اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدSynthesis and physical properties of the new potassium iron selenide superconductor K0.80Fe1.76Se2
138
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
In this article we review our studies of the K0.80Fe1.76Se2 superconductor, with an attempt to elucidate the crystal growth details and basic physical properties over a wide range of temperatures and applied magnetic field, including anisotropic magnetic and electrical transport properties, thermodynamic, London penetration depth, magneto-optical imaging and Mossbauer measurements. We find that: (i) Single crystals of similar stoichiometry can be grown both by furnace-cooled and decanted methods; (ii) Single crystalline K0.80Fe1.76Se2 shows moderate anisotropy in both magnetic susceptibility and electrical resistivity and a small modulation of stoichiometry of the crystal, which gives rise to broadened transitions; (iii) The upper critical field, Hc2(T) is ~ 55 T at 2 K for H||c, manifesting a temperature dependent anisotropy that peaks near 3.6 at 27 K and drops to 2.5 by 18 K; (iv) Mossbauer measurements reveal that the iron sublattice in K0.80Fe1.76Se2 clearly exhibits magnetic order, probably of the first order, from well below Tc to its Neel temperature of Tn = 532 +/- 2 K. It is very important to note that, although, at first glance there is an apparent dilemma posed by these data: high Tc superconductivity in a near insulating, large ordered moment material, analysis indicates that the sample may well consist of two phases with the minority superconducting phase (that does not exhibit magnetic order) being finely distributed, but connected with in an antiferromagnetic, poorly conducting, matrix, essentially making a superconducting aerogel.
قيم البحث
اقرأ أيضاً
One of the most important properties of very recently reported FeSe based superconductors is the robustness of their superconductivity under applied magnetic field. The synthesis and control of superconductivity in FeSe based compounds is rather a di
fficult task. Synthesis and physical property characterization for optimized superconductivity of FeSe1/2Te1/2 at 13 K is reported here. The compound crystallized in a tetragonal structure with lattice parameters a = 3.8008(10) and c = 6.0187 (15) A. Magnetization measurements indicated bulk superconductivity with lower critical field (Hc1) of around 180 Oe. By applying Ginzburg Landau (GL) theory, the Hc2(0) value is estimated to be = 1840 kOe for the 90% of resistive transition. A heat capacity measurement revealed bulk superconductivity by a hump at Tc near 13 K, and an expected decrease was observed under an applied magnetic field.
Using the ab initio FLAPW-GGA method we examine the electronic band structure, densities of states, and the Fermi surface topology for a very recently synthesized ThCr2Si2-type potassium intercalated iron selenide superconductor KxFe2Se2. We found th
at the electronic state of the stoichiometric KFe2Se2 is far from that of the isostructural iron pnictide superconductors. Thus the main factor responsible for experimentally observed superconductivity for this material is the deficiency of potassium, i.e. the hole doping effect. On the other hand, based on the results obtained, we conclude that the tuning of the electronic system of the new KxFe2Se2 superconductor in the presence of K vacancies is achieved by joint effect owing to structural relaxations and hole doping, where the structural factor is responsible for the modification of the band topology, whereas the doping level determines their filling.
The recent discovery of high-temperature superconductivity in single-layer iron selenide has generated significant experimental interest for optimizing the superconducting properties of iron-based superconductors through the lattice modification. For
simulating the similar effect by changing the chemical composition due to S doping, we investigate the superconducting properties of high-quality single crystals of FeSe$_{1-x}$S$_{x}$ ($x$=0, 0.04, 0.09, and 0.11) using magnetization, resistivity, the London penetration depth, and low temperature specific heat measurements. We show that the introduction of S to FeSe enhances the superconducting transition temperature $T_{c}$, anisotropy, upper critical field $H_{c2}$, and critical current density $J_{c}$. The upper critical field $H_{c2}(T)$ and its anisotropy are strongly temperature dependent, indicating a multiband superconductivity in this system. Through the measurements and analysis of the London penetration depth $lambda _{ab}(T)$ and specific heat, we show clear evidence for strong coupling two-gap $s$-wave superconductivity. The temperature-dependence of $lambda _{ab}(T)$ calculated from the lower critical field and electronic specific heat can be well described by using a two-band model with $s$-wave-like gaps. We find that a $d$-wave and single-gap BCS theory under the weak-coupling approach can not describe our experiments. The change of specific heat induced by the magnetic field can be understood only in terms of multiband superconductivity.
The parent compound of an unconventional superconductor must contain unusual correlated electronic and magnetic properties of its own. In the high-Tc potassium intercalated FeSe, there has been significant debate regarding what the exact parent compo
und is. Our studies unambiguously show that the Fe-vacancy ordered K2Fe4Se5 is the magnetic, Mott insulating parent compound of the superconducting state. Non-superconducting K2Fe4Se5 becomes a superconductor after high temperature annealing, and the overall picture indicates that superconductivity in K2-xFe4+ySe5 originates from the Fe-vacancy order to disorder transition. Thus, the long pending question whether magnetic and superconducting state are competing or cooperating for cuprate superconductors may also apply to the Fe-chalcogenide superconductors. It is believed that the iron selenides and related compounds will provide essential information to understand the origin of superconductivity in the iron-based superconductors, and possibly to the superconducting cuprates.
Alkali-doped iron selenide is the latest member of high Tc superconductor family, and its peculiar characters have immediately attracted extensive attention. We prepared high-quality potassium-doped iron selenide (KxFe2-ySe2) thin films by molecular
beam epitaxy and unambiguously demonstrated the existence of phase separation, which is currently under debate, in this material using scanning tunneling microscopy and spectroscopy. The stoichiometric superconducting phase KFe2Se2 contains no iron vacancies, while the insulating phase has a surd5timessurd5 vacancy order. The iron vacancies are shown always destructive to superconductivity in KFe2Se2. Our study on the subgap bound states induced by the iron vacancies further reveals a magnetically-related bipartite order in the superconducting phase. These findings not only solve the existing controversies in the atomic and electronic structures in KxFe2-ySe2, but also provide valuable information on understanding the superconductivity and its interplay with magnetism in iron-based superconductors.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
