اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدEpitaxial ferromagnetic Fe$_{3}$Si/Si(111) structures with high-quality hetero-interfaces
169
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
To develop silicon-based spintronic devices, we have explored high-quality ferromagnetic Fe$_{3}$Si/silicon (Si) structures. Using low-temperature molecular beam epitaxy at 130 $^circ$C, we realize epitaxial growth of ferromagnetic Fe$_{3}$Si layers on Si (111) with keeping an abrupt interface, and the grown Fe$_{3}$Si layer has the ordered $DO_{3}$ phase. Measurements of magnetic and electrical properties for the Fe$_{3}$Si/Si(111) yield a magnetic moment of ~ 3.16 $mu_{B}$/f.u. at room temperature and a rectifying Schottky-diode behavior with the ideality factor of ~ 1.08, respectively.
قيم البحث
اقرأ أيضاً
We report experimental and theoretical evidence for the formation of chiral bobbers - an interfacial topological spin texture - in FeGe films grown by molecular beam epitaxy (MBE). After establishing the presence of skyrmions in FeGe/Si(111) thin fil
m samples through Lorentz transmission electron microscopy and topological Hall effect, we perform magnetization measurements that reveal an inverse relationship between film thickness and the slope of the susceptibility (dc{hi}/dH). We present evidence for the evolution as a function of film thickness, L, from a skyrmion phase for L < LD/2 to a cone phase with chiral bobbers at the interface for L > LD/2, where LD ~ 70 nm is the FeGe pitch length. We show using micromagnetic simulations that chiral bobbers, earlier predicted to be metastable, are in fact the stable ground state in the presence of an additional interfacial Rashba Dzyaloshinskii-Moriya interaction (DMI).
This paper has been withdrawn by the author
The electronic structures of the Heusler type compounds Fe$_{3-x}V$_x$Si in the concentration range between x = 0 and x = 1 have been probed by photoemission spectroscopy (PES). The observed shift of Si 2p core- level and the main valence band struct
res indicate a chemical potential shift to higher energy with increasing x. It is also clarified that the density of state at Fermi edge is owing to the collaboration of V 3d and Fe 3d derived states. Besides the decrease of the spectral intensity near Fermi edge with increasing x suggests the formation of pseudo gap at large x.
Atomically sharp epitaxial growth of Bi2Se3 films is achieved on Si (111) substrate with MBE (Molecular Beam Epitaxy). Two-step growth process is found to be a key to achieve interfacial-layer-free epitaxial Bi2Se3 films on Si substrates. With a sing
le-step high temperature growth, second phase clusters are formed at an early stage. On the other hand, with low temperature growth, the film tends to be disordered even in the absence of a second phase. With a low temperature initial growth followed by a high temperature growth, second-phase-free atomically sharp interface is obtained between Bi2Se3 and Si substrate, as verified by RHEED (Reflection High Energy Electron Diffraction), TEM (Transmission Electron Microscopy) and XRD (X-Ray Diffraction). The lattice constant of Bi2Se3 is observed to relax to its bulk value during the first quintuple layer according to RHEED analysis, implying the absence of strain from the substrate. TEM shows a fully epitaxial structure of Bi2Se3 film down to the first quintuple layer without any second phase or an amorphous layer.
We demonstrate that it is possible to mechanically exfoliate graphene under ultra high vacuum conditions on the atomically well defined surface of single crystalline silicon. The flakes are several hundred nanometers in lateral size and their optical
contrast is very faint in agreement with calculated data. Single layer graphene is investigated by Raman mapping. The G and 2D peaks are shifted and narrowed compared to undoped graphene. With spatially resolved Kelvin probe measurements we show that this is due to p-type doping with hole densities of n_h simeq 6x10^{12} cm^{-2}. The in vacuo preparation technique presented here should open up new possibilities to influence the properties of graphene by introducing adsorbates in a controlled way.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
