We performed a two-way remote optical phase comparison on optical fiber. Two optical frequency signals were launched in opposite directions in an optical fiber and their phases were simultaneously measured at the other end. In this technique, the fiber noise was passively cancelled, and we compared two optical frequencies at the ultimate 1E-21 stability level. The experiment was performed on a 47 km fiber that is part of the metropolitan network for Internet traffic. The technique relies on the synchronous measurement of the optical phases at the two ends of the link, that is made possible by the use of digital electronics. This scheme offers several advantages with respect to active noise cancellation, and can be upgraded to perform more complex tasks.
We describe a fiber optical gyroscope based on the Sagnac effect realized on a multiplexed telecom fiber network. Our loop encloses an area of 20 km^2 and coexists with Internet data traffic. This Sagnac interferometer achieves a sensitivity of about 1e-8 (rad/s)/sqrt(Hz), thus approaching ring laser gyroscopes without using narrow-linewidth laser nor sophisticated optics. The proposed gyroscope is sensitive enough for seismic applications, opening new possibilities for this kind of optical fiber sensors
We describe the application of Raman Optical-fiber Amplification (ROA) for the phase coherent transfer of optical frequencies in an optical fiber link. ROA uses the transmission fiber itself as a gain medium for bi-directional coherent amplification. In a test setup we evaluated the ROA in terms of on-off gain, signal-to-noise ratio, and phase noise added to the carrier. We transferred a laser frequency in a 200 km optical fiber link with an additional 16 dB fixed attenuator (equivalent to 275 km of fiber on a single span), and evaluated both co-propagating and counter-propagating amplification pump schemes, demonstrating nonlinear effects limiting the co-propagating pump configuration. The frequency at the remote end has a fractional frequency instability of 3e-19 over 1000 s with the optical fiber link noise compensation.
We stabilized the frequency of a compact planar-waveguide external cavity laser (ECL) on a Fabry-Perot cavity (FPC) through a Pound-Drever-Hall scheme. The residual frequency stability of the ECL is 1E-14, comparable to the stability achievable with a fiber laser (FL) locked to a FPC through the same scheme. We set up an optical link of 100 km, based on fiber spools, that reaches 1E-19 relative stability, and we show that its performances using the ECL or FL are comparable. Thus ECLs could serve as an excellent replacement for FLs in optical links where cost-effectiveness and robustness are important considerations.
