Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userHeater induced thermal effects on the LTP dynamics
141
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
The STOC (Science and Technology Operations Centre) simulator of the LPF (LISA PathFinder) mission is intended to provide a validation tool for the mission operations tele-commanding chain, as well as for a deeper understanding of the underlying physical processes happening in the LTP (LISA Technology Package). Amongst the different physical effects that will appear onboard, temperature fluctuations in the Electrode Housing (EH) could generate disturbances on the interferometer (IFO) readouts, therefore they must be known and controlled. In this article we report on the latest progress in the analysis at IEEC of the LTP response to thermal signals injected by means of heaters. More specifically, we determine the transfer functions relating heat input signals to forces on the Test Masses (TMs) in the LTP frequency band, from 1 mHz to 30 mHz. A complete thermal model of the entire LPF spacecraft plus payload, elaborated and maintained at European Space Technology Center (ESTEC), was used to obtain temperature distributions in response to heat inputs at prescribed spots (heaters), which are later processed to calculate the associated dynamical effects on the Test Masses.
rate research
Read More
The OSE (Offline Simulations Environment) simulator of the LPF (LISA Pathfinder) mission is intended to simulate the different experiments to be carried out in flight. Amongst these, the thermal diagnostics experiments are intended to relate thermal disturbances and interferometer readouts, thereby allowing the subtraction of thermally induced interferences from the interferometer channels. In this paper we report on the modelling of these simulated experiments, including the parametrisation of different thermal effects (radiation pressure effect, radiometer effect) that will appear in the Inertial Sensor environment of the LTP (LISA Technology Package). We report as well how these experiments are going to be implemented in the LTPDA toolbox, which is a dedicated tool for LPF data analysis that will allow full traceability and reproducibility of the analysis thanks to complete recording of the processes.
The transient phenomena produced in solid noble gases by the stopping of the recoils resulting from the elastic scattering processes of WIMPs from the galactic halo were modelled, as dependencies of the temperatures of lattice and electronic subsystems on the distance to the recoils trajectory, and time from its passage. The peculiarities of these thermal transients produced in Ar, Kr and Xe were analysed for different initial temperatures and WIMP energies, and were correlated with the characteristics of the targets and with the energy loss of the recoils. The results were compared with the thermal spikes produced by the same WIMPs in Si and Ge. In the range of the energy of interest, up to tens of keV for the self-recoil, local phase transitions solid - liquid and even liquid - gas were found possible, and the threshold parameters were established.
The proposed space-borne laser interferometric gravitational wave (GW) observatory TianQin adopts a geocentric orbit for its nearly equilateral triangular constellation formed by three identical drag-free satellites. The geocentric distance of each satellite is $approx 1.0 times 10^{5} ~mathrm{km}$, which makes the armlengths of the interferometer be $approx 1.73 times 10^{5} ~mathrm{km}$. It is aimed to detect the GWs in $0.1 ~mathrm{mHz}-1 ~mathrm{Hz}$. For space-borne detectors, the armlengths are unequal and change continuously which results in that the laser frequency noise is nearly $7-8$ orders of magnitude higher than the secondary noises (such as acceleration noise, optical path noise, etc.). The time delay interferometry (TDI) that synthesizes virtual interferometers from time-delayed one-way frequency measurements has been proposed to suppress the laser frequency noise to the level that is comparable or below the secondary noises. In this work, we evaluate the performance of various data combinations for both first- and second-generation TDI based on the five-year numerically optimized orbits of the TianQins satellites which exhibit the actual rotating and flexing of the constellation. We find that the time differences of symmetric interference paths of the data combinations are $sim 10^{-8}$ s for the first-generation TDI and $sim 10^{-12}$ s for the second-generation TDI, respectively. While the second-generation TDI is guaranteed to be valid for TianQin, the first-generation TDI is possible to be competent for GW signal detection with improved stabilization of the laser frequency noise in the concerned GW frequencies.
Advanced laser interferometer gravitational-wave detectors use high laser power to achieve design sensitivity. A small part of this power is absorbed in the interferometer cavity mirrors where it creates thermal lenses, causing aberrations in the main laser beam that must be minimized by the actuation of ring heaters, which are additional heater elements that are aimed to reduce the temperature gradients in the mirrors. In this article we derive the first, to the best of our knowledge, analytical model of the temperature field generated by an ideal ring heater. We express the resulting optical aberration contribution to the main laser beam in this axisymmetric case. Used in conjunction with wavefront measurements, our model provides a more complete understanding of the thermal state of the cavity mirrors and will allow a more efficient use of the ring heaters in the Advanced Laser Interferometer Gravitational-wave Observatory.
Advanced LIGO and the next generation of ground-based detectors aim to capture many more binary coalescences through improving sensitivity and duty cycle. Earthquakes have always been a limiting factor at low frequency where neither the pendulum suspension nor the active controls provide sufficient isolation to the test mass mirrors. Several control strategies have been proposed to reduce the impact of teleseismic events by switching to a robust configuration with less aggressive feedback. The continental United States has witnessed a huge increase in the number of induced earthquake events primarily associated with hydraulic fracking-related waste water re-injection. Effects from these differ from teleseismic earthquakes primarily because of their depth which is in turn linked to their triggering mechanism. In this paper, we discuss the impact caused due to these low magnitude regional earthquakes and explore ways to minimize the impact of induced seismicity on the detector.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
