ترغب بنشر مسار تعليمي؟ اضغط هنا

Spatial beam self-cleaning in bi-tapered multimode fibers

116   0   0.0 ( 0 )
 نشر من قبل Aiping Luo
 تاريخ النشر 2021
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

We report the spatial beam self-cleaning in bi-tapered conventional multimode fibers (MMFs) with different tapered lengths. Through the introduction of the bi-tapered structure in MMFs, the input beam with poor beam quality from a high-power fiber laser can be converted to a centered, bell-shaped beam in a short length, due to the strengthened nonlinear modes coupling. It is found that the bi-tapered MMF with longer tapered length at the same waist diameter shows better beam self-cleaning effect and larger spectral broadening. The obtained results offer a new method to improve the beam quality of high-power laser at low cost. Besides, it may be interesting for manufacturing bi-tapered MMF-based devices to obtain the quasi-fundamental mode beam in spatiotemporal mode-locked fiber lasers.



قيم البحث

اقرأ أيضاً

Multimode optical fibres are enjoying a renewed attention, boosted by the urgent need to overcome the current capacity crunch of single-mode fibre systems and by recent advances in multimode complex nonlinear optics [1-13]. In this work, we demonstra te that standard multimode fibres can be used as ultrafast all-optical tool for transverse beam manipulation of high power laser pulses. Our experimental data show that the Kerr effect in a graded-index multimode fibre is the driving mechanism for overcoming speckle distortions, leading to a somewhat counter-intuitive effect resulting in a spatially clean output beam robust against fibre bending. Our observations demonstrate that nonlinear beam reshaping into the fundamental mode of a multimode fibre can be achieved even in the absence of a dissipative process such as stimulated scattering (Raman or Brillouin) [14,15].
We experimentally demonstrate spatial beam self-cleaning in an Yb-doped graded-index multimode fiber taper, both in passive and active configurations. The input laser beam at 1064 nm was injected for propagation from the small to the large core side of the taper, with laser diode pumping in a counterdirectional configuration. The Kerr effect permits to obtain high-beam quality amplification with no accompanying frequency
141 - J. Garnier , A. Fusaro , K. Baudin 2020
Classical nonlinear random waves can exhibit a process of condensation. It originates in the singularity of the Rayleigh-Jeans equilibrium distribution and it is characterized by the macroscopic population of the fundamental mode of the system. Sever al recent experiments revealed a phenomenon of spatial beam cleaning of an optical field that propagates through a graded-index multimode optical fiber (MMF). Our aim in this article is to provide physical insight into the mechanism underlying optical beam self-cleaning through the analysis of wave condensation in the presence of structural disorder inherent to MMFs. We consider experiments of beam cleaning where long pulses are injected in the and populate many modes of a 10-20 m MMF, for which the dominant contribution of disorder originates from polarization random fluctuations (weak disorder). On the basis of the wave turbulence theory, we derive nonequilibrium kinetic equations describing the random waves in a regime where disorder dominates nonlinear effects. The theory reveals that the presence of a conservative weak disorder introduces an effective dissipation in the system, which is shown to inhibit wave condensation in the usual continuous wave turbulence approach. On the other hand, the experiments of beam cleaning are described by a discrete wave turbulence approach, where the effective dissipation induced by disorder modifies the regularization of wave resonances, which leads to an acceleration of condensation that can explain the effect of beam self-cleaning. The simulations are in quantitative agreement with the theory. The analysis also reveals that the effect of beam cleaning is characterized by a repolarization as a natural consequence of the condensation process. In addition, the discrete wave turbulence approach explains why optical beam self-cleaning has not been observed in step-index multimode fibers.
We experimentally demonstrate Kerr beam self-cleaning in the anomalous dispersion regime of graded-index multimode optical fibers. By using 90 ps duration, highly chirped (2 nm bandwidth at -3dB) optical pulses at 1562 nm, we demonstrate a 2 decades reduction, with respect to previous experiments in the normal dispersion regime, of threshold peak power for beam self-cleaning into the fundamental mode of the fiber, accompanied by more than 65% nonlinear increase of intensity correlation into the fundamental mode. Highly efficient self-selection of the LP11 mode is also observed. Self-cleaned beams remain spatio-temporally stable for more than a decade of variation of the peak pulse power.
We report the experimental observation of Kerr beam self-cleaning in a graded-index multimode fiber, leading to output beam profiles different from a bell shape, close to the $LP_{01}$ mode. For specific coupling conditions, nonlinear coupling among the guided modes can reshape the output speckle pattern generated by a pulsed beam into the low order $LP_{11}$ mode. This was observed in a few meters long multimode fiber with 750 ps pulses at 1064 nm in the normal dispersion regime. The power threshold for $LP_{11}$ mode self-cleaning was about three times larger than that required for Kerr nonlinear self- cleaning into the $LP_{01}$ mode.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا