اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدA new compact, portable 2-LTD-brick x-pinch driver at the Idaho Accelerator Center: design, fabrication, testing and x-ray performance
77
0
0.0
(
0
)
تأليف
Roman V. Shapovalov
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We propose to construct a compact and portable x-pinch driver with x-ray radiation performance, comparable to standard x-pinch drivers. Such a new x-pinch driver was recently designed, fabricated and tested at the Idaho Accelerator Center. The generator is based on two slow LTD bricks combined into one solid unit, and can be described by a simple RLC circuit with four fast 140-nF, 100-kV capacitors that store up to 2.8 kJ. The test data reveals that when charged to 80 kV, the driver supplies 185-kA peak-current into a short Ni-wire load with 220-ns, 10-90%, rise time. The total internal inductance of our driver was measured to be about 60 nH. The revised driver model shows that when fully charged to 100 kV, the driver will supply 180-kA peak-current with 150-ns rise-time into the x-pinch load. The corresponding current rise rate is about 1.2 kA/ns. To prove the driver x-pinch efficiency and to estimate the x-ray radiation performance, we could, for example, image an exploding wires, placed in a separate HV pulser, with our x-pinch x-ray radiation source. The study of exploding wires helps to understand the behavior of a warm dense matter, and our x-pinch driver can be part of the diagnostics needed for this study which is currently under progress at the IAC. Our driver contains no oil inside, is very compact and portable, and can be easily relocated to practically anywhere, which makes it an ideal backlighting diagnostic tool in many areas of plasma physics, biology, and industry where a bright, fast, and small x-pinch radiation source is required.
قيم البحث
اقرأ أيضاً
Almost all well-known x-pinch x-ray radiation machines are large, based on a conventional Marx generator, and lack portability. The literature suggests that a current rate of rise of 1 kA/ns or more is required for good x-pinch radiation performance,
which, for reasonable current rise times, translates to a current requirement of 100 kA or more. Those requirements are difficult to achieve in a limited volume, if one wants to build a compact machine without the use of traditional Marx generators, pulse-forming lines, and transmission lines. In this work we describe a new, compact and portable x-pinch driver based on two slow LTD bricks combined into one solid unit. The short-circuit tests demonstrated the required 1-kA/ns current rate-of-rise and x-pinch shots confirmed good x-pinch radiation performance and revealed the potential for many x-pinch applications.
We present an in-depth experimental-computational study of the parameters necessary to optimize a tunable, quasi-monoenergetic, efficient, low-background Compton backscattering (CBS) x-ray source that is based on the self-aligned combination of a las
er-plasma accelerator (LPA) and a plasma mirror (PM). The main findings are: (1) an LPA driven in the blowout regime by 30 TW, 30 fs laser pulses producesnot only a high-quality, tunable, quasi-monoenergetic electron beam, but also a high-quality, relativistically intense (a0~1) spent drive pulse that remains stable in profile and intensity over the LPA tuning range. (2) A thin plastic film near the gas jet exit retro-reflects the spent drive pulse efficiently into oncoming electrons to produce CBS x-rays without detectable bremsstrahlung background. Meanwhile anomalous far-field divergence of the retro-reflected light demonstrates relativistic denting of the PM. Exploiting these optimized LPA and PM conditions, we demonstrate quasi-monoenergetic (50% FWHM energy spread), tunable (75 to 200 KeV) CBS x-rays, characteristics previously achieved only on more powerful laser systems by CBS of a split-off, counter-propagating pulse. Moreover, laser-to-x-ray photon conversion efficiency ~6e12 exceeds that of any previous LPA-based quasi-monoenergetic Compton source. Particle-in-cell simulations agree well with the measurements.
A lightning surge generator generates a high voltage surge with 1.2 microsec. rise time. The generator fed a spark gap of two pointed electrodes at 0.7 to 1.2 m distances. Gap breakdown occurred between 0.1 and 3 microsec. after the maximum generator
voltage of approximately 850 kV. Various scintillator detectors with different response time recorded bursts of hard radiation in nearly all surges. The bursts were detected over the time span between approximately half of the maximum surge voltage and full gap breakdown. The consistent timing of the bursts with the high-voltage surge excluded background radiation as source for the high intensity pulses. In spite of the symmetry of the gap, negative surges produced more intense radiation than positive. This has been attributed to additional positive discharges from the measurement cabinet which occurred for negative surges. Some hard radiation signals were equivalent to several MeV. Pile-up occurs of lesser energy X-ray quanta, but still with a large fraction of these with an energy of the order of 100 keV. The bursts occurred within the 4 nanosec. time resolution of the fastest detector. The relation between the energy of the X-ray quanta and the signal from the scintillation detector is quite complicated, as shown by the measurements.
We have performed a systematic study of the Bremsstrahlung emission from the electrons in the plasma of a commercial 14.5 GHz Electron-Cyclotron Resonance Ion Source. The electronic spectral temperature and the product of ionic and electronic densiti
es of the plasma are measured by analyzing the Bremsstrahlung spectra recorded for several rare gases (Ar, Kr, Xe) as a function of the injected power. Within our uncertainty, we find an average temperature of ? 48 keV above 100W, with a weak dependency on the injected power and gas composition. Charge state distributions of extracted ion beams have been determined as well, providing a way to disentangle the ionic density from the electronic density. Moreover X-ray emission from highly charged argon ions in the plasma has been observed with a high-resolution mosaic crystal spectrometer, demonstrating the feasibility for high-precision measurements of transition energies of highly charged ions, in particular of the magnetic dipole (M1) transition of He-like of argon ions.
X-ray polarimetry promises to give qualitatively new information about high-energy astrophysical sources, such as binary black hole systems, micro-quasars, active galactic nuclei, neutron stars, and gamma-ray bursts. We designed, built and tested a X
-ray polarimeter, X-Calibur, to be used in the focal plane of the balloon-borne InFOCuS grazing incidence X-ray telescope. X-Calibur combines a low-Z scatterer with a CZT detector assembly to measure the polarization of 20-80keV X-rays making use of the fact that polarized photons scatter preferentially perpendicular to the electric field orientation. X-Calibur achieves a high detection efficiency of ~80%. The X-Calibur detector assembly is completed, tested, and fully calibrated. The response to a polarized X-ray beam was measured successfully at the Cornell High Energy Synchrotron Source. This paper describes the design, calibration and performance of the X-Calibur polarimeter. In principle, a similar space-borne scattering polarimeter could operate over the broader 2-100keV energy band.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
