اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديد1D-1D Coulomb Drag Signature of a Luttinger Liquid
154
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We report Coulomb drag measurements between vertically-integrated quantum wires separated by a barrier only 15 nm wide. The temperature dependence of the drag resistance is measured in the true one-dimensional (1D) regime where both wires have less than one 1D subband occupied. As a function of temperature, an upturn in the drag resistance is observed in three distinct devices at a temperature $T^* sim 1.6$ K. This crossover in Coulomb drag behaviour is consistent with Tomonaga-Luttinger liquid models for the 1D-1D drag between quantum wires.
قيم البحث
اقرأ أيضاً
In this work we derive a new scheme to calculate Tomonaga-Luttinger liquid (TLL) parameters and holon (charge modes) velocities in a quasi-1D material that consists of two-leg ladders coupled through Coulomb interactions. Firstly, we obtain an analyt
ic formula for electron-electron interaction potential along the conducting axis for a generalized charge distribution in a plane perpendicular to it. In the second step we introduce many-body screening that is present in a quasi-1D material. To this end we propose a new approximation for the charge susceptibility. Based on this we are able to find the TLLs parameters and velocities. We then show how to use these to validate the experimental ARPES data measured recently in p-polarization in $NbSe_3$. Although we focus our study on this specific material it is applicable for any quasi-1D system that consists of two-leg ladders as basic units.
Recent years have seen a surge of interest in studies of hydrodynamic transport in electronic systems. We investigate the electron viscosity of metals and find a new component that is closely related to Coulomb drag. Using the linear response theory,
viscosity, a transport coefficient for momentum, can be extracted from the retarded correlation function of the momentum flux, i.e., the stress tensor. There exists a previously overlooked contribution to the shear viscosity from the interacting part of the stress tensor which accounts for the momentum flow induced by interactions. This contribution, which we dub drag viscosity, is caused by the frictional drag force due to long-range interactions. It is therefore linked to Coulomb drag which also originates from the interaction induced drag force. Starting from the Kubo formula and using the Keldysh technique, we compute the drag viscosity of 2D and 3D metals along with the drag resistivity of double-layer 2D electronic systems. Both the drag resistivity and drag viscosity exhibit a crossover from quadratic-in-T behavior at low temperatures to a linear one at higher temperatures. Although the drag viscosity appears relatively small compared with the normal Drude component for the clean metals, it may dominate hydrodynamic transport in some systems, which are discussed in the conclusion.
We study theoretically the transport through a single impurity in a one-channel Luttinger liquid coupled to a dissipative (ohmic) bath . For non-zero dissipation $eta$ the weak link is always a relevant perturbation which suppresses transport strongl
y. At zero temperature the current voltage relation of the link is $Isim exp(-E_0/eV)$ where $E_0simeta/kappa$ and $kappa$ denotes the compressibility. At non-zero temperature $T$ the linear conductance is proportional to $exp(-sqrt{{cal C}E_0/k_BT})$. The decay of Friedel oscillation saturates for distance larger than $L_{eta}sim 1/eta $ from the impurity.
Using a novel structure, consisting of two, independently contacted graphene single layers separated by an ultra-thin dielectric, we experimentally measure the Coulomb drag of massless fermions in graphene. At temperatures higher than 50 K, the Coulo
mb drag follows a temperature and carrier density dependence consistent with the Fermi liquid regime. As the temperature is reduced, the Coulomb drag exhibits giant fluctuations with an increasing amplitude, thanks to the interplay between coherent transport in the graphene layer and interaction between the two layers.
Coulomb drag is a process whereby the repulsive interactions between electrons in spatially separated conductors enable a current flowing in one of the conductors to induce a voltage drop in the other. If the second conductor is part of a closed circ
uit, a net current will flow in that circuit. The drag current is typically much smaller than the drive current owing to the heavy screening of the Coulomb interaction. There are, however, rare situations in which strong electronic correlations exist between the two conductors. For example, bilayer two-dimensional electron systems can support an exciton condensate consisting of electrons in one layer tightly bound to holes in the other. One thus expects perfect drag; a transport current of electrons driven through one layer is accompanied by an equal one of holes in the other. (The electrical currents are therefore opposite in sign.) Here we demonstrate just this effect, taking care to ensure that the electron-hole pairs dominate the transport and that tunneling of charge between the layers is negligible.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
