This letter reports on the growth, structure and luminescent properties of individual multiple quantum well (MQW) AlGaAs nanowires (NWs). The composition modulations (MQWs) are obtained by alternating the elemental flux of Al and Ga during the molecular beam epitaxy growth of the AlGaAs wire on GaAs (111)B substrates. Transmission electron microscopy and energy dispersive X-ray spectroscopy performed on individual NWs are consistent with a configuration composed of conical segments stacked along the NW axis. Micro-photoluminescence measurements and confocal microscopy showed enhanced light emission from the MQW NWs as compared to non-segmented NWs due to carrier confinement and sidewall passivation.
We report an ultrafast optical tuning of the reflectivity of AlGaAs/InAlGaAs multiple quantum well photonic crystal waveguides using a reflection geometry, pump-probe technique.
We study the optical properties of a single core-shell GaAs-AlGaAs nanowire (grown by VLS method) using the technique of micro-photoluminescence and spatially-resolved photoluminescence imaging. We observe large linear polarization anisotropy in emission and excitation of nanowires.
Al(0.37)Ga(0.63)As nanowires (NWs) were grown in a molecular beam epitaxy system on GaAs(111)B substrates. Micro-photoluminescence measurements and energy dispersive X-ray spectroscopy indicated a core-shell structure and Al composition gradient along the NW axis, producing a potential minimum for carrier confinement. The core-shell structure formed during the growth as a consequence of the different Al and Ga adatom diffusion lengths.
We present in this work a simple Quantum Well (QW) structure consisting of GaAs wells with AlGaAs barriers as a probe for measuring the performance of arsine purifiers within a MetalOrganic Vapour Phase Epitaxy system. Comparisons between two different commercially available purifiers are based on the analysis of low temperature photoluminescence emission spectra from thick QWs, grown on GaAs substrates misoriented slightly from (100). Neutral excitons emitted from these structures show extremely narrow linewidths, comparable to those which can be obtained by Molecular Beam Epitaxy in an ultra-high vacuum environment, suggesting that purifications well below the 1ppb level are needed to achieve high quality quantum well growth.
The quantum well solar cell (QWSC) has been proposed as a route to higher efficiency than that attainable by homojunction devices. Previous studies have established that carriers escape the quantum wells with high efficiency in forward bias and contribute to the photocurrent. Progress in resolving the efficiency limits of these cells has been dogged by the lack of a theoretical model reproducing both the enhanced carrier gen- eration and enhanced recombination due to the quantum wells. Here we present a model which calculates the incremental generation and recombination due to the QWs and is verified by modelling the experimental light and dark current-voltage characteristics of a range of III-V quantum well structures. We find that predicted dark currents are significantly greater than experiment if we use lifetimes derived from homostructure devices. Successful simulation of light and dark currents can be obtained only by introducing a parameter which represents a reduction in the quasi-Fermi level separation.