اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدControl and diagnosis of temperature, density, and uniformity in x-ray heated iron/magnesium samples for opacity measurements
45
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Experimental tests are in progress to evaluate the accuracy of the modeled iron opacity at solar interior conditions, in particular to better constrain the solar abundance problem [S. Basu and H.M. Antia, Physics Reports 457, 217 (2008)]. Here we describe measurements addressing three of the key requirements for reliable opacity experiments: control of sample conditions, independent sample condition diagnostics, and verification of sample condition uniformity. The opacity samples consist of iron/magnesium layers tamped by plastic. By changing the plastic thicknesses, we have controlled the iron plasma conditions to reach i) Te=167+/-3 eV and ne=(7.1+/-1.5)e21 e/cc, ii) Te=170+/-2 eV and ne=(2.0+/-0.2)e22 e/cc, and iii) Te=196+/-6 eV and ne=(3.8+/-0.8)e22 e/cc, which were measured by magnesium tracer K-shell spectroscopy. The opacity sample non-uniformity was directly measured by a separate experiment where Al is mixed into the side of the sample facing the radiation source and Mg into the other side. The iron condition was confirmed to be uniform within their measurement uncertainties by Al and Mg K-shell spectroscopy. The conditions are suitable for testing opacity calculations needed for modeling the solar interior, other stars, and high energy density plasmas.
قيم البحث
اقرأ أيضاً
The aim of this paper is to demonstrate the effect of turbulent background density fluctuations on flare-accelerated electron transport in the solar corona. Using the quasi-linear approximation, we numerically simulated the propagation of a beam of a
ccelerated electrons from the solar corona to the chromosphere, including the self-consistent response of the inhomogeneous background plasma in the form of Langmuir waves. We calculated the X-ray spectrum from these simulations using the bremsstrahlung cross-section and fitted the footpoint spectrum using the collisional thick-target model, a standard approach adopted in observational studies. We find that the interaction of the Langmuir waves with the background electron density gradient shifts the waves to a higher phase velocity where they then resonate with higher velocity electrons. The consequence is that some of the electrons are shifted to higher energies, producing more high-energy X-rays than expected if the density inhomogeneity is not considered. We find that the level of energy gain is strongly dependent on the initial electron beam density at higher energy and the magnitude of the density gradient in the background plasma. The most significant gains are for steep (soft) spectra that initially had few electrons at higher energies. If the X-ray spectrum of the simulated footpoint emission are fitted with the standard thick-target model (as is routinely done with RHESSI observations) some simulation scenarios produce more than an order-of-magnitude overestimate of the number of electrons $>50$keV in the source coronal distribution.
Seismology of stars is strongly developing. To address this question we have formed an international collaboration OPAC to perform specific experimental measurements, compare opacity calculations and improve the opacity calculations in the stellar co
des [1]. We consider the following opacity codes: SCO, CASSANDRA, STA, OPAS, LEDCOP, OP, SCO-RCG. Their comparison has shown large differences for Fe and Ni in equivalent conditions of envelopes of type II supernova precursors, temperatures between 15 and 40 eV and densities of a few mg/cm3 [2, 3, 4]. LEDCOP, OPAS, SCO-RCG structure codes and STA give similar results and differ from OP ones for the lower temperatures and for spectral interval values [3]. In this work we discuss the role of Configuration Interaction (CI) and the influence of the number of used configurations. We present and include in the opacity code comparisons new HULLAC-v9 calculations [5, 6] that include full CI. To illustrate the importance of this effect we compare different CI approximations (modes) available in HULLAC-v9 [7]. These results are compared to previous predictions and to experimental data. Differences with OP results are discussed.
In a molecular cloud dust opacity typically dominates over gas opacity, yet in the vicinities of forming stars dust is depleted, and gas is the sole provider of opacity. In the optically thin circumstellar environments the radiation temperature canno
t be assumed to be equal to the gas temperature, hence the two-temperature Planck means are necessary to calculate the radiative equilibrium. By using the two-temperature mean opacity one does obtain the proper equilibrium gas temperature in a circumstellar environment, which is in a chemical equilibrium. A careful consideration of a radiative transfer problem reveals that the equilibrium temperature solution can be degenerate in an optically thin gaseous environment. We compute mean gas opacities based on the publicly available code DFSYNTHE by Kurucz and Castelli. We performed the calculations assuming local thermodynamic equilibrium and an ideal gas equation of state. The values were derived by direct integration of the high-resolution opacity spectrum. We produced two sets of gas opacity tables: Rosseland means and two-temperature Planck means (the tables available via http://cdsweb.u-strasbg.fr/ as well as via http://www.mpia-hd.mpg.de/homes/malygin). For three metallicities [Me/H] = 0.0,+/-0.3 we covered the parameter range 3.48 <= log T_rad[K] <= 4.48 in radiation temperature, 2.8 <= log T_gas[K]} <= 6.0 in gas temperature, and -10 <= log P[dyn cm^-2] <= 6 in gas pressure. We show that in the optically thin circumstellar environment for a given stellar radiation field and local gas density there are several equilibrium gas temperatures possible. We conclude that, in general, equilibrium gas temperature cannot be determined without treating the temperature evolution.
The dense Galactic environment is a large reservoir of interstellar dust. Therefore, this region represents a perfect laboratory to study the properties of the cosmic dust grains. X-rays are the most direct way to detect the interaction of light with
dust present in these dense environments. The interaction between the radiation and the interstellar matter imprints specific absorption features in the X-ray spectrum. We study them with the aim of defining the chemical composition, the crystallinity and structure of the dust grains which populate the inner regions of the Galaxy. We investigate the magnesium and the silicon K-edges detected in the Chandra/HETG spectra of eight bright X-ray binaries, distributed in the neighbourhood of the Galactic centre. We model the two spectral features using accurate extinction cross sections of silicates, that we have measured at the synchrotron facility Soleil, France. Near the Galactic centre magnesium and silicon show abundances similar to the solar ones and they are highly depleted from the gas phase ($delta_{rm{Mg}}>0.90$ and $delta_{rm{Si}}>0.96$). We find that amorphous olivine with a composition of $rm MgFeSiO_{4}$ is the most representative compound along all lines of sight according to our fits. The contribution of Mg-rich silicates and quartz is low (less than $10%$). On average we observe a percentage of crystalline dust equal to $11%$. For the extragalactic source LMC X-1, we find a preference for forsterite, a magnesium-rich olivine. Along this line of sight we also observe an underabundance of silicon $A_{rm Si}/A_{rm LMC} = 0.5pm0.2$.
Standard measures of opacity, the imaginary part of the atomic scattering factor $f_2$ and the x-ray mass attenuation coefficient $mu/rho$, are evaluated in shock-heated boron, boron carbide and boron nitride plasmas. The Hugoniot equation, relating
the temperature $T$ behind a shock wave to the compression ratio $rho/rho_0$ across the shock front, is used in connection with the plasma equation of state to determine the pressure $p$, effective plasma charge $Z^ast$ and the K-shell occupation in terms of $rho/rho_0$. Solutions of the Hugoniot equation (determined within the framework of the generalized Thomas-Fermi theory) reveal that the K-shell occupation in low-Z ions decreases rapidly from 2 to 0.1 as the temperature increases from 20eV to 500eV; a temperature range in which the shock compression ratio is near 4. The average-atom model (a quantum mechanical version of the generalized Thomas-Fermi theory) is used to determine K-shell and continuum wave functions and the photoionization cross section for x-rays in the energy range $omega=1$eV to 10keV, where the opacity is dominated by the atomic photoionization process. For an uncompressed boron plasma at $T=10$eV, where the K-shell is filled, the average-atom cross section, the atomic scattering factor and the mass attenuation coefficient are all shown to agree closely with previous (cold matter) tabulations. For shock-compressed plasmas, the dependence of the $mu/rho$ on temperature can be approximated by scaling previously tabulated cold-matter values by the relative K-shell occupation, however, there is a relatively small residual dependence arising from the photoionization cross section. Attenuation coefficients $mu$ for a 9 keV x-ray are given as functions of $T$ along the Hugoniot for B, C, B$_4$C and BN plasmas.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
