اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدA collection of model stellar spectra for spectral types B to early-M
104
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Models of stellar spectra are necessary for interpreting light from individual stars, planets, integrated stellar populations, nebulae, and the interstellar medium. We provide a comprehensive and homogeneous collection of synthetic spectra for a wide range of atmospheric parameters and chemical compositions. We compile atomic and molecular data from the literature. We adopt the largest and most recent set of ATLAS9 model atmospheres, and use the radiative code ASS$epsilon$T.The resulting collection of spectra is made publicly available at medium and high-resolution ($Requivlambda/deltalambda$ = 10,000, 100,000 and 300,000 spectral grids, which include variations in effective temperature between 3500 K and 30,000 K, surface gravity ($0le log g le 5$), and metallicity ($-5 le$[Fe/H]$le +0. 5$), spanning the wavelength interval 120-6500 nm. A second set of denser grids with additional dimensions, [$alpha$/Fe] and micro-turbulence, are also provided (covering 200-2500 nm). We compare models with observations for a few representative cases.
قيم البحث
اقرأ أيضاً
We present infrared spectral indices (1.0-2.3 um) of Galactic late-type giants and red supergiants (RSGs). We used existing and new spectra obtained at resolution power R=2000 with SpeX on the IRTF telescope. While a large CO equivalent width (EW), a
t 2.29 um ([CO, 2.29]>45 AA) is a typical signature of RSGs later than spectral type M0, [CO] of K-type RSGs and giants are similar. In the [CO, 2.29] versus [Mg I, 1.71] diagram, RSGs of all spectral types can be distinguished from red giants, because the Mg I line weakens with increasing temperature and decreasing gravity. We find several lines that vary with luminosity, but not temperature: Si I (1.59 um), Sr (1.033 um), Fe+Cr+Si+CN (1.16 um), Fe+Ti (1.185 um), Fe+Ti (1.196 um), Ti+Ca (1.28 um), and Mn (1.29 um). Good markers of CN enhancement are the Fe+Si+CN line at 1.087 um and CN line at 1.093 um. Using these lines, at the resolution of SpeX, it is possible to separate RSGs and giants. Contaminant O-rich Mira and S-type AGBs are recognized by strong molecular features due to water vapor features, TiO band heads, and/or ZrO absorption. Among the 42 candidate RSGs that we observed, all but one were found to be late-types. 21 have EWs consistent with those of RSGs, 16 with those of O-rich Mira AGBs, and one with an S-type AGB. These infrared results open new, unexplored, potential for searches at low-resolution of RSGs in the highly obscured innermost regions of the Milky Way.
The HST Treasury Program Advanced Spectral Library Project: Cool Stars was designed to collect representative, high quality ultraviolet spectra of eight evolved F-M type cool stars. The Space Telescope Imaging Spectrograph (STIS) echelle spectra of t
hese objects enable investigations of a broad range of topics including stellar and interstellar astrophysics. This paper provides a guide to the spectra of the two evolved M-stars, the M2Iab supergiant Alpha Ori and the M3.4 giant Gamma Cru, with comparisons to the prototypical K1.5 giant Alpha Boo. It includes identifications of the significant atomic and molecular emission and absorption features and discusses the character of the photospheric and chromospheric continua and line spectra. The fluorescent processes responsible for a large portion of the emission line spectrum, the characteristics of the stellar winds, and the available diagnostics for hot and cool plasmas are also summarized. This analysis will facilitate the future study of the spectra, outer atmospheres, and winds, not only of these objects, but for numerous other cool, low-gravity stars for years to come.
The observable spectrum of an unresolved binary star system is a superposition of two single-star spectra. Even without a detectable velocity offset between the two stellar components, the combined spectrum of a binary system is in general different
from that of either component, and fitting it with single-star models may yield inaccurate stellar parameters and abundances. We perform simple experiments with synthetic spectra to investigate the effect of unresolved main-sequence binaries on spectral fitting, modeling spectra similar to those collected by the APOGEE, GALAH, and LAMOST surveys. We find that fitting unresolved binaries with single-star models introduces systematic biases in the derived stellar parameters and abundances that are modest but certainly not negligible, with typical systematic errors of $300,rm K$ in $T_{rm eff}$, 0.1 dex in $log g$, and 0.1 dex in $[rm Fe/H]$ for APOGEE-like spectra of solar-type stars. These biases are smaller for spectra at optical wavelengths than in the near-infrared. We show that biases can be corrected by fitting spectra with a binary model, which adds only two labels to the fit and includes single-star models as a special case. Our model provides a promising new method to constrain the Galactic binary population, including systems with single-epoch spectra and no detectable velocity offset between the two stars.
The X-shooter Spectral Library (XSL) is an empirical stellar library at medium spectral resolution covering the wavelength range from 3000 AA to 24 800 AA. This library aims to provide a benchmark for stellar population studies. In this work, we pres
ent a uniform set of stellar atmospheric parameters, effective temperatures, surface gravities, and iron abundances for 754 spectra of 616 XSL stars. We used the full-spectrum fitting package ULySS with the empirical MILES library as reference to fit the ultraviolet-blue (UVB) and visible (VIS) spectra. We tested the internal consistency and we compared our results with compilations from the literature. The stars cover a range of effective temperature 2900 < Teff < 38 000 K, surface gravity 0 < log g < 5.7, and iron abundance -2.5 < [Fe/H] < +1.0, with a couple of stars extending down to [Fe/H] = -3.9. The precisions of the measurements for the G- and K-type stars are 0.9%, 0.14, and 0.06 in Teff, log g, and [Fe/H], respectively. For the cool giants with log g < 1, the precisions are 2.1%, 0.21, and 0.22, and for the other cool stars these values are 1%, 0.14, and 0.10. For the hotter stars (Teff > 6500 K), these values are 2.6%, 0.20, and 0.10 for the three parameters.
$Aims.$ We present a database of 43,340 atmospheric models ($sim$80,000 models at the conclusion of the project) for stars with stellar masses between 9 and 120 $M_{odot}$, covering the region of the OB main-sequence and Wolf-Rayet (W-R) stars in the
Hertzsprung--Russell (H--R) diagram. $Methods.$ The models were calculated using the ABACUS I supercomputer and the stellar atmosphere code CMFGEN. $Results.$ The parameter space has six dimensions: the effective temperature $T_{eff}$, the luminosity $L$, the metallicity $Z$, and three stellar wind parameters: the exponent $beta$, the terminal velocity $V_{infty}$, and the volume filling factor $F_{cl}$. For each model, we also calculate synthetic spectra in the UV (900-2000 A), optical (3500-7000 A), and near-IR (10000-40000 A) regions. To facilitate comparison with observations, the synthetic spectra can be rotationally broadened using ROTIN3, by covering vsin(i) velocities between 10 and 350 km s$^{-1}$ with steps of 10 km s$^{-1}$. $Conclusions.$ We also present the results of the reanalysis of $epsilon$ Ori using our grid to demonstrate the benefits of databases of precalculated models. Our analysis succeeded in reproducing the best-fit parameter ranges of the original study, although our results favor the higher end of the mass-loss range and a lower level of clumping. Our results indirectly suggest that the resonance lines in the UV range are strongly affected by the velocity-space porosity, as has been suggested by recent theoretical calculations and numerical simulations.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
