ترغب بنشر مسار تعليمي؟ اضغط هنا

Estimating stellar wind parameters from low-resolution magnetograms

88   0   0.0 ( 0 )
 نشر من قبل Moira Jardine
 تاريخ النشر 2016
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

Stellar winds govern the angular momentum evolution of solar-like stars throughout their main-sequence lifetime. The efficiency of this process depends on the geometry of the stars magnetic field. There has been a rapid increase recently in the number of stars for which this geometry can be determined through spectropolarimetry. We present a computationally efficient method to determine the 3D geometry of the stellar wind and to estimate the mass loss rate and angular momentum loss rate based on these observations. Using solar magnetograms as examples, we quantify the extent to which the values obtained are affected by the limited spatial resolution of stellar observations. We find that for a typical stellar surface resolution of 20$^{rm o}$-30$^{rm o}$, predicted wind speeds are within 5$%$ of the value at full resolution. Mass loss rates and angular momentum loss rates are within 5-20$%$. In contrast, the predicted X-ray emission measures can be under-estimated by 1-2 orders of magnitude, and their rotational modulations by 10-20$%$.



قيم البحث

اقرأ أيضاً

Low-mass stars are known to have magnetic fields that are believed to be of dynamo origin. Two complementary techniques are principally used to characterise them. Zeeman-Doppler imaging (ZDI) can determine the geometry of the large-scale magnetic fie ld while Zeeman broadening can assess the total unsigned flux including that associated with small-scale structures such as spots. In this work, we study a sample of stars that have been previously mapped with ZDI. We show that the average unsigned magnetic flux follows an activity-rotation relation separating into saturated and unsaturated regimes. We also compare the average photospheric magnetic flux recovered by ZDI, $langle B_Vrangle$, with that recovered by Zeeman broadening studies, $langle B_Irangle$. In line with previous studies, $langle B_Vrangle$ ranges from a few % to $sim$20% of $langle B_Irangle$. We show that a power law relationship between $langle B_Vrangle$ and $langle B_Irangle$ exists and that ZDI recovers a larger fraction of the magnetic flux in more active stars. Using this relation, we improve on previous attempts to estimate filling factors, i.e. the fraction of the stellar surface covered with magnetic field, for stars mapped only with ZDI. Our estimated filling factors follow the well-known activity-rotation relation which is in agreement with filling factors obtained directly from Zeeman broadening studies. We discuss the possible implications of these results for flux tube expansion above the stellar surface and stellar wind models.
Alfven-wave-driven 3D magnetohydrodynamic (MHD) models, which are increasingly used to predict stellar wind properties, contain unconstrained parameters and rely on low-resolution stellar magnetograms. We explore the effects of the input Alfven wave energy flux and the surface magnetogram on the wind properties predicted by the Alfven Wave Solar Model (AWSoM). We lowered the resolution of two solar magnetograms during solar cycle maximum and minimum using spherical harmonic decomposition. The Alfven wave energy was altered based on non-thermal velocities determined from a far ultraviolet (FUV) spectrum of the solar twin 18 Sco. Additionally, low-resolution magnetograms of three solar analogues were obtained using Zeeman Doppler imaging (ZDI). Finally, the simulated wind properties were compared to Advanced Composition Explorer (ACE) observations. AWSoM simulations using well constrained input parameters taken from solar observations can reproduce the observed solar wind mass and angular momentum loss rates. The resolution of the magnetogram has a small impact on the wind properties and only during cycle maximum. However, variation in Alfven wave energy influences the wind properties irrespective of the solar cycle activity level. Furthermore, solar wind simulations carried out using the low-resolution magnetogram of the three stars instead of the solar magnetogram could lead to an order of a magnitude difference in the simulated wind properties. The choice in Alfven energy has a stronger influence on the wind output compared to the magnetogram resolution. The influence could be even stronger for stars whose input boundary conditions are not as well constrained as those of the Sun. Unsurprisingly, replacing the solar magnetogram with a stellar magnetogram could lead to completely inaccurate solar wind properties, and should be avoided in solar and stellar wind simulations.
98 - X. M. Zhang , M. Zhang , J. T. Su 2016
It is a common practice in the solar physics community to test whether or not measured photospheric or chromospheric vector magnetograms are force-free, using the Maxwell stress as a measure. Some previous studies have suggested that magnetic fields of active regions in the solar chromosphere are close to be force-free whereas there is no consistency among previous studies on whether magnetic fields of active regions in the solar photosphere are force-free or not. Here we use three kinds of representative magnetic fields (analytical force-free solutions, modeled solar-like force-free fields and observed non-force-free fields) to discuss on how the measurement issues such as limited field of view, instrument sensitivity and measurement error could affect the estimation of force-freeness based on observed magnetograms. Unlike previous studies that focus on discussing the effect of limited field of view or instrument sensitivity, our calculation shows that just measurement error alone can significantly influence the results of force-freeness estimate, due to the fact that measurement errors in horizontal magnetic fields are usually ten times larger than that of the vertical fields. This property of measurement errors, interacting with the particular form of force-freeness estimate formula, would result in wrong judgments of the force-freeness: a truly force-free field may be mistakenly estimated as being non-force-free and a true non-force-free field may be estimated as being force-free. Our analysis calls for caution when interpreting the force-freeness estimates based on measured magnetograms, and also suggests that the true photospheric magnetic field may be further away from being force-free than they currently appear to be.
In this paper we describe Kea a new spectroscopic fitting method to derive stellar parameters from moderate to low signal/noise, high-resolution spectra. We developed this new tool to analyze the massive data set of the Kepler mission reconnaissance spectra that we have obtained at McDonald Observatory. We use Kea to determine effective temperatures (T_eff), metallicity ([Fe/H]), surface gravity (log g) and projected rotational velocity (v sin i). Kea compares the observations to a large library of synthetic spectra that covers a wide range of different T_eff, [Fe/H] and log g values. We calibrated Kea on observations of well-characterized standard stars (the Kepler field platinum sample) which range in T_eff from 5000 to 6500 K, in [Fe/H] from -0.5 to +0.4 dex and in log g from 3.2 to 4.6 dex. We then compared the Kea results from reconnaissance spectra of 45 KOIs (Kepler Object of Interest) to stellar parameters derived from higher signal/noise spectra obtained with Keck/HIRES. We find typical uncertainties of 100 K in T_eff, 0.12 dex in [Fe/H] and 0.18 dex in log g.
Magnetic activity and rotation are known to be intimately linked for low-mass stars. Understanding rotation evolution over the stellar lifetime is therefore an important goal within stellar astrophysics. In recent years, there has been increased focu s on how the complexity of the stellar magnetic field affects the rate of angular momentum-loss from a star. This is a topic that Zeeman-Doppler imaging (ZDI), a technique that is capable of reconstructing the large-scale magnetic field topology of a star, can uniquely address. Using a potential field source surface model, we estimate the open flux, mass loss-rate and angular momentum-loss rates for a sample of 66 stars that have been mapped with ZDI. We show that the open flux of a star is predominantly determined by the dipolar component of its magnetic field for our choice of source surface radius. We also show that, on the main sequence, the open flux, mass- and angular momentum-loss rates increase with decreasing Rossby number. The exception to this rule is stars less massive than $0.3M_{odot}$. Previous work suggests that low mass M dwarfs may possess either strong, ordered and dipolar fields or weak and complex fields. This range of field strengths results in a large spread of angular momentum-loss rates for these stars and has important consequences for their spin down behaviour. Additionally, our models do not predict a transition in the mass-loss rates at the so called wind dividing line noted from Ly$alpha$ studies.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا