Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userEffects of microstructure and growth conditions on quantum emitters in Gallium Nitride
119
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Single-photon emitters in gallium nitride (GaN) are gaining interest as attractive quantum systems due to the well-established techniques for growth and nanofabrication of the host material, as well as its remarkable chemical stability and optoelectronic properties. We investigate the nature of such single-photon emitters in GaN with a systematic analysis of various samples produced under different growth conditions. We explore the effect that intrinsic structural defects (dislocations and stacking faults), doping and crystal orientation in GaN have on the formation of quantum emitters. We investigate the relationship between the position of the emitters (determined via spectroscopy and photoluminescence measurements) and the location of threading dislocations (characterised both via atomic force microscopy and cathodoluminescence). We find that quantum emitters do not correlate with stacking faults or dislocations; instead, they are more likely to originate from point defects or impurities whose density is modulated by the local extended defect density.
rate research
Read More
Nanoscale optical thermometry is a promising non-contact route for measuring local temperature with both high sensitivity and spatial resolution. In this work, we present a deterministic optical thermometry technique based on quantum emitters in nanoscale hexagonal boron-nitride. We show that these nanothermometers exhibit better performance than that of homologous, all-optical nanothermometers both in sensitivity and range of working temperature. We demonstrate their effectiveness as nanothermometers by monitoring the local temperature at specific locations in a variety of custom-built micro-circuits. This work opens new avenues for nanoscale temperature measurements and heat flow studies in miniaturized, integrated devices.
Indium gallium nitride films with nanocolumnar microstructure were deposited with varying indium content and substrate temperatures using plasma-enhanced evaporation on amorphous SiO2 substrates. FESEM and XRD results are presented, showing that more crystalline nanocolumnar microstructures can be engineered at lower indium compositions. Nanocolumn diameter and packing factor (void fraction) was found to be highly dependent on substrate temperature, with thinner and more closely packed nanocolumns observed at lower substrate temperatures.
Quantum technologies require robust and photostable single photon emitters (SPEs) that can be reliably engineered. Hexagonal boron nitride (hBN) has recently emerged as a promising candidate host to bright and optically stable SPEs operating at room temperature. However, the emission wavelength of the fluorescent defects in hBN has, to date, been shown to be uncontrolled. The emitters usually display a large spread of zero phonon line (ZPL) energies spanning over a broad spectral range (hundreds of nanometers), which hinders the potential development of hBN-based devices and applications. We demonstrate bottom-up, chemical vapor deposition growth of large-area, few layer hBN that hosts large quantities of SPEs: 100 per 10x10 {mu}m2. Remarkably, more than 85 percent of the emitters have a ZPL at (580{pm}10)nm, a distribution which is over an order of magnitude narrower than previously reported. Exploiting the high density and uniformity of the emitters, we demonstrate electrical modulation and tuning of the ZPL emission wavelength by up to 15 nm. Our results constitute a definite advancement towards the practical deployment of hBN single photon emitters in scalable quantum photonic and hybrid optoelectronic devices based on 2D materials.
Color centers in hexagonal boron nitride (hBN) have emerged as promising candidates for single-photon emitters (SPEs) due to their bright emission characteristics at room temperature. In contrast to mono- and few-layered hBN, color centers in multi-layered flakes show superior emission characteristics such as higher saturation counts and spectral stability. Here, we report a method for determining both the axial position and three-dimensional dipole orientation of SPEs in thick hBN flakes by tuning the photonic local density of states using vanadium dioxide (VO2), a phase change material. Emitters under study exhibit a strong surface-normal dipole orientation, providing some insight on the atomic structure of hBN SPEs, deeply embedded in thick crystals. We have optimized a hot pickup technique to reproducibly transfer flakes of hBN from VO2 onto SiO2/Si substrate and relocated the same emitters. Our approach serves as a practical method to systematically characterize SPEs in hBN prior to integration in quantum photonics systems.
The controlled growth of carbon nitride (CN) films with tailored electronic properties and surface area is quite challenging due to the solid-state reaction and the lack of efficient interaction between C-N monomers and substrates. Herein, controlled growth of CN films over robust carbon nanotubes (CNT) fiber fabric is reported, which is obtained by either direct calcination of melamine on their surface, that yields a bulk material, or by its chemical vapor deposition resulting in hybrid films. These materials are effective electrodes consisting of high surface-area CN containing CNT fiber fabrics acting as a scaffold and a highly conducting built-in current collector. The results confirm that CNTs act as nucleation centers for the formation of CN films, forming close contact at the CN/CNT interphase, and resulting in efficient charge transfer upon illumination and enhanced electrochemical surface area.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
