اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديد3-Phase Evolution of a Coronal Hole, Part II: The Magnetic Field
463
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We investigate the magnetic characteristics of a persistent coronal hole (CH) extracted from EUV imagery using HMI filtergrams over the timerange February 2012-October 2012. The magnetic field, its distribution as well as the magnetic fine structure in form of flux tubes (FT) are analyzed in different evolutionary states of the CH. We find a strong linear correlation between the magnetic properties (e.g. signed/unsigned magnetic field strength) and area of the CH. As such, the evolutionary pattern in the magnetic field clearly follows the three-phase evolution (growing, maximum and decaying phase) as found from EUV data (Part I). This evolutionary process is most likely driven by strong FTs with a mean magnetic field strength exceeding 50 G. During the maximum phase they entail up to 72% of the total signed magnetic flux of the CH, but only cover up to 3.9% of the total CH area, whereas during the growing and decaying phase, strong FTs entail 54-60% of the signed magnetic flux and cover around 1-2% of the CHs total area. We conclude that small scale-structures of strong unipolar magnetic field are the fundamental building blocks of a CH and govern its evolution.
قيم البحث
اقرأ أيضاً
We investigate the evolution of a well-observed, long-lived, low-latitude coronal hole (CH) over 10 solar rotations in the year 2012. By combining EUV imagery from STEREO-A/B and SDO we are able to track and study the entire evolution of the CH havin
g a continuous 360$deg$ coverage of the Sun. The remote sensing data are investigated together with in-situ solar wind plasma and magnetic field measurements from STEREO-A/B, ACE and WIND. From this we obtain how different evolutionary states of the CH as observed in the solar atmosphere (changes in EUV intensity and area) affect the properties of the associated high-speed stream measured at $1$AU. Most distinctly pronounced for the CH area, three development phases are derived: a) growing, b) maximum, and c) decaying phase. During these phases the CH area a) increases over a duration of around three months from about $1 cdot 10^{10} mathrm{km}^{2}$ to $6 cdot 10^{10} mathrm{km}^{2}$, b) keeps a rather constant area for about one month of $> 9 cdot 10^{10} mathrm{km}^{2}$, and c) finally decreases in the following three months below $1 cdot 10^{10} mathrm{km}^{2}$ until the CH cannot be identified anymore. The three phases manifest themselves also in the EUV intensity and in in-situ measured solar wind proton bulk velocity. Interestingly, the three phases are related to a different range in solar wind speed variations and we find for the growing phase a range of $460-600$~km~s$^{-1}$, for the maximum phase $600-720$~km~s$^{-1}$, and for the decaying phase a more irregular behavior connected to slow and fast solar wind speed of $350-550$~km~s$^{-1}$.
The Type-II solar radio burst recorded on 13 June 2010 by the radio spectrograph of the Hiraiso Solar Observatory was employed to estimate the magnetic-field strength in the solar corona. The burst was characterized by a well pronounced band-splittin
g, which we used to estimate the density jump at the shock and Alfven Mach number using the Rankine-Hugoniot relations. The plasma frequency of the Type-II bursts is converted into height [R] in solar radii using the appropriate density model, then we estimated the shock speed [Vs], coronal Alfven velocity [Va], and the magnetic-field strength at different heights. The relative bandwidth of the band-split is found to be in the range 0.2 -- 0.25, corresponding to the density jump of X = 1.44 -- 1.56, and the Alfven Mach number of MA = 1.35 -- 1.45. The inferred mean shock speed was on the order of V ~ 667 km/s. From the dependencies V(R) and MA(R) we found that Alfven speed slightly decreases at R ~ 1.3 -- 1.5. The magnetic-field strength decreases from a value between 2.7 and 1.7 G at R ~ 1.3 -- 1.5 Rs depending on the coronal-density model employed. We find that our results are in good agreement with the empirical scaling by Dulk and McLean (Solar Phys. 57, 279, 1978) and Gopalswamy et al. (Astrophys. J. 744, 72, 2012). Our result shows that Type-II band splitting method is an important tool for inferring the coronal magnetic field, especially when independent measurements were made from white light observations.
A joint campaign of various space-borne and ground-based observatories, comprising the Japanese Hinode mission (HOP~338, 20,--,30~September 2017), the GREGOR solar telescope, and the textit{Vacuum Tower Telescope} (VTT), investigated numerous targets
such as pores, sunspots, and coronal holes. In this study, we focus on the coronal hole region target. On 24~September 2017, a very extended non-polar coronal hole developed patches of flux emergence, which contributed to the decrease of the overall area of the coronal hole. These flux emergence patches erode the coronal hole and transform the area into a more quiet-Sun-like area, whereby bipolar magnetic structures play an important role. Conversely, flux cancellation leads to the reduction of opposite-polarity magnetic fields and to an increase in the area of the coronal hole. Other global coronal hole characteristics, including the evolution of the associated magnetic flux and the aforementioned area evolution in the EUV, are studied using data of the textit{Helioseismic and Magnetic Imager} (HMI) and textit{Atmospheric Imaging Assembly} (AIA) onboard the textit{Solar Dynamics Observatory} (SDO). The interplanetary medium parameters of the solar wind display parameters compatible with the presence of the coronal hole. Furthermore, a particular transient is found in those parameters.
In recent work, Antiochos and coworkers argued that the boundary between the open and closed field regions on the Sun can be extremely complex with narrow corridors of open flux connecting seemingly disconnected coronal holes from the main polar hole
s, and that these corridors may be the sources of the slow solar wind. We examine, in detail, the topology of such magnetic configurations using an analytical source surface model that allows for analysis of the field with arbitrary resolution. Our analysis reveals three important new results: First, a coronal hole boundary can join stably to the separatrix boundary of a parasitic polarity region. Second, a single parasitic polarity region can produce multiple null points in the corona and, more important, separator lines connecting these points. It is known that such topologies are extremely favorable for magnetic reconnection, because they allow this process to occur over the entire length of the separators rather than being confined to a small region around the nulls. Finally, the coronal holes are not connected by an open-field corridor of finite width, but instead are linked by a singular line that coincides with the separatrix footprint of the parasitic polarity. We investigate how the topological features described above evolve in response to the motion of the parasitic polarity region. The implications of our results for the sources of the slow solar wind and for coronal and heliospheric observations are discussed.
By 2050, we expect that CME models will accurately describe, and ideally predict, observed solar eruptions and the propagation of the CMEs through the corona. We describe some of the present known unknowns in observations and models that would need t
o be addressed in order to reach this goal. We also describe how we might prepare for some of the unknown unknowns that will surely become challenges.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
