ترغب بنشر مسار تعليمي؟ اضغط هنا

Cavity-Based 3D Cooling of a Levitated Nanoparticle via Coherent Scattering

127   0   0.0 ( 0 )
 نشر من قبل Dominik Windey
 تاريخ النشر 2018
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

We experimentally realize cavity cooling of all three translational degrees of motion of a levitated nanoparticle in vacuum. The particle is trapped by a cavity-independent optical tweezer and coherently scatters tweezer light into the blue detuned cavity mode. For vacuum pressures around $10^{-5},{rm mbar}$, minimal temperatures along the cavity axis in the mK regime are observed. Simultaneously, the center-of-mass (COM) motion along the other two spatial directions is cooled to minimal temperatures of a few hundred $rm mK$. Measuring temperatures and damping rates as the pressure is varied, we find that the cooling efficiencies depend on the particle position within the intracavity standing wave. This data and the behaviour of the COM temperatures as functions of cavity detuning and tweezer power are consistent with a theoretical analysis of the experiment. Experimental limits and opportunities of our approach are outlined.



قيم البحث

اقرأ أيضاً

We report three-dimensional cooling of a levitated nanoparticle inside an optical cavity. The cooling mechanism is provided by cavity-enhanced coherent scattering off an optical tweezer. The observed 3D dynamics and cooling rates are as theoretically expected from the presence of both linear and quadratic terms in the interaction between the particle motion and the cavity field. By achieving nanometer-level control over the particle location we optimize the position-dependent coupling and demonstrate axial cooling by two orders of magnitude at background pressures as high as $6times10^{-2}$ mbar. We also estimate a significant ($> 40$ dB) suppression of laser phase noise, and hence of residual heating, which is a specific feature of the coherent scattering scheme. The observed performance implies that quantum ground state cavity cooling of levitated nanoparticles can be achieved for background pressures below $10^{-7}$ mbar.
Quantum control of levitated dielectric particles is an emerging subject in quantum optomechanics. A major challenge is to efficiently measure and manipulate the particles motion at the Heisenberg uncertainty limit. Here we present a nanophotonic int erface suited to address this problem. By optically trapping a 150 nm silica particle and placing it in the near field of a photonic crystal cavity, we achieve tunable single-photon optomechanical coupling of up to $g_0/2pi=9$ kHz, three orders of magnitude larger than previously reported for levitated cavity optomechanical systems. Efficient collection and guiding of light through the nanophotonic structure results in a per-photon displacement sensitivity that is increased by two orders of magnitude compared to conventional far-field detection. The demonstrated performance shows a promising route for room temperature quantum optomechanics.
We investigate the influence of laser phase noise heating on resolved sideband cooling in the context of cooling the center-of-mass motion of a levitated nanoparticle in a high-finesse cavity. Although phase noise heating is not a fundamental physica l constraint, the regime where it becomes the main limitation in Levitodynamics has so far been unexplored and hence embodies from this point forward the main obstacle in reaching the motional ground state of levitated mesoscopic objects with resolved sideband cooling. We reach minimal center-of-mass temperatures comparable to $T_{min}=10$mK at a pressure of $p = 3times 10^{-7}$mbar, solely limited by phase noise. Finally we present possible strategies towards motional ground state cooling in the presence of phase noise.
276 - M. Torov{s} , T.S. Monteiro 2019
Ultra-high sensitivity detection of quantum-scale displacements in cavity optomechanics optimises the combined errors from measurement back-action and imprecisions from incoming quantum noises. This sets the well-known Standard Quantum Limit (SQL). N ormal quantum cavity optomechanics allows cooling and detection of a single degree of freedom, along the cavity axis. However, a recent breakthrough that allows quantum ground-state cooling of levitated nanoparticles [Delic et al, arxiv:1911.04406], is uniquely 3D in character, with coupling along the $x$, $y$ and $z$ axes. We investigate current experiments and show that the underlying behaviour is far from the addition of independent 1D components and that ground-state cooling and sensing analysis must consider- to date neglected- 3D hybridisation effects. We characterise the additional 3D spectral contributions and find direct and indirect hybridising pathways can destructively interfere suppressing of 3D effects at certain parameters in order to approach, and possibly surpass, the SQL. We identify a sympathetic cooling mechanism that can enhance cooling of weaker coupled modes, arising from optomechanically induced correlations.
We report on cooling the center-of-mass motion of a nanoparticle due to a purely quadratic coupling between its motion and the optical field of a high finesse cavity. The resulting interaction gives rise to a Van der Pol nonlinear damping, which is a nalogous to conventional parametric feedback where the cavity provides passive feedback without measurement. We show experimentally that like feedback cooling the resulting energy distribution is strongly nonthermal and can be controlled by the nonlinear damping of the cavity. As quadratic coupling has a prominent role in proposed protocols to generate deeply nonclassical states, our work represents a first step for producing such states in a levitated system.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا