اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدHot Settling Accretion Flow onto a Spinning Black Hole
83
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We study the structure and properties of hot MHD accretion onto a Kerr black hole. In such a system, the hole is magnetically coupled to the inflowing gas and exerts a torque onto the accretion flow. A hot settling flow can form around the hole and transport the angular momentum outward, to the outer edge of the flow. Unlike other hot flows, such as advection- and convection-dominated flows and inflow-outflow solutions (ADAFs, CDAFs, and ADIOS), the properties of the hot settling flow are determined by the spin of the central black hole, but are insensitive to the mass accretion rate. Therefore, it may be possible to identify rapidly spinning BHs simply from their broad-band spectra. Observationally, the hot settling flow around a Kerr hole is somewhat similar to other hot flows in that they all have hard, power-law spectra and relatively low luminosities. Thus, most black hole candidates in the low/hard and, perhaps, intermediate X-ray state may potentially accrete via the hot settling flow. However, a settling flow will be somewhat more luminous than ADAFs/CDAFs/ADIOS, will exhibit high variability in X-rays, and may have relativistic jets. This suggests that galactic microquasars and active galactic nuclei may be powered by hot settling flows. We identify several galactic X-ray sources as the best candidates.
قيم البحث
اقرأ أيضاً
We study low-density axisymmetric accretion flows onto black holes (BHs) with two-dimensional hydrodynamical simulations, adopting the $alpha$-viscosity prescription. When the gas angular momentum is low enough to form a rotationally supported disk w
ithin the Bondi radius ($R_{rm B}$), we find a global steady accretion solution. The solution consists of a rotational equilibrium distribution at $rsim R_{rm B}$, where the density follows $rho propto (1+R_{rm B}/r)^{3/2}$, surrounding a geometrically thick and optically thin accretion disk at the centrifugal radius, where thermal energy generated by viscosity is transported via strong convection. Physical properties of the inner solution agree with those expected in convection-dominated accretion flows (CDAF; $rho propto r^{-1/2}$). In the inner CDAF solution, the gas inflow rate decreases towards the center due to convection ($dot{M}propto r$), and the net accretion rate (including both inflows and outflows) is strongly suppressed by several orders of magnitude from the Bondi accretion rate $dot{M}_{rm B}$ The net accretion rate depends on the viscous strength, following $dot{M}/dot{M}_{rm B}propto (alpha/0.01)^{0.6}$. This solution holds for low accretion rates of $dot{M}_{rm B}/dot{M}_{rm Edd}< 10^{-3}$ having minimal radiation cooling, where $dot{M}_{rm Edd}$ is the Eddington rate. In a hot plasma at the bottom ($r<10^{-3}~R_{rm B}$), thermal conduction would dominate the convective energy flux. Since suppression of the accretion by convection ceases, the final BH feeding rate is found to be $dot{M}/dot{M}_{rm B} sim 10^{-3}-10^{-2}$. This rate is as low as $dot{M}/dot{M}_{rm Edd} sim 10^{-7}-10^{-6}$ inferred for SgrA$^*$ and the nuclear BHs in M31 and M87, and can explain the low luminosities in these sources, without invoking any feedback mechanism.
We perform a full 3D general relativistic magnetohydrodynamical (GRMHD) simulation of an equal-mass, spinning, binary black hole approaching merger, surrounded by a circumbinary disk and with a mini-disk around each black hole. For this purpose, we e
volve the ideal GRMHD equations on top of an approximated spacetime for the binary that is valid in every position of space, including the black hole horizons, during the inspiral regime. We use relaxed initial data for the circumbinary disk from a previous long-term simulation, where the accretion is dominated by a $m=1$ overdensity called the lump. We compare our new spinning simulation with a previous non-spinning run, studying how spin influences the mini-disk properties. We analyze the accretion from the inner edge of the lump to the black hole, focusing on the angular momentum budget of the fluid around the mini-disks. We find that mini-disks in the spinning case have more mass over a cycle than the non-spinning case. However, in both cases, we find most of the mass received by the black holes is delivered by the direct plunging of material from the lump. We also analyze the morphology and variability of the electromagnetic fluxes and we find they share the same periodicities of the accretion rate. In the spinning case, we find that the outflows are $8$ times stronger than the non-spinning case. Our results will be useful to understand and produce realistic synthetic light curves and spectra, which can be used in future observations.
We present a theoretical model for driving jets by accretion onto Kerr black holes and try to give an answer to the following question: How much energy could be extracted from a rotating black hole and its accretion disk in order to power relativistic jets in Active Galactic Nuclei?
Supermassive black hole binaries are likely to accrete interstellar gas through a circumbinary disk. Shortly before merger, the inner portions of this circumbinary disk are subject to general relativistic effects. To study this regime, we approximate
the spacetime metric of close orbiting black holes by superimposing two boosted Kerr-Schild terms. After demonstrating the quality of this approximation, we carry out very long-term general relativistic magnetohydrodynamic simulations of the circumbinary disk. We consider black holes with spin dimensionless parameters of magnitude 0.9, in one simulation parallel to the orbital angular momentum of the binary, but in another anti-parallel. These are contrasted with spinless simulations. We find that, for a fixed surface mass density in the inner circumbinary disk, aligned spins of this magnitude approximately reduce the mass accretion rate by 14% and counter-aligned spins increase it by 45%, leaving many other disk properties unchanged.
In this paper, we present the classical Bondi accretion theory for the case of non-isothermal accretion processes onto a supermassive black hole (SMBH), including the effects of X-ray heating and the radiation force due to electron scattering and spe
ctral lines. The radiation field is calculated by considering an optically thick, geometrically thin, standard accretion disk as the emitter of UV photons and a spherical central object as a source of X-ray emission. In the present analysis, the UV emission from the accretion disk is assumed to have an angular dependence, while the X-ray/central object radiation is assumed to be isotropic. This allows us to build streamlines in any angular direction we need to. The influence of both types of radiation is evaluated for different flux fractions of the X-ray and UV emissions with and without the effects of spectral line driving. We find that the radiation emitted near the SMBH interacts with the infalling matter and modifies the accretion dynamics. In the presence of line driving, a transition resembles from pure type 1 & 2 to type 5 solutions (see Fig2.1 of Frank etal. 2002), which takes place regardless of whether or not the UV emission dominates over the X-ray emission. We compute the radiative factors at which this transition occurs, and discard type 5 solution from all our models. Estimated values of the accretion radius and accretion rate in terms of the classical Bondi values are also given. The results are useful for the construction of proper initial conditions for time-dependent hydrodynamical simulations of accretion flows onto SMBH at the centre of galaxies.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
