Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userGroup-III assisted catalyst-free growth of InGaAs nanowires and the formation of quantum dots
329
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Growth of GaAs and InGaAs nanowires by the group-III assisted Molecular Beam Epitaxy growth method is studied in dependence of growth temperature, with the objective of maximizing the indium incorporation. Nanowire growth was achieved for growth temperatures as low as 550{deg}C. The incorporation of indium was studied by low temperature micro-photoluminescence spectroscopy, Raman spectroscopy and electron energy loss spectroscopy. The results show that the incorporation of indium lowering the growth temperature does not have an effect in increasing the indium concentration in the bulk of the nanowire, which is limited to 3-5%. For growth temperatures below 575{deg}C, indium rich regions form at the surface of the nanowires as a consequence of the radial growth. This results in the formation of quantum dots, which exhibit extremely sharp luminescence.
rate research
Read More
The synthesis of Si3N4 nanowires from the reaction of silicon nanoparticles with N2 in the 1200-1440 C temperature range is reported. The nitridation conditions are such that the reaction with nitrogen is favoured by the presence of silicon oxide in the particles and by the active oxidation of silicon without a catalyst. It is shown that the Si to Si3N4 conversion rate depends on the amount of silicon particles used in the experiments and that, in general, the reaction slows down for greater amounts. This trend is explained by particle stacking, which restricts the exchange of gases between the furnace atmosphere and the atmosphere around the inner particles. In a first stage, local oxygen partial pressure increases around the inner particles and inhibits nitridation locally. If the amount of reactant Si nanoparticles is small enough, this extrinsic effect is avoided and the intrinsic nitridation kinetics can be measured. Experiments show that intrinsic kinetics does not depend on temperature.
Recently, hexagonal boron nitride (h-BN) has been shown to act as an ideal substrate to graphene by greatly improving the material transport properties thanks to its atomically flat surface, low interlayer electronic coupling and almost perfect reticular matching. Chemical vapour deposition (CVD) is presently considered the most scalable approach to grow graphene directly on h-BN. However, for the catalyst-free approach, poor control over the shape and crystallinity of the graphene grains and low growth rates are typically reported. In this work we investigate the crystallinity of differently shaped grains and identify a path towards a real van der Waals epitaxy of graphene on h-BN by adopting a catalyst-free CVD process. We demonstrate the polycrystalline nature of circular-shaped pads and attribute the stemming of different oriented grains to airborne contamination of the h-BN flakes. We show that single-crystal grains with six-fold symmetry can be obtained by adopting high hydrogen partial pressures during growth. Notably, growth rates as high as 100 nm/min are obtained by optimizing growth temperature and pressure. The possibility of synthesizing single-crystal graphene on h-BN with appreciable growth rates by adopting a simple CVD approach is a step towards an increased accessibility of this promising van der Waals heterostructure.
The role of the sublimation of the compound and of the evaporation of the constituents from the gold nanoparticle during the growth of semiconductor nanowires is exemplified with CdTe-ZnTe heterostructures. Operating close to the upper temperature limit strongly reduces the amount of Cd present in the gold nanoparticle and the density of adatoms on the nanowire sidewalls. As a result, the growth rate is small and strongly temperature dependent, but a good control of the growth conditions allows the incorporation of quantum dots in nanowires with sharp interfaces and adjustable shape, and it minimizes the radial growth and the subsequent formation of additional CdTe clusters on the nanowire sidewalls, as confirmed by photoluminescence. Uncapped CdTe segments dissolve into the gold nanoparticle when interrupting the flux, giving rise to a bulb-like (pendant-droplet) shape attributed to the Kirkendall effect.
A virtual substrate for high quality InAs epitaxial layer has been attained via metalorganic vapor-phase epitaxy growth of Sb-assisted InxGa1-xAs metamorphic buffers, following a convex compositional continuous gradient of the In content from x = 53 % to 100 %. The use of trimethylantimony (or its decomposition products) as a surfactant has been found to crucially enable the control over the defect formation during the relaxation process. Moreover, an investigation of the wafer offcut-dependence of the defect formation and surface morphology has enabled the achievement of a reliably uniform growth on crystals with offcut towards the [111]B direction.
The incorporation paths of Be in GaAs nanowires grown by the Ga-assisted method in molecular beam epitaxy has been investigated by electrical measurements of nanowires with different doping profiles. We find that Be atoms incorporate preferentially via the nanowire side facets, while the incorporation path through the Ga droplet is negligible. We also demonstrate that Be can diffuse into the volume of the nanowire giving an alternative incorporation path. This work is an important step towards controlled doping of nanowires and will serve as a help for designing future devices based on nanowires.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
