We studied nanoprecipitates and defects in p-type filled skutterudite CeFe4Sb12 prepared by non-equilibrium melt-spinning plus spark plasma sintering method using transmission electron microscopy. Nanoprecipitates with mostly spherical shapes and different sizes (from several nm to several tens of nm) have been observed. The most typically observed nanoprecipitates are shown to be Sb-rich. Superlattices with a periodicity of about 3.576 nm were induced by the ordering of excessive Sb atoms along the c direction. These nanoprecipitates usually share coherent interfaces with the surrounding matrix and induce anisotropic and strong strain fields in the surrounding matrix. Nanoprecipitates with compositions close to CeSb2 are much larger in size (~ 30 nm) and have orthorhombic structures. Various defects were typically observed on the interfaces between these nanoprecipitates and the matrix. The strain fields induced by these nanoprecipitates are less distinct, possibly because part of the strains has been released by the formation of defects.
A filled skutterudite, La$_{0.5}$Rh$_4$Sb$_{12}$, with a lattice constant of 9.284(2) {AA} was synthesized using a high-pressure technique. The electrical resistivity showed semiconducting behavior and the energy gap was estimated to be more than 0.08 eV. Magnetic susceptibility measurements indicated temperature-independent diamagnetism, which originates from Larmor diamagnetism. The electrical properties of this compound are more similar to those of the La$_{0.5}$Rh$_4$As$_{12}$ semiconductor with an energy gap of 0.03 eV than to those of the La$_{0.6}$Rh$_4$P$_{12}$ superconductor.
p-type Ce1.05Fe4Sb12.04 filled skutterudites with much improved thermoelectric properties have been synthesized by rapidly converting nearly amorphous ribbons into crystalline pellets under pressure. It is found that this process greatly suppresses grain growth and second phase formation/segregation, and hence results in the samples consisting of nano-sized grains with strongly-coupled grain boundaries, as observed by transmission electron microscopy. The room temperature carrier mobility in these samples is significantly higher (nearly double) than those in the samples of the same starting composition made by the conventional solid-state reaction. Nanostructure reduces the lattice thermal conductivity, while cleaner grain boundaries permit higher electron conduction.
First-principles calculations of substitutional defects and vacancies are performed for zigzag-edged hybrid C/BN nanosheets and nanotubes which recently have been proposed to exhibit half-metallic properties. The formation energies show that defects form preferentially at the interfaces between graphene and BN domains rather than in the middle of these domains, and that substitutional defects dominate over vacancies. Chemical control can be used to favor localization of defects at C- B interfaces (nitrogen-rich environment) or C-N interfaces (nitrogen-poor environment). Although large defect concentrations have been considered here (106 cm-1), half-metallic properties can subsist when defects are localized at the C-B interface and for negatively charged defects localized at the C- N interface, hence the promising magnetic properties theoretically predicted for these zigzag-edged nanointerfaces might not be destroyed by point defects if these are conveniently engineered during synthesis.
Among the over eighteen different forms of water ice, only the common hexagonal phase and a cubic phase are present in nature on Earth. The existence of these two polytypes, almost degenerate in energy, represents one of the most important and unresolved topics in the physics of ice. It is now widely recognised that all the samples of cubic ice obtained so far are instead a stacking-disordered form of ice I (i.e. ice Isd), in which both hexagonal and cubic stacking sequences of hydrogen-bonded water molecules are present. Here we describe a new method to obtain cubic ice Ic in large quantities, and demonstrate its unprecedented structural purity from two independent neutron diffraction experiments performed on two of the leading neutron diffraction instruments in Europe.
We study the local and non-local magnetoresistance of thin Pt strips deposited onto yttrium iron garnet. The local magnetoresistive response, inferred from the voltage drop measured along one given Pt strip upon current-biasing it, shows the characteristic magnetization orientation dependence of the spin Hall magnetoresistance. We simultaneously also record the non-local voltage appearing along a second, electrically isolated, Pt strip, separated from the current carrying one by a gap of a few 100 nm. The corresponding non-local magnetoresistance exhibits the symmetry expected for a magnon spin accumulation-driven process, confirming the results recently put forward by Cornelissen et al. [1]. Our magnetotransport data, taken at a series of different temperatures as a function of magnetic field orientation, rotating the externally applied field in three mutually orthogonal planes, show that the mechanisms behind the spin Hall and the non-local magnetoresistance are qualitatively different. In particular, the non-local magnetoresistance vanishes at liquid Helium temperatures, while the spin Hall magnetoresistance prevails.