other measurements. In essence, from this work, experimental realization of tefc~has been demonstrated. It can be anticipated that by further fine-tuning the deposition conditions, even single phase tefc~phase can be realized which hitherto remains an experimental challenge.
We present a detailed theoretical investigation on the magnetic properties of small single-layered Fe, Co and Ni clusters deposited on Ir(111), Pt(111) and Au(111). For this a fully relativistic {em ab-initio} scheme based on density functional theory has been used. We analyse the element, size and geometry specific variations of the atomic magnetic moments and their mutual exchange interactions as well as the magnetic anisotropy energy in these systems. Our results show that the atomic spin magnetic moments in the Fe and Co clusters decrease almost linearly with coordination on all three substrates, while the corresponding orbital magnetic moments appear to be much more sensitive to the local atomic environment. The isotropic exchange interaction among the cluster atoms is always very strong for Fe and Co exceeding the values for bulk bcc Fe and hcp Co, whereas the anisotropic Dzyaloshinski-Moriya interaction is in general one or two orders of magnitude smaller when compared to the isotropic one. For the magnetic properties of Ni clusters the magnetic properties can show quite a different behaviour and we find in this case a strong tendency towards noncollinear magnetism.
We have investigated the Vanadium- (V) substituted Ni-Zn-Co ferrites where the samples were prepared using solid-state reaction technique. The impact of V5+ substitution on the structural, magnetic, dielectric and electrical properties of Ni-Zn-Co ferrites has been studied. XRD analysis confirmed the formation of a single-phase cubic spinel structure. The lattice constants have been calculated both theoretically and experimentally along with other structural parameters such as bulk density, X-ray density and porosity. The FESEM images are taken to study the surface morphology. FTIR measurement is also performed which confirms spinel structure formation. The saturation magnetization (Ms), coercive field (Hc) and Bohr magneton (B) were calculated from the obtained M-H loops. The temperature dependent permeability is studied to obtain the Curie temperature. Frequency and composition dependence of permeability was also analyzed. Dielectric behavior and ac resistivity are also subjected to investigate the frequency dependency. An inverse relationship was observed between the composition dependence of dielectric constant and ac resistivity. The obtained results such as the electrical resistivity, dielectric constants and magnetic properties suggest the appropriateness of the studied ferrites in microwave device applications.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
