ترغب بنشر مسار تعليمي؟ اضغط هنا

Photoemission Investigation of Oxygen Intercalated Epitaxial Graphene on Ru(0001)

112   0   0.0 ( 0 )
 نشر من قبل S{\\o}ren Ulstrup
 تاريخ النشر 2018
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

We study the formation of epitaxial graphene on Ru(0001) using fast x-ray photoelectron spectroscopy during the growth process. The assignment of different C 1s and Ru 3d core level components and their evolution during the growth process gives a detailed insight into the graphene formation and the strongly varying graphene-Ru interaction strength within the large moire unit cell. Subsequent intercalation of oxygen can be achieved at elevated temperature and the core level spectra show a conversion of the strongly corrugated to quasi free-standing graphene, characterised by a single narrow C 1s component. This conversion and the accompanying flattening of the graphene layer is also confirmed by x-ray photoelectron diffraction. The effect of oxygen intercalation on the electronic structure is studied using angle-resolved photoemission of the valence band states. For graphene/Ru(0001), the strong graphene-substrate hybridisation disrupts the {pi}-band dispersion but oxygen intercalation fully restores the {pi}-band with a strong p-doping that shifts the Dirac point 785 meV above the Fermi level. The doping of the system is highly tunable, as the additional exposure to rubidium can convert the carrier filling to n-type with the Dirac point 970 meV below the Fermi level.



قيم البحث

اقرأ أيضاً

Large-area bilayer graphene (BG) is grown epitaxially on Ru(0001) surface and characterized by low temperature scanning tunneling microscopy. The lattice of the bottom layer of BG is stretched by 1.2%, while strain is absent from the top layer. The l attice mismatch between the two layers leads to the formation of a moire pattern with a periodicity of ~21.5 nm and a mixture of AA- and AB-stacking. The root3 x root3 superstructure around atomic defects is attributed to the inter-valley scattering of the delocalized pi-electrons, demonstrating that the as-grown BG behaves like intrinsic free-standing graphene.
The effect of oxygen adsorption on the local structure and electronic properties of monolayer graphene grown on SiC(0001) has been studied by means of Low Energy Electron Microscopy (LEEM), microprobe Low Energy Electron Diffraction (muLEED) and micr oprobe Angle Resolved Photoemission (muARPES). We show that the buffer layer of epitaxial graphene on SiC(0001) is partially decoupled after oxidation. The monitoring of the oxidation process demonstrates that the oxygen saturates the Si dangling bonds, breaks some Si-C bonds at the interface and intercalates the graphene layer. Accurate control over the oxidation parameters enables us to tune the charge density modulation in the layer.
By comparing the growth of Cu thin films on bare and graphene-covered Ru(0001) surfaces, we demonstrate the role of graphene as a surfactant allowing the formation of flat Cu films. Low-energy electron microscopy, X-ray photoemission electron microsc opy and X-ray absorption spectroscopy reveal that depositing Cu at 580 K leads to distinct behaviors on both types of surfaces. On bare Ru, a Stranski-Krastanov growth is observed, with first the formation of an atomically flat and monolayer-thick wetting layer, followed by the nucleation of three-dimensional islands. In sharp contrast, when Cu is deposited on a graphene-covered Ru surface under the very same conditions, Cu intercalates below graphene and grows in a step-flow manner: atomically-high growth fronts of intercalated Cu form at the graphene edges, and extend towards the center of the flakes. Our findings suggest potential routes in metal heteroepitaxy for the control of thin film morphology.
217 - Thomas Brugger 2008
The electronic structure of a single layer graphene on Ru(0001) is compared with that of a single layer hexagonal boron nitride nanomesh on Ru(0001). Both are corrugated sp2 networks and display a pi-band gap at the K point of their 1 x 1 Brillouin z one. Graphene has a distinct Fermi surface which indicates that 0.1 electrons are transferred per 1 x 1 unit cell. Photoemission from adsorbed xenon identifies two distinct Xe 5p1/2 lines, separated by 240 meV, which reveals a corrugated electrostatic potential energy surface. These two Xe species are related to the topography of the system and have different desorption energies.
Realization of a free-standing graphene is always a demanding task. Here we use scanning probe microscopy and spectroscopy to study the crystallographic structure and electronic properties of the uniform free-standing graphene layers obtained by inte rcalation of oxygen monolayer in the strongly bonded graphene/Ru(0001) interface. Spectroscopic data show that such graphene layer is heavily p-doped with the Dirac point located at 552 meV above the Fermi level. Experimental data are understood within DFT and the observed effects are in good agreement with the theoretical data.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا