اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدFabrication of Germanium-on-insulator in a Ge wafer with a crystalline Ge top layer and buried GeO2 layer by Oxygen ion implantation
92
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The paper reports fabrication of Germanium-on-Insulator (GeOI) wafer by Oxygen ion implantation of an undoped single crystalline Ge wafer of orientation (100). Oxygen ions of energy 200 keV were implanted. The implanted wafer was subjected to Rapid Thermal Annealing to 650 C. The resulting wafer has a top crystalline Ge layer of 220 nm thickness and Buried Oxide layer (BOX) layer of good quality crystalline Germanium oxide with thickness around 0.62 micron. The crystalline BOX layer has hexagonal crystal structure with lattice constants close to the standard values. Raman Spectroscopy, cross-sectional HRTEM with SAED and EDS established that the top Ge layer was recrystallized during annealing with faceted crystallites. The top layer has a small tensile strain of around +0.4% and has estimated dislocation density of 2.7 x 10^{7}cm^{-2}. The thickness, crystallinity and electrical characteristics of the top layer and the quality of the BOX layer of GeO_{2} are such that it can be utilized for device fabrication.
قيم البحث
اقرأ أيضاً
The integration of ferromagnetic Mn5Ge3 with the Ge matrix is promising for spin injection in a silicon-compatible geometry. In this paper, we report the preparation of magnetic Mn5Ge3 nanocrystals embedded inside the Ge matrix by Mn ions implantatio
n at elevated temperature. By X-ray diffraction and transmission electron microscopy, we observe crystalline Mn5Ge3 with variable size depending on the Mn ion fluence. The electronic structure of Mn in Mn5Ge3 nanocrystals is 3d6 configuration, the same as in bulk Mn5Ge3. A large positive magnetoresistance has been observed at low temperatures. It can be explained by the conductivity inhomogeneity in the magnetic/semiconductor hybrid system.
Germanium is emerging as the substrate of choice for the growth of graphene in CMOS-compatible processes. For future application in next generation devices the accurate control over the properties of high-quality graphene synthesized on Ge surfaces,
such as number of layers and domain size, is of paramount importance. Here we investigate the role of the process gas flows on the CVD growth of graphene on Ge(100). The quality and morphology of the deposited material is assessed by using microRaman spectroscopy, x-ray photoemission spectroscopy, scanning electron and atomic force microscopies. We find that by simply varying the carbon precursor flow different growth regimes - yielding to graphene nanoribbons, graphene monolayer and graphene multilayer - are established. We identify the growth conditions yielding to a layer-by-layer growth regime and report on the achievement of homogeneous monolayer graphene with an average intensity ratio of 2D and G bands in the Raman map larger than 3.
The electronic properties of thin metallic films deviate from the corresponding bulk ones when the film thickness is comparable with the wavelength of the electrons at the Fermi level due to quantum size effects (QSE). QSE are expected to affect the
film morphology and structure leading to the low temperature (LT) ``electronic growth of metals on semiconductors. In particular, layer-by-layer growth of Pb(111) films has been reported for deposition on Ge(001) below 130 K. An extremely flat morphology is preserved throughout deposition from four up to a dozen of monolayers. These flat films are shown to be metastable and to reorganize into large clusters uncovering the first Pb layer, pseudomorphic to the substrate, already at room temperature. Indications of QSE induced structural variations of the growing films have been reported for Pb growth on Ge(001), where the apparent height of the Pb(111) monatomic step was shown to change in an oscillatory fashion by He atom scattering (HAS) during layer-by-layer growth. The extent of the structural QSE has been obtained by a comparison of the HAS data with X-ray diffraction (XRD) and reflectivity experiments. Whereas step height variations as large as 20 % have been measured by HAS reflectivity, the displacement of the atomic planes from their bulk position, as measured by XRD, has been found to mainly affect the topmost Pb layer, but with a lower extent, i.e. the QSE observed by HAS are mainly due to a perpendicular displacement of the topmost layer charge density. The effect of the variable surface relaxation on the surface vibration has been studied by inelastic HAS to measure the acoustic dispersion of the low energy phonons.
Enhancement-mode Si/SiGe electron quantum dots have been pursued extensively by many groups for revEdit{their} potential in quantum computing. Most of the reported dot designs utilize multiple metal-gate layers and use Si/SiGe heterostructures with G
e concentration close to 30%. Here we report the fabrication and low-temperature characterization of quantum dots in Si/Si$_{0.8}$Ge$_{0.2}$ heterostructures using only one metal-gate layer. We find that the threshold voltage of a channel narrower than 1 $mu$m increases as the width decreases. The higher threshold can be attributed to the combination of quantum confinement and disorder. We also find that the lower Ge ratio used here leads to a narrower operational gate bias range. The higher threshold combined with the limited gate bias range constrains the device design of lithographic quantum dots. We incorporate such considerations in our device design and demonstrate a quantum dot that can be tuned from a single dot to a double dot. The device uses only a single metal-gate layer, greatly simplifying device design and fabrication.
We realize Mn $delta$-doping into Si and Si/Ge interfaces using Mn atomic chains on Si(001). Highly sensitive X-ray absorption fine structure techniques reveal that encapsulation at room temperature prevents the formation of silicides / germanides wh
ilst maintaining one dimensional anisotropic structures. This is revealed by studying both the incident X-ray polarization dependence and post-annealing effects. Density functional theory calculations suggest that Mn atoms are located at substitutional sites, and show good agreement with experiment. A comprehensive magnetotransport study reveals magnetic ordering within the Mn $delta$-doped layer, which is present at around 120,K. We demonstrate that doping methods based on the burial of surface nanostructures allows for the realization of systems for which conventional doping methods fail.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
