اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدFresnel coefficients and Fabry-Perot formula for spatially dispersive metallic layers
73
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The repulsion between free electrons inside a metal makes its optical response spatially dispersive, so that it is not described by Drudes model but by a hydrodynamic model. We give here fully analytic results for a metallic slab in this framework, thanks to a two-modes cavity formalism leading to a Fabry-Perot formula, and show that a simplification can be made that preserves the accuracy of the results while allowing much simpler analytic expressions. For metallic layers thicker than 2.7 nm modified Fresnel coefficients can actually be used to accurately predict the response of any multilayer with spatially dispersive metals (for reflection, transmission or the guided modes). Finally, this explains why adding a small dielectric layer[Y. Luo et al., Phys. Rev. Lett. 111, 093901 (2013)] allows to reproduce the effects of nonlocality in many cases, and especially for multilayers.
قيم البحث
اقرأ أيضاً
We propose a novel photonic structure composed of metal nanolayer, Bragg mirror and metal nanolayer. The structure supports resonances that are transitional between Fabry-Perot and Tamm modes. When the dielectric contrast of the DBR is removed these
modes are a pair of conventional Fabry-Perot resonances. They spectrally merge into a Tamm mode at high contrast. Such behavior differs from the results for structures supporting Tamm modes reported earlier. The optical properties of the structure in the frequency range of the DBR stop band, including highly beneficial 50% transmittivity through thick structures, are determined by the introduced in the paper hybrid resonances. The results can find a wide range of photonic applications.
We demonstrate the optical coupling of two cavities without light transmission through a substrate. Compared to a conventional coupling component, that is a partially transmissive mirror, an all-reflective coupler avoids light absorption in the subst
rate and therefore associated thermal problems, and even allows the use of opaque materials with possibly favourable mechanical and thermal properties. Recently, the all-reflective coupling of two cavities with a low-efficiency 3-port diffraction grating was theoretically investigated. Such a grating has an additional (a third) port. However, it was shown that the additional port does not necessarily decrease the bandwidth of the coupled cavities. Such an all-reflective scheme for cavity coupling is of interest in the field of gravitational wave detection. In such detectors light that is resonantly enhanced inside the so-called power-recycling cavity is coupled to (kilometre-scale) Fabry-Perot resonators representing the arms of a Michelson interferometer. In order to achieve a high sensitivity over a broad spectrum, the Fabry-Perot resonators need to have a high bandwidth for a given (high) power build-up. We realized such an all-reflective coupling in a table-top experiment. Our findings are in full agreement with the theoretical model incorporating the characteristics of the 3-port grating used, and therefore encourage the application of all-reflective cavity couplers in future gravitational wave detectors.
We measured the far-field emission patterns in three dimensions of flat organic dye microlasers using a solid angle scanner. Polymer-based microcavities of ribbon shape (i.e., Fabry-Perot type) were investigated. Out of plane emission from the caviti
es was observed, with significant differences for the two cases of resonators either fully supported by the substrate or sustained by a pedestal. In both cases, the emission diagrams are accounted for by a model combining diffraction at the cavity edges and reflections from the substrate.
In non-Hermitian scattering problems the behavior of the transmission probability is very different from its Hermitian counterpart; it can exceed unity or even be divergent, since the non-Hermiticity can add or remove the probability to and from the
scattering system. In the present paper, we consider the scattering problem of a PT-symmetric potential and find a counter-intuitive behavior. In the usual PT-symmetric non-Hermitian system, we would typically find stationary semi-Hermitian dynamics in a regime of weak non-Hermiticity but observe instability once the non-Hermiticity goes beyond an exceptional point. Here, in contrast, the behavior of the transmission probability is strongly non-Hermitian in the regime of weak non-Hermiticity with divergent peaks, while it is superficially Hermitian in the regime of strong non-Hermiticity, recovering the conventional Fabry-Perot-type peak structure. We show that the unitarity of the S-matrix is generally broken in both of the regimes, but is recovered in the limit of infinitely strong non-Hermiticity.
In this work we present a new mechanism for designing phase-gradient metasurfaces (PGMs) to control an electromagnetic wavefront with high efficiency. Specifically, we design a transmission-type PGM formed by a periodic subwavelength metallic slit ar
ray filled with identical dielectrics of different heights. It is found that when Fabry-Perot (FP) resonances occur locally inside the dielectric regions, in addition to the common phenomenon of complete transmission, the transmitted phase differences between two adjacent slits are exactly the same, being a non-zero constant. These local FP resonances ensure total phase shift across a supercell that can fully cover the range of 0 to 2Pi, satisfying the design requirements of PGMs. More studies reveal that due to local FP resonances, there is a one-to-one correspondence between the phase difference and the permittivity of the filled dielectric. A similar approach can be extended to the reflection-type case and other wavefront transformation, creating new opportunities for wave manipulation.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
