Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userEfficient and mode selective spatial mode multiplexer based on Multi-Plane Light Conversion
135
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We designed and built a new type of spatial mode multiplexer, based on Multi-Plane Light Conversion (MPLC), with very low intrinsic loss and high mode selectivity. In this first demonstration we show that a typical 3-mode multiplexer achieves a mode selectivity better than -23 dB and a total insertion efficiency of -4.1 dB (optical coating improvements could increase efficiency to -2.4 dB), across the full C-band. Moreover this multiplexer is able to perform any mode conversion, and we demonstrate its performance for the first 6 eigenmodes of a few-mode fiber: LP$_{01}$, LP$_{11mathrm{a}}$, LP$_{11mathrm{b}}$, LP$_{02}$, LP$_{21mathrm{a}}$ and LP$_{21mathrm{b}}$.
rate research
Read More
Space Division Multiplexing (SMD) is a very attractive technique for addressing the ever-growing demands in transmission capacity by enabling the use of a new parameter textemdash space textemdash to increase the number of channels in multi-mode fibers. One key component to build a spatially multiplexed-based optical network is a spatial multiplexer and demultiplexer combining signals from multiple single-mode fibers into as many channels in a multi-mode fiber. In this article, we report the fabrication and characterization of a pair of 45-mode spatial multiplexer and demultiplexer saturating all the modes of a standard 50~$mu$m core graded-index (OM2) multi-mode fiber. The multiplexers are based on Multi-Plane Light Conversion (MPLC), a technique that enables the control of the transverse shape of the light by multiple reflections on specifically designed phase plates. We show that by using a separable variable basis of modes, such as Hermite-Gaussian (HG) modes, we are able to drastically reduce the number of reflections hence reducing the insertion losses and modal crosstalks. The multiplexers typically show an average 4~dB insertion loss and -28~dB cross-talk across the C band. Finally, we emphasize the use of this higher-order modes multiplexer to explore the propagation properties inside multi-mode fibers and more specifically the mode group crosstalks as well as the impact of fiber bending.
Hyperbolic Meta-Materials~(HMMs) are anisotropic materials with permittivity tensor that has both positive and negative eigenvalues. Here we report that by using a type II HMM as cladding material, a waveguide which only supports higher order modes can be achieved, while the lower order modes become leaky and are absorbed in the HMM cladding. This counter intuitive property can lead to novel application in optical communication and photonic integrated circuit. The loss in our HMM-Insulator-HMM~(HIH) waveguide is smaller than that of similar guided mode in a Metal-Insulator-Metal~(MIM) waveguide.
We propose a wavelength-mode sorter realized by multi-plane light conversion (MPLC). For the first time, to our best knowledge, wavelengths and spatial modes can be sorted simultaneously. We first demonstrate pure wavelength sorting by a series of phase masks, which could find applications in high-power wavelength beam combining (WBC) or coarse wavelength-division multiplexing (CWDM), for example. We then present a design of a 4-wavelength, 3-mode sorter using only 5 phase masks. Insertion loss (IL) and mode dependent loss (MDL) as low as 1.27 dB and 2.45 dB can be achieved, respectively.
In this work, we study the effect of beam deviation angle at the reception side and calculate the theoretical demultiplexed collected energy for up to 15 modes, investigating the influence of the ratio between incoming beam size and fundamental HG modes waist. We show this approach greatly enhances the collection efficiency, tolerating tip-tilt error of more than 3 times compared to a Gaussian beam alone. We also show that, depending on wait size, a trade-off between collection efficiency at small angles and maximum acceptance angle can be achieved.
Spatial resolution is one of the most important specifications of an imaging system. Recent results in quantum parameter estimation theory reveal that an arbitrarily small distance between two incoherent point sources can always be efficiently determined through the use of a spatial mode sorter. However, extending this procedure to a general object consisting of many incoherent point sources remains challenging, due to the intrinsic complexity of multi-parameter estimation problems. Here, we generalize the Richardson-Lucy (RL) deconvolution algorithm to address this challenge. We simulate its application to an incoherent confocal microscope, with a Zernike spatial mode sorter replacing the pinhole used in a conventional confocal microscope. We test different spatially incoherent objects of arbitrary geometry, and we find that the resolution enhancement of sorter-based microscopy is on average over 30% higher than that of a conventional confocal microscope using the standard RL deconvolution algorithm. Our method could potentially be used in diverse applications such as fluorescence microscopy and astronomical imaging.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
