اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدSurface state reconstruction in ion-damaged SmB_6
132
0
0.0
(
0
)
تأليف
N. Wakeham
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We have used ion-irradiation to damage the (001) surfaces of SmB_6 single crystals to varying depths, and have measured the resistivity as a function of temperature for each depth of damage. We observe a reduction in the residual resistivity with increasing depth of damage. Our data are consistent with a model in which the surface state is not destroyed by the ion-irradiation, but instead the damaged layer is poorly conducting and the initial surface state is reconstructed below the damage. This behavior is consistent with a surface state that is topologically protected.
قيم البحث
اقرأ أيضاً
We report on the electronic and thermodynamic properties of the antiferromagnetic metal uranium mononitride with a Neel temperature $T_Napprox 53,$K. The fabrication of microstructures from single crystals enables us to study the low-temperature meta
magnetic transition at approximately $58,$T by high-precision magnetotransport, Hall-effect, and magnetic-torque measurements. We confirm the evolution of the high-field transition from a broad and complex behavior to a sharp first-order-like step, associated with a spin flop at low temperature. In the high-field state, the magnetic contribution to the temperature dependence of the resistivity is suppressed completely. It evolves into an almost quadratic dependence at low temperatures indicative of a metallic character. Our detailed investigation of the Hall effect provides evidence for a prominent Fermi-surface reconstruction as the system is pushed into the high-field state.
Fe$_{1+x}$Te is a two dimensional van der Waals antiferromagnet that becomes superconducting on anion substitution on the Te site. The parent phase of Fe$_{1+x}$Te is sensitive to the amount of interstitial iron situated between the iron-tellurium la
yers displaying collinear magnetic order coexisting with low temperature metallic resistivity for small concentrations of interstitial iron $x$ and helical magnetic order for large values of $x$. While this phase diagram has been established through scattering [see for example E. E. Rodriguez $textit{et al.}$ Phys. Rev. B ${bf{84}}$, 064403 (2011) and S. Rossler $textit{et al.}$ Phys. Rev. B ${bf{84}}$, 174506 (2011)], recent scanning tunnelling microscopy measurements [C. Trainer $textit{et al.}$ Sci. Adv. ${bf{5}}$, eaav3478 (2019)] have observed a different magnetic structure for small interstitial iron concentrations $x$ with a significant canting of the magnetic moments along the crystallographic $c$ axis of $theta$=28 $pm$ 3$^{circ}$. In this paper, we revisit the magnetic structure of Fe$_{1.09}$Te using spherical neutron polarimetry and scanning tunnelling microscopy to search for this canting in the bulk phase and compare surface and bulk magnetism. The results show that the bulk magnetic structure of Fe$_{1.09}$Te is consistent with collinear in-plane order ($theta=0$ with an error of $sim$ 5$^{circ}$). Comparison with scanning tunnelling microscopy on a series of Fe$_{1+x}$Te samples reveals that the surface exhibits a magnetic surface reconstruction with a canting angle of the spins of $theta=29.8^{circ}$. We suggest that this is a consequence of structural relaxation of the surface layer resulting in an out-of-plane magnetocrystalline anisotropy. The magnetism in Fe$_{1+x}$Te displays different properties at the surface when the symmetry constraints of the bulk are removed.
By LDA+U method with spin-orbit coupling (LDA+U+SO) the magnetic state and electronic structure have been investigated for plutonium in delta and alpha phases and for Pu compounds: PuN, PuCoGa5, PuRh2, PuSi2, PuTe, and PuSb. For metallic plutonium in
both phases in agreement with experiment a nonmagnetic ground state was found with Pu ions in f^6 configuration with zero values of spin, orbital, and total moments. This result is determined by a strong spin-orbit coupling in 5f shell that gives in LDA calculation a pronounced splitting of 5f states on f^{5/2} and f^{7/2} subbands. A Fermi level is in a pseudogap between them, so that f^{5/2} subshell is already nearly completely filled with six electrons before Coulomb correlation effects were taken into account. The competition between spin-orbit coupling and exchange (Hund) interaction (favoring magnetic ground state) in 5f shell is so delicately balanced, that a small increase (less than 15%) of exchange interaction parameter value from J_H=0.48eV obtained in constrain LDA calculation would result in a magnetic ground state with nonzero spin and orbital moment values. For Pu compounds investigated in the present work, predominantly f^6 configuration with nonzero magnetic moments was found in PuCoGa5, PuSi2, and PuTe, while PuN, PuRh2, and PuSb have f^5 configuration with sizeable magnetic moment values. Whereas pure jj coupling scheme was found to be valid for metallic plutonium, intermediate coupling scheme is needed to describe 5f shell in Pu compounds. The results of our calculations show that both spin-orbit coupling and exchange interaction terms in the Hamiltonian must be treated in a general matrix form for Pu and its compounds.
We report on the electronic structure of $alpha$-Sn films in the very low thickness regime grown on InSb(111)A. High-resolution low photon energies angle-resolved photoemission (ARPES) allows for the direct observation of the linearly dispersing 2D t
opological surface states (TSSs) that exist between the second valence band and the conduction band. The Dirac point of this TSS was found to be 200meV below the Fermi level in 10-nm-thick $alpha$-Sn films, which enables the observation of the hybridization gap opening at the Dirac point of the TSS for thinner films. The crossover to a quasi-2D electronic structure is accompanied by a full gap opening at the Brillouin zone center, in agreement with our density functional theory calculations. We further identify the thickness regime of $alpha$-Sn films where the hybridization gap in TSS coexists with the topologically non-trivial electronic structure and one can expect the presence of a 1D helical edge states.
The transition metal dichalcogenides 1T-TaS$_2$ and 1T-TaSe$_2$ have been extensively studied for the complicated correlated electronic properties. The origin of different surface electronic states remains controversial. We apply scanning tunneling m
icroscopy and spectroscopy to restudy the surface electronic state of bulk 1T-TaSe$_2$. Both insulating and metallic states are identified in different areas of the same sample. The insulating state is similar to that in 1T-TaS$_2$, concerning both the dI/dV spectrum and the orbital texture. With further investigations in single-step areas, the discrepancy of electronic states is found to be associated with different stacking orders. The insulating state is most possibly a single-layer property, modulated to a metallic state in some particular stacking orders. Both the metallic and large-gap insulating spectra, together with their corresponding stacking orders, are dominant in 1T-TaSe$_2$. The connected metallic areas lead to the metallic transport behavior. We then reconcile the bulk metallic and surface insulating state in 1T-TaSe$_2$. The rich phenomena in 1T-TaSe$_2$ deepen our understanding of the correlated electronic state in bulk 1T-TaSe$_2$ and 1T-TaS$_2$.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
