Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userUltrahigh Resolution Spectroscopy Across the Visible to Infrared Spectrum Using Multi-Mode Interference in a Compact Tapered Fiber
151
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Optical spectroscopy is a fundamental tool in numerous areas of science and technology. Much effort has focused on miniaturizing spectrometers, but thus far at the cost of high spectral resolution and broad operating range. Here, we describe a compact spectrometer without this trade-off. The device relies on imaging multi-mode interference from leaky modes along a highly multimode tapered optical fiber, resulting in spectrally distinguishable images that form a basis for reconstructing an incident light spectrum. This tapered fiber multimode interference spectrometer enables the acquisition of broadband spectra in a single camera exposure with a measured resolution of 40 pm in the visible spectrum and 10 pm in the infrared spectrum, which are comparable to the performance of grating spectrometers. Spectroscopy from 500 nm to 1600 nm is demonstrated, though operation across the entire transparency window of silica fibers is possible. Multimode interference spectroscopy of leaky modes is suitable in a variety of device geometries, including planar waveguides in a broad range of transparent materials. We anticipate that this technique will greatly expand the availability of high-performance spectroscopy in a wide range of applications.
rate research
Read More
We report supercontinuum generation by launching femtosecond Yb fiber laser pulses into a tapered single-mode fiber of 3 um core diameter. A spectrum of more than one octave, from 550 to 1400 nm, has been obtained with an output power of 1.3 W at a repetition rate of 250 MHz, corresponding to a coupling efficiency of up to 60%. By using a typical f-2f interferometer, the carrier envelope offset frequency was measured and found to have a signal-to-noise ratio of nearly 30 dB.
Tuneable ultrafast laser pulses are a powerful tool for measuring difficult-to-access degrees of freedom in materials science. In general these experiments require the ability to address resonances and excitations both above and below the bandgap of materials, and to probe their response at the timescale of the fastest non-trivial internal dynamics. This drives the need for ultrafast sources capable of delivering 10-15 fs duration pulses tuneable across the entire visible (VIS) and near infrared (NIR) range, 500 nm - 3000 nm, as well as the characterization of these sources. Here we present a single frequency-resolved optical gating (FROG) system capable of self-referenced characterization of pulses with 10 fs duration across the entire VIS-NIR spectral range. Our system does not require auxiliary beams and only minor reconfiguration for different wavelengths. We demonstrate the system with measurements of pulses across the entire tuning range.
We present an experimental and theoretical study of the energy transfer between modes during the tapering process of an optical nanofiber through spectrogram analysis. The results allow optimization of the tapering process, and we measure transmission in excess of 99.95% for the fundamental mode. We quantify the adiabaticity condition through calculations and place an upper bound on the amount of energy transferred to other modes at each step of the tapering, giving practical limits to the tapering angle.
We experimentally demonstrate that pumping a graded-index multimode fiber with sub-ns pulses from a microchip Nd:YAG laser leads to spectrally flat supercontinuum generation with a uniform bell-shaped spatial beam profile extending from the visible to the mid-infrared at 2500,nm. We study the development of the supercontinuum along the multimode fiber by the cut-back method, which permits us to analyze the competition between the Kerr-induced geometric parametric instability and stimulated Raman scattering. We also performed a spectrally resolved temporal analysis of the supercontinuum emission.
Ultrahigh-resolution fiber-optic sensing has been demonstrated with a meter-long, high-finesse fiber Fabry-Perot interferometer (FFPI). The main technical challenge of large, environment-induced resonance frequency drift is addressed by locking the interrogation laser to a similar meter-long FFPI, which, along with the FFPI sensor, is thermally and mechanically isolated from the ambient. A nominal, noise-limited strain resolution of 800 f{epsilon} /sqrt(Hz) has been achieved within 1 to 100 Hz. Strain resolution further improves to 75 f{epsilon} /sqrt(Hz) at 1 kHz, 60 f{epsilon} /sqrt(Hz) at 2 kHz and 40 f{epsilon} /sqrt(Hz) at 23 kHz, demonstrating comparable or even better resolutions than proven techniques such as {pi}-phase-shifted and slow-light fiber Bragg gratings. Limitations of the current system are analyzed and improvement strategies are presented. The work lays out a feasible path toward ultrahigh-resolution fiber-optic sensing based on long FFPIs.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
