اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدImproved nanopatterning for YBCO nanowires approaching the depairing current
111
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
An improved nanopatterning procedure has been developed to obtain YBCO nanowires with cross sections as small as 50x50 nm^2, protected by an Au capping layer. To probe the effective role of the Au protecting layer, we have measured the current-voltage characteristics and the resistive transition in temperature of the nanowires. Critical current densities up to 10^8 A/cm^2 have been achieved at T=4.2 K, approaching the theoretical depairing current limit. The resistance, measured as a function of temperature close to Tc, has been fitted with a thermal activated phase slip model, including the effect of the gold layer. The extracted values of the superconducting coherence length and of the London penetration depth give current densities consistent with the measured ones. These results cannot be achieved with same nanowires, without the Au capping layer.
قيم البحث
اقرأ أيضاً
We estimate the depairing current of superconducting nanowire single photon detectors (SNSPDs) by studying the dependence of the nanowires kinetic inductance on their bias current. The kinetic inductance is determined by measuring the resonance frequ
ency of resonator style nanowire coplanar waveguides both in transmission and reflection configurations. Bias current dependent shifts in the measured resonant frequency correspond to the change in the kinetic inductance, which can be compared with theoretical predictions. We demonstrate that the fast relaxation model described in the literature accurately matches our experimental data and provides a valuable tool for direct determination of the depairing current. Accurate and direct measurement of the depairing current is critical for nanowire quality analysis, as well as modeling efforts aimed at understanding the detection mechanism in SNSPDs.
We present results on ultra low noise YBa$_2$Cu$_3$O$_{7-delta}$ nano Superconducting QUantum Interference Devices (nanoSQUIDs). To realize such devices, we implemented high quality YBCO nanowires, working as weak links between two electrodes. We obs
erve critical current modulation as a function of an externally applied magnetic field in the full temperature range below the transition temperature $T_C$. The white flux noise below 1 $mu Phi_0/sqrt{mathrm{Hz}}$ at T = 8 K makes our nanoSQUIDs very attractive for the detection of small spin systems.
High temperature superconducting coated conductor (CC) could be practically applied in electric equipment due to its favorable mechanical properties and the critical current performance of YBCO superconducting layer. It is well known that CC could be
easily delaminated because of its poor stress tolerance in thickness direction, i.e. along the c-axis of YBCO. Commonly, a stack including YBCO layer and silver stabilizer could be obtained after the delamination. It would be interesting to investigate the superconducting properties of the delaminated stack, since it could also be considered as a new type of CC with the silver stabilizer as the buffer layer, which is quite different from the oxide buffer layers in the traditional CC and might lead to new applications. In this study, a CC sample was delaminated by liquid nitrogen immersing. A Hall probe scanning system was employed to measure the critical current (IC) distribution of the original sample and the obtained stack. It was found that IC could be partially preserved after the delamination. Dense and crack-free morphologies of the delaminated surfaces were observed by scanning electron microscopy, and the potential application of the obtained stack in superconducting joint technology was discussed.
We analyze the effect of different types of fluctuations in internal electron energy on the rates of dark and photon counts in straight current-carrying superconducting nanowires. Dark counts appear due to thermal fluctuations in statistically indepe
ndent cells with the effective size of the order of the coherence length; each count corresponds to an escape from the equilibrium state through an appropriate saddle point. For photon counts, spectral broadening of the deterministic cut off in the spectra of the detection efficiency can be phenomenologically explained by local thermal fluctuations in the electron energy within cells with the same effective volume as for dark counts.
The quest to create superconductors with higher transition temperatures is as old as superconductivity itself. One strategy, popular after the realization that (conventional) superconductivity is mediated by phonons, is to chemically combine differen
t elements within the crystalline unit cell to maximize the electron-phonon coupling. This led to the discovery of NbTi and Nb3Sn, to name just the most technologically relevant examples. Here, we propose a radically different approach to transform a `pristine material into a better (meta-) superconductor by making use of modern fabrication techniques: designing and engineering the electronic properties of thin films via periodic patterning on the nanoscale. We present a model calculation to explore the key effects of different supercells that could be fabricated using nanofabrication or deliberate lattice mismatch, and demonstrate that specific pattern will enhance the coupling and the transition temperature. We also discuss how numerical methods could predict the correct design parameters to improve superconductivity in materials including Al, NbTi, and MgB2
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
