اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدAb-initio calculations for the beta-tin diamond transition in Silicon: comparing theories with experiments
216
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We investigate the pressure-induced metal-insulator transition from diamond to beta-tin in bulk Silicon, using quantum Monte Carlo (QMC) and density functional theory (DFT) approaches. We show that it is possible to efficiently describe many-body effects, using a variational wave function with an optimized Jastrow factor and a Slater determinant. Variational results are obtained with a small computational cost and are further improved by performing diffusion Monte Carlo calculations and an explicit optimization of molecular orbitals in the determinant. Finite temperature corrections and zero point motion effects are included by calculating phonon dispersions in both phases at the DFT level. Our results indicate that the theoretical QMC (DFT) transition pressure is significantly larger (smaller) than the accepted experimental value. We discuss the limitation of DFT approaches due to the choice of the exchange and correlation functionals and the difficulty to determine consistent pseudopotentials within the QMC framework, a limitation that may significantly affect the accuracy of the technique.
قيم البحث
اقرأ أيضاً
We present a new interpretation of measured Raman frequencies of a high-pressure structure of Silicon which was assigned previously to the beta-tin phase. Our results show that the beta-tin->Imma->sh phase transitions have been already indicated in t
his experiment which was performed before the discovery of the Imma phase. We have calculated phonon-dispersion curves for the beta-tin, Imma, and sh phases of silicon using the plane-wave pseudopotential approach to the density-functional theory and the density-functional perturbation theory within the local density approximation. With the new assignment, the calculated phonon frequencies display an excellent agreement with the experimental data, and can be also used to determine precisely the transition pressure for the Imma->beta-tin phase transition. The sh->Imma transition is accompanied by soft modes.
We have investigated the structural sequence of the high-pressure phases of silicon and germanium. We have focussed on the cd->beta-tin->Imma->sh phase transitions. We have used the plane-wave pseudopotential approach to the density-functional theory
implemented within the Vienna ab-initio simulation package (VASP). We have determined the equilibrium properties of each structure and the values of the critical parameters including a hysteresis effect at the phase transitions. The order of the phase transitions has been obtained alternatively from the pressure dependence of the enthalpy and of the internal structure parameters. The commonly used tangent construction is shown to be very unreliable. Our calculations identify a first-order phase transition from the cd to the beta-tin and from the Imma to the sh phase, and they indicate the possibility of a second-order phase-transition from the beta-tin to the Imma phase. Finally, we have derived the enthalpy barriers between the phases.
Quantum-mechanical ab initio calculations are performed to elucidate the vibrational spectroscopic features of a common irradiation-induced defect in diamond, i.e. the neutral vacancy. Raman spectra are computed analytically through a Coupled-Perturb
ed-Hartree-Fock/Kohn-Sham approach as a function of both different defect spin states and defect concentration. The experimental Raman features of defective diamond located in the 400-1300 cm-1 spectral range, i.e. below the first-order line of pristine diamond at 1332 cm-1 , are well reproduced, thus corroborating the picture according to which, at low damage densities, this spectral region is mostly affected by non-graphitic sp3 defects. No peaks above 1332 cm-1 are found, thus ruling out previous tentative assignments of different spectral features (at 1450 and 1490 cm-1) to the neutral vacancy. The perturbation introduced by the vacancy to the thermal nuclear motion of carbon atoms in the defective lattice is discussed in terms of atomic anisotropic displacement parameters (ADPs), computed from converged lattice dynamics calculations.
We study the general problem of mixing for ab-initio quantum-mechanical problems. Guided by general mathematical principles and the underlying physics, we propose a multisecant form of Broydens second method for solving the self-consistent field equa
tions of Kohn-Sham density functional theory. The algorithm is robust, requires relatively little finetuning and appears to outperform the current state of the art, converging for cases that defeat many other methods. We compare our technique to the conventional methods for problems ranging from simple to nearly pathological.
The electronic and magnetic properties of neutral substitutional transition-metal dopants in dia- mond are calculated within density functional theory using the generalized gradient approximation to the exchange-correlation potential. Ti and Fe are n
onmagnetic, whereas the ground state of V, Cr and Mn are magnetic with a spin entirely localized on the magnetic ion. For Co, Ni, and Cu, the ground state is magnetic with the spin distributed over the transition-metal ion and the nearest-neighbor carbon atoms; furthermore a bound state is found in the gap that originates from the hybridization of the 3d-derived level of the dopant and the 2p-derived dangling bonds of the nearest-neighbor carbons. A p{d hybridization model is developed in order to describe the origin of the magnetic interaction. This model predicts high-spin to low-spin transitions for Ni and Cu under compressive strain.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
