ترغب بنشر مسار تعليمي؟ اضغط هنا

Rapid microwave phase detection based on a solid state spiontronic device

443   0   0.0 ( 0 )
 نشر من قبل Bimu Yao
 تاريخ النشر 2013
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

A technique for rapidly detecting microwave phase has been developed which uses a spintronic device that can directly rectify microwave fields into a dc voltage signal. Use of a voltage-controlled phase shifter enables the development of a spintronic device that can simultaneously read the magnitude and phase of incident continuous-wave (CW) microwaves when combined with a lock-in amplifier. As an example of many possible practical applications of this device, the resonance phase in a complementary electric inductive-capacitive (CELC) resonator has been characterized using a spintronic sensor based on a magnetic tunnel junction (MTJ). This sensor device is not limited for use only with spintronic devices such as MTJs, but can also be used with semiconductor devices such as microwave detectors, and hence offers a useful alternative to existing microwave imaging and characterization technologies.



قيم البحث

اقرأ أيضاً

We analyze the dynamics of a continuously observed, damped, microwave driven solid state charge qubit. The qubit consists of a single electron in a double well potential, coupled to an oscillating electric field, and which is continuously observed by a nearby point contact electrometer. The microwave field induces transitions between the qubit eigenstates, which have a profound effect on the detector output current. We show that useful information about the qubit dynamics, such as dephasing and relaxation rates, and the Rabi frequency, can be extracted from the DC detector conductance and the detector output noise power spectrum. We also demonstrate that these phenomena can be used for single shot electron emph{spin} readout, for spin based quantum information processing.
Neuro-inspired computing architectures are one of the leading candidates to solve complex, large-scale associative learning problems. The two key building blocks for neuromorphic computing are the synapse and the neuron, which form the distributed co mputing and memory units. Solid state implementations of these units remain an active area of research. Specifically, voltage or current controlled oscillators are considered a minimal representation of neurons for hardware implementations. Such oscillators should demonstrate synchronization and coupling dynamics for demonstrating collective learning behavior, besides the desirable individual characteristics such as scaling, power, and performance. To this end, we propose the use of nanoscale, epitaxial heterostructures of phase change oxides and oxides with metallic conductivity as a fundamental unit of an ultralow power, tunable electrical oscillator capable of operating in the microwave regime. Our simulations show that optimized heterostructure design with low thermal boundary resistance can result in operation frequency of up to 3 GHz and power consumption as low as 15 fJ/cycle with rich coupling dynamics between the oscillators.
We present measurements of the Berry Phase in a single solid-state spin qubit associated with the nitrogen-vacancy center in diamond. Our results demonstrate the remarkable degree of coherent control achievable in the presence of a highly complex sol id-state environment. We manipulate the spin qubit geometrically by careful application of microwave radiation that creates an effective rotating magnetic field, and observe the resulting phase via spin-echo interferometry. We find good agreement with Berrys predictions within experimental errors. We also investigated the role of the environment on the geometric phase, and observed that unlike other solid-state qubit systems, the dephasing was primarily dominated by fast radial fluctuations in the path.
We report a combined experimental and theoretical study of non-conventional lasing from higher multi-exciton states of a few quantum dot-photonic crystal nanocavity. We show that the photon output is fed from saturable quantum emitters rather than a non-saturable background despite being rather insensitive to the spectral position of the mode. Although the exciton transitions of each quantum dot are detuned by up to $160$ cavity linewidths, we observe that strong excitation populates a multitude of closely spaced multi-exciton states, which partly overlap spectrally with the mode. The limited number of emitters is confirmed by a complete saturation of the mode intensity at strong pumping, providing sufficient gain to reach stimulated emission, whilst being accompanied by a distinct lasing threshold. Detailed second-order photon-correlation measurements unambiguously identify the transition to lasing for strong pumping and, most remarkably, reveal super-thermal photon bunching with $g^{(2)}(0)>2$ below lasing threshold. Based on our microscopic theory, a pump-rate dependent $beta$-factor $beta(P)$ is needed to describe the nanolaser and account for the interplay of multi-exciton transitions in the few-emitter gain medium. Moreover, we theoretically predict that the super-thermal bunching is related to dipole-anticorrelated multi-exciton recombination channels via sub- and super-radiant coupling below and above lasing threshold, respectively. Our results provide new insights into the microscopic light-matter-coupling of spatially separated emitters coupled to a common cavity mode and, thus, provides a complete understanding of stimulated emission in nanolasers with discrete emitters.
We introduce a microwave bolometer aimed at high-quantum-efficiency detection of wave packet energy within the framework of circuit quantum electrodynamics, the ultimate goal being single microwave photon detection. We measure the differential therma l conductance between the detector and its heat bath, obtaining values as low as 5 fW/K at 50 mK. This is one tenth of the thermal conductance quantum and corresponds to a theoretical lower bound on noise-equivalent-power of order $10^{-20}$ $W/sqrt{mbox{Hz}}$ at 50 mK. By measuring the differential thermal conductance of the same bolometer design in qualitatively different environments and materials, we determine that electron--photon coupling dominates the thermalization of our nanobolometer.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا