ترغب بنشر مسار تعليمي؟ اضغط هنا

Experimental Demonstration of a Robust and Scalable Flux Qubit

107   0   0.0 ( 0 )
 نشر من قبل Richard Harris
 تاريخ النشر 2009
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

A novel rf-SQUID flux qubit that is robust against fabrication variations in Josephson junction critical currents and device inductance has been implemented. Measurements of the persistent current and of the tunneling energy between the two lowest lying states, both in the coherent and incoherent regime, are presented. These experimental results are shown to be in agreement with predictions of a quantum mechanical Hamiltonian whose parameters were independently calibrated, thus justifying the identification of this device as a flux qubit. In addition, measurements of the flux and critical current noise spectral densities are presented that indicate that these devices with Nb wiring are comparable to the best Al wiring rf-SQUIDs reported in the literature thusfar, with a $1/f$ flux noise spectral density at $1 $Hz of $1.3^{+0.7}_{-0.5} muPhi_0/sqrt{text{Hz}}$. An explicit formula for converting the observed flux noise spectral density into a free induction decay time for a flux qubit biased to its optimal point and operated in the energy eigenbasis is presented.



قيم البحث

اقرأ أيضاً

We present a detailed theoretical analysis for a system of a superconducting flux qubit coupled to a transmission line resonator. The master equation, accounting incoherent processes for a weakly populated resonator, is analytically solved. An electr omagnetic wave transmission coefficient through the system, which provides a tool for probing dressed states of the qubit, is derived. We also consider a general case for the resonator with more than one photon population and compare the results with an experiment on the qubit-resonator system in the intermediate coupling regime, when the coupling energy is comparable with the qubit relaxation rate.
Superconducting devices based on the Josephson effect are effectively used for the implementation of qubits and quantum gates. The manipulation of superconducting qubits is generally performed by using microwave pulses with frequencies from 5 to 15 G Hz, obtaining a typical operating clock from 100MHz to 1GHz. A manipulation based on simple pulses in the absence of microwaves is also possible. In our system a magnetic flux pulse modifies the potential of a double SQUID qubit from a symmetric double well to a single deep well condition. By using this scheme with a Nb/AlOx/Nb system we obtained coherent oscillations with sub-nanosecond period (tunable from 50ps to 200ps), very fast with respect to other manipulating procedures, and with a coherence time up to 10ns, of the order of what obtained with similar devices and technologies but using microwave manipulation. We introduce the ultrafast manipulation presenting experimental results, new issues related to this approach (such as the use of a feedback procedure for cancelling the effect of slow fluctuations), and open perspectives, such as the possible use of RSFQ logic for the qubit control.
We report on two different manipulation procedures of a tunable rf SQUID. First, we operate this system as a flux qubit, where the coherent evolution between the two flux states is induced by a rapid change of the energy potential, turning it from a double well into a single well. The measured coherent Larmor-like oscillation of the retrapping probability in one of the wells has a frequency ranging from 6 to 20 GHz, with a theoretically expected upper limit of 40 GHz. Furthermore, here we also report a manipulation of the same device as a phase qubit. In the phase regime, the manipulation of the energy states is realized by applying a resonant microwave drive. In spite of the conceptual difference between these two manipulation procedures, the measured decay times of Larmor oscillation and microwave-driven Rabi oscillation are rather similar. Due to the higher frequency of the Larmor oscillations, the microwave-free qubit manipulation allows for much faster coherent operations.
We report single-shot readout of a superconducting flux qubit by using a flux-driven Josephson parametric amplifier (JPA). After optimizing the readout power, gain of the JPA and timing of the data acquisition, we observe the Rabi oscillations with a contrast of 74% which is mainly limited by the bandwidth of the JPA and the energy relaxation of the qubit. The observation of quantum jumps between the qubit eigenstates under continuous monitoring indicates the nondestructiveness of the readout scheme.
168 - Hu Zhao , Tiefu Li , Jianshe Liu 2013
A phase-slip flux qubit, exactly dual to a charge qubit, is composed of a superconducting loop interrupted by a phase-slip junction. Here we propose a tunable phase-slip flux qubit by replacing the phase-slip junction with a charge-related supercondu cting quantum interference device (SQUID) consisting of two phase-slip junctions connected in series with a superconducting island. This charge-SQUID acts as an effective phase-slip junction controlled by the applied gate voltage and can be used to tune the energy-level splitting of the qubit. Also, we show that a large inductance inserted in the loop can reduce the inductance energy and consequently suppress the dominating flux noise of the phase-slip flux qubit. This enhanced phase-slip flux qubit is exactly dual to a transmon qubit.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا