ترغب بنشر مسار تعليمي؟ اضغط هنا

Efficient 4.42 {mu}m Raman laser based on hollow-core silica fiber

132   0   0.0 ( 0 )
 نشر من قبل Alexey Gladyshev
 تاريخ النشر 2018
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

In this paper we consider mid-infrared Raman lasers based on gas-filled hollow-core silica fibers and provide theoretical and experimental analysis of factors that limit the efficiency and output power of these lasers. As a result, we realized an efficient ns-pulsed 4.42 {mu}m Raman laser based on an 1H2-filled revolver silica fiber. Quantum efficiency as high as 36 % is achieved, and output average power as high as 250 mW is demonstrated. The possibilities of further improving the laser efficiency are discussed.



قيم البحث

اقرأ أيضاً

In this letter, we present a high pulse energy Raman laser at 1946 nm wavelength directly pumped with a 1533 nm custom-made fiber laser. The Raman laser is based on the stimulated Raman scattering (SRS) in an 8-meter carbon dioxide (CO2) filled neste d anti-resonant hollow-core fiber (ARHCF). The low energy phonon emission combined with the inherent SRS process along the low-loss fiber allows the generation of high pulse energy up to 15.4 {mu}J at atmospheric CO2 pressure. The Raman laser exhibits good long-term stability and low relative intensity noise (RIN) of less than 4%. We also investigate the pressure-dependent overlap of the Raman laser line with the absorption band of CO2 at 2 {mu}m spectral range. Our results constitute a novel and promising technology towards high energy 2 {mu}m lasers.
We report the first mode-locked fiber laser to operate in the femtosecond regime well beyond 3 {mu}m. The laser uses dual-wavelength pumping and non-linear polarisation rotation to produce 3.5 {mu}m wavelength pulses with minimum duration of 580 fs a t a repetition rate of 68 MHz. The pulse energy is 3.2 nJ, corresponding to a peak power of 5.5 kW.
Emission at 4.6 um was observed from an N2O filled hollow core fiber laser. 8-ns pump pulses at 1.517 um excited a vibrational overtone resulting in lasing on an R and P branch fundamental transition from the upper pump state. At optimum gas pressure of 80 Torr a photon conversion efficiency of 9% and a slope efficiency of 3% was observed from a mirrorless laser. The laser threshold occurred at an absorbed pump energy of 150 nJ in a 45-cm long fiber with 85 {mu}m core diameter. The observed dependence of the laser output on gas pressure is shown to be a result of line broadening and relaxation rates.
Optical properties of hollow-core revolver fibers are numerically investigated depending on various parameters: the hollow-core diameter, the capillary wall thickness, the values of the minimum gap between the capillaries, the number of capillaries i n the cladding and the type of glass (silica and chalcogenide). Preliminary, similar calculations are made for simple models of hollow-core fibers. Based on the obtained results, the optimal design of the revolver fiber for Raman laser frequency conversion (1560 nm to 4420 nm in H2) was determined. As a result, efficient ns-pulsed 4420 nm Raman laser based on H2-filled revolver silica fiber is realized. Quantum efficiency as high as 36 % is achieved and output average power as high as 250 mW is demonstrated.
The possibility of performing time-resolved spectroscopic studies in the molecular fingerprinting region or extending the cut-off wavelength of high-harmonic generation has recently boosted the development of efficient mid-infrared ultrafast lasers. In particular, fibre lasers based on active media such as thulium or holmium are a very active area of research since they are robust, compact and can operate at high repetition rates. These systems, however, are still complex, are unable to deliver pulses shorter than 100 fs and are not yet as mature as their near-infrared counterparts. Here we report generation of sub-40 fs pulses at 1.8 microns, with quantum efficiencies of 50% and without need for post-compression, in hydrogen-filled hollow-core photonic crystal fibre pumped by a commercial 300-fs fibre laser at 1030 nm. This is achieved by pressure-tuning the dispersion and avoiding Raman gain suppression by adjusting the chirp of the pump pulses and the proportion of higher order modes launched into the fibre. The system is optimized using a physical model that incorporates the main linear and nonlinear contributions to the optical response. The approach is average power-scalable, permits adjustment of the pulse shape and can potentially allow access to much longer wavelengths.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا