Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userArtificial and self-assembled pinning centers in Ba(Fe1-xCox)2As2 thin films as a route to very high current density
165
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We report on the superior vortex pinning of single and multilayer Ba(Fe1-xCox)2As2 thin films with self-assembled c-axis and artificially introduced ab-plane pins. Ba(Fe1-xCox)2As2 can accept a very high density of pins (15-20 vol%) without Tc suppression. The matching field is greater than 12 T, producing a significant enhancement of the critical current density Jc, an almost isotropic Jc (Theta,20T) > 10^5 A/cm2, and global pinning force density Fp of about 50 GN/m^3. This scenario strongly differs from the high temperature cuprates where the addition of pins without Tc suppression is limited to 2-4 vol%, leading to small HIrr enhancements and improved Jc only below 3-5 Tesla.
rate research
Read More
The angular-dependent critical current density, Jc(theta), and the upper critical field, Hc2(theta), of epitaxial Ba(Fe1-xCox)2As2 thin films have been investigated. No Jc(theta) peaks for H || c were observed regardless of temperatures and magnetic fields. In contrast, Jc(theta) showed a broad maximum at theta=90 degree, which arises from intrinsic pinning. All data except at theta=90 degree can be scaled by the Blatter plot. Hc2(theta) near Tc follows the anisotropic Ginzburg-Landau expression. The mass anisotropy increased from 1.5 to 2 with increasing temperature, which is an evidence for multi-band superconductivity.
Ba(Fe1-xCox)2As2 is the most tunable of the Fe-based superconductors (FBS) in terms of acceptance of high densities of self-assembled and artificially introduced pinning centres which are effective in significantly increasing the critical current density, Jc. Moreover, FBS are very sensitive to strain, which induces an important enhancement in critical temperature, Tc, of the material. In this paper we demonstrate that strain induced by the substrate can further improve Jc of both single and multilayer films by more than that expected simply due to the increase in Tc. The multilayer deposition of Ba(Fe1-xCox)2As2 on CaF2 increases the pinning force density Fp by more than 60% compared to a single layer film, reaching a maximum of 84 GN/m^3 at 22.5T and 4.2 K, the highest value ever reported in any 122 phase.
We report muon spin rotation ($mu$SR) measurements of single crystal Ba(Fe$_{1-x}$Co$_x$)$_2$As$_2$ and Sr(Fe$_{1-x}$Co$_x$)$_2$As$_2$. From measurements of the magnetic field penetration depth $lambda$ we find that for optimally- and over-doped samples, $1/lambda(Tto 0)^2$ varies monotonically with the superconducting transition temperature T$_{rm C}$. Within the superconducting state we observe a positive shift in the muon precession signal, likely indicating that the applied field induces an internal magnetic field. The size of the induced field decreases with increasing doping but is present for all Co concentrations studied.
We show that despite the low anisotropy, strong vortex pinning and high irreversibility field Hirr close to the upper critical field Hc2 of Ba(Fe1-xCox)2As2, the critical current density Jgb across [001] tilt grain boundaries (GBs) of thin film Ba(Fe1-xCox)2As2 bicrystals is strongly depressed, similar to high-Tc cuprates. Our results suggest that weak-linked GBs are characteristic of both cuprates and pnictides because of competing orders, low carrier density, and unconventional pairing symmetry.
An extensive calorimetric study of the normal- and superconducting-state properties of Ba(Fe1-xCox)2As2 is presented for 0 < x < 0.2. The normal-state Sommerfeld coefficient increases (decreases) with Co doping for x < 0.06 (x > 0.06), which illustrates the strong competition between magnetism and superconductivity to monopolize the Fermi surface in the underdoped region and the filling of the hole bands for overdoped Ba(Fe1-xCox)2As2. All superconducting samples exhibit a residual electronic density of states of unknown origin in the zero-temperature limit, which is minimal at optimal doping but increases to the normal-state value in the strongly under- and over-doped regions. The remaining specific heat in the superconducting state is well described using a two-band model with isotropic s-wave superconducting gaps.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
